- 您現在的位置：買賣IC網 > PDF目錄359439 > VT900 (PerkinElmer Inc.) Photoconductive Cells and Analog Optoisolators (Vactrols) PDF資料下載
參數資料
| 型號： | VT900 |
| 廠商： | PerkinElmer Inc. |
| 英文描述： | Photoconductive Cells and Analog Optoisolators (Vactrols) |
| 中文描述： | 光導細胞和模擬光隔離器（Vactrols） |
| 文件頁數： | 42/76頁 |
| 文件大?。?/td> | 1240K |
| 代理商： | VT900 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
37
Characteristics of Analog Optical Isolators
Voltage Rating
The maximumvoltage rating of the output element (photocell) applies
only when the input is off. Two different kinds of dark current “l(fā)eakage”
characteristics are observed in photocell output elements. Figure 4
shows the soft breakdown found in lower resistivity materials. With no
input, if the applied voltage is suddenly increased fromzero to V
1
, the
current increases along section ‘a(chǎn)’, with the steepness depending on
the rate at which the voltage is increased. If the voltage is now held at
V1, the current decreases along curve ‘b and stabilizes at a much
lower value. If the voltage is again increased, the next section of the
curve is traversed with the current dropping along curve ‘d in time.
This process can be repeated until the reverse current becomes so
great that the cell burns up. The maximumvoltage rating for photocells
with this soft reverse characteristic is based on a safe steady-state
power dissipation in the OFF condition.
Figure 4. Breakdown characteristics of photocells with low resistivity
photoconductive material.
Higher resistivity photoconductive materials do not show the reverse
characteristics of Figure 4 to any significant degree. As voltage is
increased, the dark current increases, but remains very low until
breakdown occurs. The current then increases in an avalanche fashion
resulting in an arc-over which causes the cell to be permanently
damaged (shorted). The dielectric breakdown voltage is approximately
8 - 10 kV per cmof contact spacing for materials with this type of
reverse characteristic. Photocells have 0.16 - 0.5 mmelectrode
spacing so the maximumvoltage ratings typically fall into the 100 - 300
volt range.
The high voltage capability of photocells suggests their use as the
series pass element in a high voltage regulated power supply. Voltages
up to 5 or 10 kV can be regulated but the current should be limted to 1
or 2 mA. The isolated input element greatly simplifies the circuit design
and the single output element avoids the need for voltage and current
sharing components.
Power Rating
Photocells are primarily used for signal control since the maximum
allowable power dissipation is low Typically, the steady-state output
current should be kept below 10 mA on catalog LED AOIs because of
the small size ceramc used in the output cell. However the surface
area is large compared to simlarly rated transistors, so AOIs withstand
significant transient current and power surges.
Power ratings are given in the catalog and are typically a few hundred
mlliwatts, but special AOIs have been made with power dissipation
ratings as high as 2.0 W.
Life and Aging
Life expectancy of an AOI is influenced both by the input and output
devices. Isolators which use an LED have long life since LED lifetimes
are long: 10,000 to 200,000 hours, depending on the application. LEDs
normally show a decrease in light output for a specified bias current as
they age.
The photocell output elements in AOIs show an increase in output
resistance over time as they age. With a continuous input drive current
and with voltage bias applied to the output, the output resistance will
generally increase at a rate of 10 percent per year. The aging rate is
lower with intermttent operation. Figure 5 shows the trend line for
output resistance under typical operating conditions. Other AOIs using
different photoconductive materials show simlar trends.
Figure 5. VTL5C3 Life Test.
相關PDF資料 |
PDF描述 |
|---|---|
| VT905GA | |
| VT905GC | |
| VT90N1 | |
| VT90N2 | |
| VT90N3 | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| VT905GA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT905GB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT905GC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT90A114 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT90A432 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。