- 您現在的位置：買賣IC網 > PDF目錄98282 > TPS54010PWPG4 (TEXAS INSTRUMENTS INC) 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 PDF資料下載
參數資料
| 型號： | TPS54010PWPG4 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | GREEN, PLASTIC, HTSSOP-28 |
| 文件頁數： | 5/29頁 |
| 文件大?。?/td> | 984K |
| 代理商： | TPS54010PWPG4 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
www.ti.com
INT +
CO
V
IN(MAX)
2
(17)
C6 +
1
2pR1
INT
(18)
LC +
1
2p
L
OUT
C
OUT
(10)
R3 +
1
p
C6
LC
(19)
C8 +
1
2pR1
LC
(20)
ESR0 +
1
2pR
ESR
C
OUT
(21)
R2 +
R1
0.891
V
OUT *
0.891
(11)
R5 +
1
2pC8
ESR
(22)
Z1 +
1
2pR3C6
(12)
Z2 +
1
2pR1C8
(13)
P1 +
1
2pR5C8
(14)
P2 +
1
2pR3C7
(15)
C7 +
1
7pR3
CO
(23)
INT +
1
2pR1C6
(16)
BIAS AND BOOTSTRAP CAPACITORS
TPS54010
SLVS509B – MAY 2004 – REVISED JUNE 2005
of the switching frequency, and the phase margin at
crossover must be greater than 45 degrees. The
general procedure outlined here produces results
consistent with these requirements without going into
And the value for C6 is given by Equation 18:
great detail about the theory of loop compensation.
First, calculate the output filter LC corner frequency
using Equation 10:
The first zero, fZ1 is located at one-half the output
filter LC corner frequency; so, R3 can be calculated
from:
For the design example, fLC = 19.3 kHz.
The closed-loop crossover frequency should be
chosen to be greater than fLC and less than one-fifth
The second zero, fZ2 is located at the output filter LC
of the switching frequency. Also, the crossover fre-
corner frequency; so, C8 can be calculated from:
quency should not exceed 150 kHz, as the error
amplifier may not provide the desired gain. For this
design, a crossover frequency of 100 kHz was
chosen. This value is chosen for comparatively wide
The first pole, fP1 is located to coincide with output
loop bandwidth while still allowing for adequate phase
filter ESR zero frequency. This frequency is given by:
boost to insure stability.
Next, calculate the R2 resistor value for the output
voltage of 1.5 V using Equation 11:
where RESR is the equivalent series resistance of the
output capacitor.
In this case, the ESR zero frequency is 88.4 kHz, and
For any TPS54010 design, start with an R1 value of
R5 can be calculated from:
10 k
. R2 is 14.7 k.
Now, the values for the compensation components
that set the poles and zeros of the compensation
network can be calculated. Assuming that R1 >> than
The final pole is placed at a frequency above the
R5 and C6 >> C7, the pole and zero locations are
closed-loop crossover frequency high enough to not
given by Equation 12 through Equation 18:
cause the phase to decrease too much at the
crossover frequency while still providing enough at-
tenuation so that there is little or no gain at the
switching frequency. The fP2 pole location for this
circuit is set to 3.5 times the closed-loop crossover
frequency and the last compensation component
value C7 can be derived:
Additionally, there is a pole at the origin, which has
Note that capacitors are only available in a limited
unity gain at a frequency:
range of standard values, so the nearest standard
value has been chosen for each capacitor. The
measured closed-loop response for this design is
shown in Figure 5.
This pole is used to set the overall gain of the
compensated error amplifier and determines the
closed-loop crossover frequency. Because R1 is
given as 1 k
and the crossover frequency is
Every TPS54010 design requires a bootstrap capaci-
selected as 100 kHz, the desired fINT can be calcu-
tor, C3, and a bias capacitor, C4. The bootstrap
lated from Equation 17:
capacitor must be a 0.1 F. The bootstrap capacitor
is located between the PH pins and BOOT. The bias
capacitor is connected between the VBIAS pin and
13
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54040DGQ | 0.5 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS54073PWPRG4 | 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54073PWPR | 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS54073PWP | 25 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS5410QDRQ1 | SWITCHING REGULATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54010PWPR | 功能描述:直流/直流開關調節器 2.2V-4.0V 14A Otp Buck PWM Switch RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54010PWPRG4 | 功能描述:直流/直流開關調節器 2.2V-4.0V 14A Otp Buck PWM Switch RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS5401DGQ | 功能描述:直流/直流開關調節器 3.5V-42Vin,0.5A Step Down SWIFT RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS5401DGQR | 功能描述:直流/直流開關轉換器 3.5V-42Vin,0.5A Step Down SWIFT RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS5401DGQT | 功能描述:直流/直流開關轉換器 3.5V-42Vin,0.5A Step Down SWIFT RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。