參數資料
型號： TPS51020DBTR
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： DUAL SWITCHING CONTROLLER, 450 kHz SWITCHING FREQ-MAX, PDSO30
封裝： GREEN, PLASTIC, TSSOP-30
文件頁數： 5/29頁
文件大小： 672K
代理商： TPS51020DBTR
TPS51020
SLUS564C JULY 2003 REVISED OCTOBER 2008
13
www.ti.com
APPLICATION INFORMATION
ENABLE AND SOFT-START
Each SMPS is switched into standby mode separately by grounding the corresponding ENBLx pin. The 5-V
supply is enabled if either the DDR, ENBL1 or ENBL2 pin(s) goes high ( >2.2 V).
Softstart of each SMPS is achieved by slowly ramping the error amplifier reference voltage by following a
buffered version of the SSTRTx pin voltage. Designers can achieve their own start-up sequencing by simply
provide external timing signals since the startup times do not depend on the load current. The softstart time is
programmable by external capacitor connected from SSTRTx pin to the ground. Each SSTRTx pin sources
constant current, typically 2.3
A. The output voltage of the SMPS ramps up from 0 V to its target regulation
voltage as the SSTRTx pin voltage increases from 0 V to 1.2 V. This gives the softstart time formula to be,
C
SSTRT (Farads) +
T
SSTRT (sec)
2.3
10*6
1.2
The soft-start capacitor is discharged upon UVLO, OVP or UVP is detected as well as ENBLx is set low.
OUTPUT DISCHARGE (SOFT-STOP)
When an SMPS is turned off by ENBLx asserted low or the part enters a fault mode, both top and bottom drivers
are turned off. This may leave the output in a high impedance state that allows the voltage to persist for some
time. Output voltage should be discharged prior to the next power up. To achieve this, connect the output to the
VO1_VDDQ or VO2 pins.
These pins turn on a 6-
resistor to ground during an off or fault condition. Both the VO1_VDDQ and VO2 pin
must be discharged to 0.3 V before the TPS51020 restarts. The TPS51020 has the flexibility of adding a resistor
in series with the VOx pin and the output voltage in order to reduce the discharge current and reduce the total
power dissipation within the device. It should be noted that when this resistor is added the discharged voltage
threshold changes according to the following equation:
V
DISCHARGE +
R
EXTERNAL ) RDS(on)
R
DS(on)
0.3
where
D REXTERNAL is the series resistor between VOx and the output
D RDS(on) = 6
相關PDF資料
PDF描述
TPS5110PW 1.5 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO24
TPS51163DRCR SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10
TPS51113DRCR SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10
TPS51200DRCT SPECIALTY ANALOG CIRCUIT, PDSO10
TPS51200DRCTG4 SPECIALTY ANALOG CIRCUIT, PDSO10
相關代理商/技術參數
參數描述
TPS51020DBTRG4 功能描述:DC/DC 開關控制器 Dual DDR selectable Sync buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS51020EVM-001 功能描述:電源管理IC開發工具 TPS51020-001 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS5102DBT 制造商:TI 制造商全稱:Texas Instruments 功能描述:DUAL, HIGH-EFFICIENCY CONTROLLER FOR NOTEBOOK PC POWER
TPS5102IDBR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC
TPS5102IDBT 功能描述:DC/DC 開關控制器 Dual Output Synch Buck Controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*