- 您現在的位置：買賣IC網 > PDF目錄361881 > WM9712LEFT (Wolfson Microelectronics) AC97 Audio and Touchpanel CODEC PDF資料下載
參數資料
| 型號： | WM9712LEFT |
| 廠商： | Wolfson Microelectronics |
| 元件分類： | Codec |
| 英文描述： | AC97 Audio and Touchpanel CODEC |
| 中文描述： | AC97音頻編解碼器和觸摸屏 |
| 文件頁數： | 44/78頁 |
| 文件大小： | 689K |
| 代理商： | WM9712LEFT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁
WM9712L
Production Data
w
PD Rev 4.0 December 2003
44
When COO is ‘0’, the WM9712L performs one type of measurement once (in polling mode) or
continuously (in continuous mode).
The co-ordinate mode (COO = ‘1’) makes it easier to obtain co-ordinate pairs rather than single co-
ordinates. In polling-coordinate mode (CTC = ‘0’, COO = ‘1’), the WM9712L performs an X
measurement, followed by a Y measurement, followed by an additional measurement determined by
ADCSEL, then stops. In continuous-coordinate mode (CTC = ‘1’, COO = ‘1’), the WM9712L
continuously repeats a sequence consisting of an X-co-ordinate measurement, followed by a Y co-
ordinate measurement, followed by an additional measurement determined by ADCSEL (if ADCSEL
= 000, the sequence is XYXYXY… only).
DATA READBACK
The output data word of the touchpanel interface consists of three parts:
Pen Status (1 bit) – this is also passed to the GPIO logic block, which can be
programmed to generate an interrupt and/or wake up the WM9712L on pen down (see
GPIO and Interrupt Control).
Output data from the touchpanel ADC (12 bits)
ADCSRC: 3 additional bits that indicate the source of the ADC data. With COO = ‘0’,
ADCSRC echoes ADCSEL. However, in co-ordinate mode (COO = ‘1’), the WM9712L
schedules different types of measurements autonomously and sets the ADCSRC bits
accordingly (see “Measurement Types”).
This data is stored in register 7Ah, and can be retrieved by reading the register in the usual manner
(see AC-Link Interface section). Additionally, the data can also be passed to the controller on one of
the AC-Link time slots not used for audio functions.
If the data is being read back using the polling method, there are several ways to determine when a
measurement has finished:
Reading back the POLL bit. If it has been reset to ‘0’, then the measurement has finished.
By monitoring the ADA signal, see GPIO and interrupt section
Reading back 7Ah until the new data appears
REGISTER
ADDRESS
7Ah
or
AC-Link slot
selected by
SLT
BIT
LABEL
DEFAULT
DESCRIPTION
15
PNDN
0
Pen status (read-only)
0: Pen Up
1: Pen Down
Touchpanel ADC Source
000: No measurement
001: X co-ordinate measurement
010: Y co-ordinate measurement
011: Pressure measurement
(4-wire touchpanels only)
100: COMP1/AUX1 measurement (pin 29)
101: COMP2/AUX2 measurement (pin 30)
110: BMON/AUX3 measurement (pin 31)
111: WIPER/AUX4 measurement (pin 12)
Touchpanel ADC Data (read-only)
Bit 11 = MSB
Bit 0 = LSB
0: No effect (new ADC data overwrites
unread data in register 7Ah)
1: New data is held back, and
measurements delayed, until register 7Ah is
read)
14:12
ADCSRC
000
11:0
ADCD
000h
78h
9
WAIT
0
Table 29 Touchpanel Digitiser Data
To avoid losing data that has not yet been read, the WM9712L can delay overwriting register 7Ah
with new data until the old data has been read. This function is enabled using the WAIT bit.
相關PDF資料 |
PDF描述 |
|---|---|
| WM9712LEFV | AC97 Audio and Touchpanel CODEC |
| WM9712LSEFL | AC97 Audio and Touchpanel CODEC |
| WM9712LSEFT | AC97 Audio and Touchpanel CODEC |
| WM9712LSEFV | AC97 Audio and Touchpanel CODEC |
| WME128K8-XXX | 128Kx8 CMOS MONOLITHIC EEPROM, SMD 5962-96796 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| WM9712LEFT/RV | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:AC97 Audio and Touchpanel CODEC |
| WM9712LEFV | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:AC97 Audio and Touchpanel CODEC |
| WM9712LGEFL/RV | 功能描述:接口—CODEC STR AC’97 CODEC TP 48-pin TQFP RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| WM9712LGEFL/V | 功能描述:接口—CODEC Stereo AC’97 CODEC T/P Interface RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| WM9712LSEFL | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:AC97 Audio and Touchpanel CODEC |
發布緊急采購，3分鐘左右您將得到回復。