參數資料
型號: ST20GP6
英文描述: MAX 7000 CPLD 256 MC 208-RQFP
中文描述: GPS處理器
文件頁數: 10/116頁
文件大小: 1107K
代理商: ST20GP6
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁
ST20-GP1
10/116
Serial communications
The ST20-GP1 has two UARTs (Asynchronous Serial Controllers (ASCs)) for serial
communication. The UARTs provide an asynchronous serial interface and can be programmed to
support a range of baud rates and data formats, for example, data size, stop bits and parity.
There is one OS-Link on the ST20-GP1 which acts as a DMA engine independent of the CPU. The
OS-Link uses an asynchronous bit-serial (byte-stream) protocol, each bit received is sampled five
times, hence the term oversampled link(OS-Link). The OS-Link provides a pair of channels, one
input and one output channel. The link is used for:
bootstrapping during development,
debugging,
communicating with OS-Link peripherals or other ST20 devices.
Interrupt subsystem
The ST20-GP1 interrupt subsystem supports five prioritized interrupts. Three interrupts are
connected to on-chip peripherals (2 for the UARTs, 1 for the programmable IO) and two are
available as external interrupt pins.
All interrupts are at a higher priority than the high priority process queue. Each interrupt level has a
higher priority than the previous and each level supports only one software handler process.
Note that interrupt handlers must not prevent the GPS DSP data traffic from being handled. During
continuous operation this has 1 ms latency and is not a problem, but during initial acquisition it has
a 32
μ
s rate and thus all interrupts must be disabled except if used to stop GPS operation.
Byte-wide parallel port
The byte-wide parallel port is provided to communicate with an external device. It transfers a byte
at a time, operating half duplex in the program-selected direction.
Parallel IO module
Six bits of parallel IO are provided. Each bit is programmable as an output or an input. Edge
detection logic is provided which can generate an interrupt on any change of an input bit.
System services module
The ST20-GP1 system services module includes:
reset, initialization and error port.
phase locked loop (PLL) — accepts 16.368 MHz input and generates all the internal high
frequency clocks needed for the CPU and the OS-Link.
相關PDF資料
PDF描述
ST25C02AB1 IC FLEX 6000 FPGA 16K 144-TQFP
ST25C02AB6 Stratix FPGA 25K FBGA-672
ST25C02AM1 IC ACEX 1K FPGA 100K 208-PQFP
ST25C02AM6 Cyclone II FPGA 20K FBGA-256
ST25C04ML1 IC FLEX 6000 FPGA 24K 144-TQFP
相關代理商/技術參數
參數描述
ST20-GP6 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GPS PROCESSOR
ST20GP6CT33S 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GPS PROCESSOR
ST20GP6CX33S 功能描述:射頻無線雜項 GPS Processor RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
ST20GP6CX33STR 功能描述:射頻無線雜項 GPS Processor RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel
ST20GP6X33S 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GPS PROCESSOR