- 您現在的位置：買賣IC網 > PDF目錄1974 > XE8801AMI000WP (Semtech)SENSING MACHINE WITH 16 + 10 BIT PDF資料下載
參數資料
| 型號： | XE8801AMI000WP |
| 廠商： | Semtech |
| 文件頁數： | 8/135頁 |
| 文件大小： | 0K |
| 描述： | SENSING MACHINE WITH 16 + 10 BIT |
| 標準包裝： | 558 |
| 系列： | XE880x |
| 應用： | 感測機 |
| 核心處理器： | Coolrisc816? |
| 程序存儲器類型： | 閃存（22 kB） |
| 控制器系列： | XE8000 |
| RAM 容量： | 512 x 8 |
| 接口： | UART，USRT |
| 輸入/輸出數： | 24 |
| 電源電壓： | 2.4 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 模具 |
| 包裝： | 托盤 |
| 配用： | XE8000MP-ND - PROG BOARD AND PROSTART2 CARD |
| 其它名稱： | Q2722595 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁
Semtech 2005
www.semtech.com
16-20
XE8801A – SX8801R
16.8.3
Linearity
16.8.3.1
Integral non-linearity
The integral non-linearity depends on the selected gain configuration. First of all, the non-linearity of the ADC (all
PGA stages bypassed) is shown in Figure 16-8.
Figure 16-8 Integral non-linearity of the ADC (PGA disabled, reference voltage of 4.8V)
The different PGA stages have been designed to find the best compromise between the noise performance, the
integral non-linearity and the power consumption. To obtain this, the first stage has the best noise performance and
the third stage the best linearity performance. For large input signals (small PGA gains, i.e. up to about 50), the noise
added by the PGA is very small with respect to the input signal and the second and third stage of the PGA should be
used to get the best linearity. For small input signals (large gains, i.e. above 50), the noise level in the PGA is
important and the first stage of the PGA should be used.
The following figures give the non-linearity for different gain settings of the PGA, selecting the appropriate stage to
get the best noise and linearity performance. Figure 16-9 shows the non-linearity when the third stage is used with a
gain of 1. It is of course not very useful to use the PGA with a gain of 1 unless it is used to compensate offset. By
increasing the gain, the integral non-linearity becomes even smaller since the signal in the amplifiers reduces.
Figure 16-10 shows the non-linearity for a gain of 2. Figure 16-11 shows the non-linearity for a gain of 5. Figure
16-12 shows the non-linearity for a gain of 10. By comparing these figures to Figure 16-8, it can be seen that the
third stage of the PGA does not add significant integral non-linearity.
Figure 16-13 shows the non-linearity for a gain of 20 and Figure 16-14 shows the non-linearity for a gain of 50. In
both cases the PGA2 is used at a gain of 10 and the remaining gain is realized by the third stage. It can be seen
again that the second stage of the PGA does not add significant non-linearity.
For gains above 50, the first stage PGA1 should be selected in stead of PGA2. Although the non-linearity in the first
stage of the PGA is larger than in stage 2 and 3, the gain in stage 3 is now sufficiently high so that the non-linearity
of the first stage does become negligible as is shown in Figure 16-15 for a gain of 100. Therefor, the first stage is
preferred over the second stage since it has less noise.
Increasing the gain further up to 1000 will further increase the linearity since the signal becomes very small in the
first two stages. The signal is full scale at the output of stage 3 and as shown in Figure 16-9 to Figure 16-12, this
stage has very good linearity.
Not
Recommended
for
New
Designs
相關PDF資料 |
PDF描述 |
|---|---|
| XE8802MI035LF | IC DAS 16BIT FLASH 8K 100-LQFP |
| XE8805AMI028LF | IC DAS 16BIT FLASH 8K MTP 64LQFP |
| XE8807AMI026TLF | IC MCU LOW PWR MTP FLASH 32-TQFP |
| XIO2200AGGW | IC PCI-EXPRESS/BUS BRIDGE 176BGA |
| XIO2200AZGW | IC PCI-EXPRESS/BUS BRIDGE 176BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XE8801AMI027LF | 功能描述:IC DAS 16BIT FLASH 8K MTP 44LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器 - 特定應用 系列:XE880x 產品變化通告:Product Discontinuation 26/Aug/2009 標準包裝:250 系列:- 應用:網絡處理器 核心處理器:4Kc 程序存儲器類型:- 控制器系列:- RAM 容量:16K x 8 接口:以太網，UART，USB 輸入/輸出數:- 電源電壓:1.8V, 3.3V 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:208-LQFP 包裝:帶卷 (TR) 供應商設備封裝:PG-LQFP-208 其它名稱:SP000314382 |
| XE8802 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Sensing Machine Data Acquisition MCU |
| XE8802MI000 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Sensing Machine Data Acquisition MCU |
| XE8802MI035LF | 功能描述:IC DAS 16BIT FLASH 8K 100-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器 - 特定應用 系列:XE880x 產品變化通告:Product Discontinuation 26/Aug/2009 標準包裝:250 系列:- 應用:網絡處理器 核心處理器:4Kc 程序存儲器類型:- 控制器系列:- RAM 容量:16K x 8 接口:以太網，UART，USB 輸入/輸出數:- 電源電壓:1.8V, 3.3V 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:208-LQFP 包裝:帶卷 (TR) 供應商設備封裝:PG-LQFP-208 其它名稱:SP000314382 |
| XE8805 | 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Data Acquisition MCU |
發布緊急采購，3分鐘左右您將得到回復。