- 您現在的位置：買賣IC網 > PDF目錄359439 > VT900 (PerkinElmer Inc.) Photoconductive Cells and Analog Optoisolators (Vactrols) PDF資料下載
參數資料
| 型號： | VT900 |
| 廠商： | PerkinElmer Inc. |
| 英文描述： | Photoconductive Cells and Analog Optoisolators (Vactrols) |
| 中文描述： | 光導細胞和模擬光隔離器（Vactrols） |
| 文件頁數： | 66/76頁 |
| 文件大?。?/td> | 1240K |
| 代理商： | VT900 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁當前第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
61
Application Notes—Analog Optical Isolators
Gating and Muting
Background noise becomes very objectionable when a signal level in a
programis low Noise is any unwanted sound and may be due to tape
hiss or amplifier hum These noises can be elimnated by selective use
of gating and muting, that is, turning the amplifier on when the signal
level is high and off when it is low This technique can also remove or
reduce unwanted echo, print through, presence or any other distracting
signal during portions of a programwhich are normally silent. The
gating circuit must be completely transparent to the listener, having a
smooth, rapid operation with no signal distortion.
A practical gating circuit having these features is shown in Figure3.
The circuit has five basic sections: the threshold adjustment, a high AC
gain stage, full-wave rectifier, LED driver and an electrically controlled
voltage divider. When the signal is below the threshold level, the
voltage divider consisting of the AOI and R
10
has maximum
attenuation. When the signal exceeds the threshold, the voltage divider
allows the signal to pass through.
The circuit operation is as follows. The THRESHOLD potentiometer
applies a portion of the signal to the high gain AC amplifier consisting
of op-amp A
1
, resistors R
2
and R
3
and capacitor C
1
. The amplified
signal is full-wave rectified by diodes D
1
and D
2
together with op-amp
A
2
which inverts the negative half of the signal. The rectifier charges
C
2
used for RELEASE TIME control and drives the base of transistor
Q
1
, the LED driver. The threshold voltage is a sumof the forward drop
of the rectifying diodes, the voltage drop across R
6
, V
BE
or Q
1
and V
F
of the LED. This voltage is 2.5 – 3.0V and when referred to the input
gives a threshold of 2.5 – 3.0 mV at the amplifier.
The circuit can be set up for a specified threshold voltage. Release
time is usually determned empirically. A typical set up procedure uses
an audio signal containing spoken dialog. Initially, the THRESHOLD
adjustment is set to the maximumand the RELEASE is set to the
mnimum The programis turned on and the THRESHOLD is
decreased until the audio starts comng through, but sounds chopped
up. The chopping occurs because the circuit is too fast on release. The
RELEASE is increased until the audio is smoothed out and sounds
normal. Setting of the two controls needs to be made carefully. A
threshold set too high cuts off the quieter sounds, while a setting which
is too low allows more of the noise to come through. Short release time
causes more chopping of the audio and can create some distortion at
the lower frequencies. Long release time keeps the gate open too long
allowing noise to come through after the signal is gone. Adjustments
should be made incrementally and worked between the two controls
until the best sound is achieved.
Figure 3. Audio Sound Gate
相關PDF資料 |
PDF描述 |
|---|---|
| VT905GA | |
| VT905GC | |
| VT90N1 | |
| VT90N2 | |
| VT90N3 | |
相關代理商/技術參數 |
參數描述 |
|---|---|
| VT905GA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT905GB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT905GC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT90A114 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
| VT90A432 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。