參數資料
型號: TMP86PM46NG
廠商: Toshiba Corporation
英文描述: Zener Diode; Application: General; Pd (mW): 500; Vz (V): 5.4 to 5.7; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35
中文描述: 8位微控制器
文件頁數: 98/170頁
文件大?。?/td> 1430K
代理商: TMP86PM46NG
Page 88
9. 8-Bit TimerCounter (TC3, TC4)
9.1 Configuration
TMP86PM46NG
Figure 9-2 8-Bit Timer Mode Timing Chart (TC4)
9.3.2
8-Bit Event Counter Mode (TC3, 4)
In the 8-bit event counter mode, the up-counter counts up at the falling edge of the input pulse to the TCj pin.
When a match between the up-counter and the TTREGj value is detected, an INTTCj interrupt is generated and
the up-counter is cleared. After being cleared, the up-counter restarts counting at the falling edge of the input
pulse to the TCj pin. Two machine cycles are required for the low- or high-level pulse input to the TCj pin.
Therefore, a maximum frequency to be supplied is fc/2
4
Hz in the NORMAL1/2 or IDLE1/2 mode, and fs/2
4
Hz in the SLOW1/2 or SLEEP1/2 mode.
Note 1: In the event counter mode, fix TCjCR<TFFj> to 0. If not fixed, the
PDOj, PWMj
and
PPGj
pins may output
pulses.
Note 2: In the event counter mode, do not change the TTREGj setting while the timer is running. Since TTREGj is
not in the shift register configuration in the event counter mode, the new value programmed in TTREGj is in
effect immediately after the programming. Therefore, if TTREGi is changed while the timer is running, an
expected operation may not be obtained.
Note 3: j = 3, 4
Figure 9-3 8-Bit Event Counter Mode Timing Chart (TC4)
9.3.3
8-Bit Programmable Divider Output (PDO) Mode (TC3, 4)
This mode is used to generate a pulse with a 50% duty cycle from the
PDOj
pin.
In the PDO mode, the up-counter counts up using the internal clock. When a match between the up-counter
and the TTREGj value is detected, the logic level output from the
PDOj
pin is switched to the opposite state and
the up-counter is cleared. The INTTCj interrupt request is generated at the time. The logic state opposite to the
timer F/Fj logic level is output from the
PDOj
pin. An arbitrary value can be set to the timer F/Fj by
TCjCR<TFFj>. Upon reset, the timer F/Fj value is initialized to 0.
To use the programmable divider output, set the output latch of the I/O port to 1.
1
2
3
n-1
n 0
1
n-1
n
2
0
1
2
0
n
Internal
Source Clock
Counter
Match detect
Counter clear
Match detect
Counter clear
TC4CR<TC4S>
TTREG4
INTTC4 interrupt request
1
0
2
n-1
n 0
1
2
0
n
Counter
Match detect
Counter
clear
n-1
n
2
0
1
Match detect
Counter
clear
TC4CR<TC4S>
TTREG4
INTTC4 interrupt request
TC4 pin input
相關PDF資料
PDF描述
TMP86PM47AUG_07 Zener Diode; Application: General; Pd (mW): 500; Vz (V): 5.6 to 5.9; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
TMP86PM47AUG CMOS 8-Bit Microcontroller
TMP86PM47U CMOS 8-Bit Microcontroller
TMP86PM49FG Zener Diode; Application: General; Pd (mW): 500; Vz (V): 5.7 to 6.0; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
TMP86PM49NG Zener Diode; Application: General; Pd (mW): 500; Vz (V): 5.8 to 6.1; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
相關代理商/技術參數
參數描述
TMP86PM46NG(OA) 制造商:Toshiba America Electronic Components 功能描述:
TMP86PM47AUG 功能描述:8位微控制器 -MCU 32kB OTP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
TMP86PM47AUG_07 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:8 Bit Microcontroller
TMP86PM47U 制造商:Toshiba America Electronic Components 功能描述:MCU 8BIT TLCS-870 CISC 16KB EPROM 5V 44PQFP - Bulk
TMP86PM49FG 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:8 Bit Microcontroller