參數資料
型號: TMP86PM74AFG
廠商: Toshiba Corporation
英文描述: Zener Diode; Application: General; Pd (mW): 500; Vz (V): 6.3 to 6.6; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35
中文描述: 8位微控制器
文件頁數: 94/190頁
文件大?。?/td> 1557K
代理商: TMP86PM74AFG
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁當前第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁
Page 84
8. 16-Bit TimerCounter 1 (TC1)
8.3 Function
TMP86PM74AFG
8.3.5
Pulse Width Measurement Mode
In the pulse width measurement mode, the up-counter starts counting by the input pulse triggering of the
TC1 pin, and counts up at the edge of the internal clock. Either the rising or falling edge of the internal clock is
selected as the trigger edge in TC1CR<TC1S>. Either the single- or double-edge capture is selected as the trig-
ger edge in TC1CR<MCAP1>.
When TC1CR<MCAP1> is set to “1” (single-edge capture)
Either high- or low-level input pulse width can be measured. To measure the high-level input pulse
width, set the rising edge to TC1CR<TC1S>. To measure the low-level input pulse width, set the
falling edge to TC1CR<TC1S>.
When detecting the edge opposite to the trigger edge used to start counting after the timer starts,
the up-counter captures the up-counter value into TC1DRB and generates an INTTC1 interrupt
request. The up-counter is cleared at this time, and then restarts counting when detecting the trigger
edge used to start counting.
When TC1CR<MCAP1> is set to “0” (double-edge capture)
The cycle starting with either the high- or low-going input pulse can be measured. To measure the
cycle starting with the high-going pulse, set the rising edge to TC1CR<TC1S>. To measure the cycle
starting with the low-going pulse, set the falling edge to TC1CR<TC1S>.
When detecting the edge opposite to the trigger edge used to start counting after the timer starts,
the up-counter captures the up-counter value into TC1DRB and generates an INTTC1 interrupt
request. The up-counter continues counting up, and captures the up-counter value into TC1DRB and
generates an INTTC1 interrupt request when detecting the trigger edge used to start counting. The
up-counter is cleared at this time, and then continues counting.
Note 1: The captured value must be read from TC1DRB until the next trigger edge is detected. If not read, the cap-
tured value becomes a don’t care. It is recommended to use a 16-bit access instruction to read the captured
value from TC1DRB.
Note 2: For the single-edge capture, the counter after capturing the value stops at “1” until detecting the next edge.
Therefore, the second captured value is “1” larger than the captured value immediately after counting
starts.
Note 3: The first captured value after the timer starts may be read incorrectively, therefore, ignore the first captured
value.
相關PDF資料
PDF描述
TMP86PS23UG Zener Diode; Application: General; Pd (mW): 500; Vz (V): 6.4 to 6.7; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
TMP86PS27FG Zener Diode; Application: General; Pd (mW): 500; Vz (V): 6.6 to 6.9; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
TMP86PS43F CMOS 8-Bit MICOROcontroller
TMP86PS44UG Zener Diode; Application: General; Pd (mW): 500; Vz (V): 6.7 to 7.0; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
TMP86PS64FG Zener Diode; Application: General; Pd (mW): 500; Vz (V): 6.9 to 7.2; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V): &#160; ESD (kV) min: -; Package: DO-35
相關代理商/技術參數
參數描述
TMP86PS23UG 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:8 Bit Microcontroller
TMP86PS25 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:CMOS 8 BIT MICROCOMTROLLER
TMP86PS25F 制造商:Toshiba America Electronic Components 功能描述:MCU 8BIT TLCS-870 CISC 60KB EPROM 5V 100PQFP - Bulk
TMP86PS27FG 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:8 Bit Microcontroller
TMP86PS27FG(JZ) 制造商:Toshiba America Electronic Components 功能描述:N/A - Bulk