- 您現在的位置：買賣IC網 > PDF目錄16433 > XR16M698IQ-0A-EVB (Exar Corporation)EVAL BOARD FOR M698-A 100QFP PDF資料下載
參數資料
| 型號： | XR16M698IQ-0A-EVB |
| 廠商： | Exar Corporation |
| 文件頁數： | 23/58頁 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR M698-A 100QFP |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
XR16M698
3
REV. 1.0.0
1.62V TO 3.63V HIGH PERFORMANCE OCTAL UART WITH 32-BYTE FIFO
PIN DESCRIPTIONS
NAME
PIN #
TYPE
DESCRIPTION
DATA BUS INTERFACE
A7:A0
20-27
I
Address lines [7:0]. A0:A3 selects individual UART’s 16 configuration registers,
A4:A6 selects UART channel 0 to7, and A7 selects the global device configuration
registers.
D7:D0
5-12
IO
Data bus lines [7:0] (bidirectional).
IOR#
19
I
When 16/68# pin is HIGH, it selects Intel bus interface and this input is read strobe
(active LOW). The falling edge instigates an internal read cycle and retrieves the
data byte from an internal register pointed by the address lines [A7:A0], places it on
the data bus to allow the host processor to read it on the leading edge.
When 16/68# pin is LOW, it selects Motorola bus interface and this input should be
connected to VCC.
IOW#
(R/W#)
13
I
When 16/68# pin is HIGH, it selects Intel bus interface and this input becomes write
strobe (active LOW). The falling edge instigates the internal write cycle and the
leading edge transfers the data byte on the data bus to an internal register pointed
by the address lines.
When 16/68# pin is LOW, it selects Motorola bus interface and this input becomes
read (HIGH) and write (LOW) signal (R/W#).
CS#
30
I
When 16/68# pin is HIGH, this input is chip select (active LOW) to enable the
XR16M698 device.
When 16/68# pin is LOW, this input becomes the read and write strobe (active
LOW) for the Motorola bus interface.
INT#
16
OD
Global interrupt output from XR16M698 (open drain, active LOW). This output
requires an external pull-up resistor (47K-100K ohms) to operate properly. It may be
shared with other devices in the system to form a single interrupt line to the host pro-
cessor and have the software driver polls each device for the interrupt status.
MODEM OR SERIAL I/O INTERFACE
TX0
93
O
UART channel 0 Transmit Data or infrared transmit data.
RX0
100
I
UART channel 0 Receive Data or infrared receive data. Normal RXD input idles
HIGH. The infrared pulse can be inverted internally prior to decoding by setting
FCTR bit-4.
RTS0#
95
O
UART channel 0 Request to Send or general purpose output (active LOW). This
port may be used for one of two functions:
1) Auto hardware flow control, see EFR bit-6, MCR bits-1 & 2, FCTR bits 0-3 and
IER bit-6
2) RS-485 half-duplex direction control, see FCTR bit-5, MCR bit-2 and MSR bits 0-
7.
CTS0#
99
I
UART channel 0 Clear to Send or general purpose input (active LOW). It can be
used for auto hardware flow control, see EFR bit-7, MCR bit-2 and IER bit-7.
DTR0#
94
O
UART channel 0 Data Terminal Ready or general purpose output (active LOW). This
port may be used forone of two functions.
1) auto hardware flow control, see EFR bit-6, FCTR bits-0 to 3, MCR bits-0 & 2, and
IER bit-6
2) RS-485 half-duplex direction control, see FCTR bit-5, MCR bit-2 and MSR bits 0-
7.
DSR0#
98
I
UART channel 0 Data Set Ready or general purpose input (active LOW). It can be
used for auto hardware flow control, see EFR bit-7, MCR bit-2 and IER bit-7.
CD0#
97
I
UART channel 0 Carrier Detect or general purpose input (active LOW).
相關PDF資料 |
PDF描述 |
|---|---|
| A3BBB-3018G | IDC CABLE- ASR30B/AE30G/ASR30B |
| VI-2V1-EX | CONVERTER MOD DC/DC 12V 75W |
| EBM18DCCT | CONN EDGECARD 36POS R/A .156 SLD |
| CM322522-680KL | INDUCTOR 68UH 65MA SMD |
| VI-27T-EX | CONVERTER MOD DC/DC 6.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR16M698IQ-0B-EVB | 功能描述:界面開發工具 Eval Board for XR16M698IQ-0B RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| XR16M698IQ100 | 制造商:EXAR 制造商全稱:EXAR 功能描述:1.62V TO 3.63V HIGH PERFORMANCE OCTAL UART WITH 32-BYTE FIFO |
| XR16M698IQ100-F | 功能描述:UART 接口集成電路 8-ch 32-byte UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16M698IQ100TR-F | 制造商:Exar Corporation 功能描述:UART 8-CH 32Byte FIFO 1.8V/2.5V/3.3V 100-Pin PQFP T/R 制造商:Exar Corporation 功能描述:XR16M698IQ100TR-F |
| XR16M752 | 制造商:EXAR 制造商全稱:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 64-BYTE FIFO |
發布緊急采購，3分鐘左右您將得到回復。