參數資料
型號： X3100
英文描述： Reed Relay; Contacts:SPST; Switching Current Max:0.5A; Switching Voltage Max:200V; Contact Carry Current:1A; Coil Voltage DC Max:5V; Relay Terminals:DIP-14; Relay Mounting:PC Board; Contact Carrying Power:10W
中文描述： 3或4芯鋰離子電池保護和監控器IC
文件頁數： 24/40頁
文件大?。?/td> 249K
代理商： X3100
X3100/X3101 – Preliminary Information
Characteristics subject to change without notice.
24 of 40
REV 1.1.8 12/10/02
www.xicor.com
EEPROM Write Sequence (EEWRITE)
Prior to any attempt to write data into the EEPROM of
the X3100 or X3101, the “Write Enable” latch must first
be set by issuing the WREN instruction (See Table 30
and Figure 11). CS is first taken LOW. Then the WREN
instruction is clocked into the X3100 or X3101. After all
eight bits of the instruction are transmitted, CS must
then be taken HIGH. If the user continues the write
operation without taking CS HIGH after issuing the
WREN instruction, the write operation will be ignored.
To write data to the EEPROM memory array, the user
issues the EEWRITE instruction, followed by the 16 bit
address and the data to be written. Only the last 9 bits of
the address are used and bits [15:9] are specified to be
zeroes. This is minimally a thirty-two clock operation. CS
must go LOW and remain LOW for the duration of the
operation. The host may continue to write up to 16 bytes
of data to the X3100 or X3101. The only restriction is the
16 bytes must reside on the same page. If the address
counter reaches the end of the page and the clock
continues, the counter will “roll over” to the first address
of the page and overwrite any data that may have been
previously written.
For a byte or page write operation to be completed, CS
can only be brought HIGH after bit 0 of the last data byte
to be written is clocked in. If it is brought HIGH at any
other time, the write operation will not be completed.
Refer to Figure 12 and Figure 13 for detailed illustration
of the write sequences and time frames in which CS
going HIGH are valid.
EEPROM Read Status Operation (EEREAD STAT)
If there is not a nonvolatile write in progress, the
EEREAD STAT instruction returns the IDLock byte from
the IDLock register which contains the IDLock bits IDL2-
IDL0 (Table 29). The IDLock bits define the IDLock
condition (Table 28). The other bits are reserved and will
return ‘0’ when read.
If a nonvolatile write to the EEPROM (i.e. EEWRITE
instruction) is in progress, the EEREAD STAT returns a
HIGH on SO. When the nonvolatile write cycle in the
EEPROM is completed, the status register data is read
out.
Clocking SCK is valid during a nonvolatile write in
progress, but is not necessary. If the SCK line is clocked,
the pointer to the status register is also clocked, even
though the SO pin shows the status of the nonvolatile
write operation (See Figure 14).
Figure 12. EEPROM Byte Write (EEWRITE) Operation Sequence
0
1
2
3
4
5
6
7
8
9
CS
SCK
SI
SO
High Impedance
EEWRITE Instruction
(1 Byte)
Byte Address (2 Byte)
Data Byte
15
14
3
2
1
0
20
21
22
23
24
25
26
27
28
29
30
31
7
6
5
4
3
2
1
0
相關PDF資料
PDF描述
X3100Q WAFER(ARM)
X3100V QFN,GREEN,IND TEMP,T&R(ARM)
X3101PT-V 3 or 4 Cell Li-Ion Battery Protection and Monitor IC
X3100 Reed Relay; Contacts:SPST; Switching Current Max:0.5A; Switching Voltage Max:200V; Contact Carry Current:1A; Coil Voltage DC Max:5V; Relay Terminals:DIP-14; Relay Mounting:PC Board; Contact Carrying Power:10W
X3100V28 Reed Relay; Contacts:SPST; Contact Carry Current:1A; Coil Voltage DC Max:5V; Relay Terminals:Thru Hole; Switching Current Max:0.5A; Switching Voltage Max:200V; Contact Carrying Power:10W; Leaded Process Compatible:Yes RoHS Compliant: Yes
相關代理商/技術參數
參數描述
X3100_08 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:3 or 4 Cell Li-ion Battery Protection and Monitor IC
X310014 制造商:MERSEN / FERRAZ SHAWMUT 功能描述:MICROCONTACT FOR PROTISTOR 制造商:MERSEN / FERRAZ SHAWMUT 功能描述:MICROCONTACT, FOR PROTISTOR 制造商:MERSEN / FERRAZ SHAWMUT 功能描述:MICROCONTACT, FOR PROTISTOR; Contact Configuration:-; Microswitch Type:-; Actuator Style:Top; Switch Operation:-; Contact Current AC:3A; Contact Current AC Max:16A; Contact Current DC Max:10A; Contact Voltage AC Max:1kV; Contact
X3100PT-V 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:3 or 4 Cell Li-Ion Battery Protection and Monitor IC
X3100Q 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Battery Management
X3100V 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Battery Management
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*