- 您現在的位置：買賣IC網 > PDF目錄376462 > XRT75L06DIB (EXAR CORP) SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER PDF資料下載
參數資料
| 型號： | XRT75L06DIB |
| 廠商： | EXAR CORP |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER |
| 中文描述： | DATACOM, PCM TRANSCEIVER, PBGA217 |
| 封裝： | 23 X 23 MM, BGA-217 |
| 文件頁數： | 71/103頁 |
| 文件大?。?/td> | 679K |
| 代理商： | XRT75L06DIB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁
XRT75L06D
SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
xr
REV. 1.0.4
67
As a consequence, no "Mapping/De-Mapping" Jitter or Wander is induced in the "Ideal Case".
7.2.2.2
The 44.736Mbps + 1ppm Case
The "above example" was a very ideal case. In reality, there are going to be frequency offsets in both the DS3
and STS-1 signals. For instance Bellcore GR-499-CORE mandates that a DS3 signal have a bit rate of
44.736Mbps ± 20ppm. Hence, the bit-rate of a "Bellcore" compliant DS3 signal can vary from the exact correct
frequency for DS3 by as much of 20ppm in either direction. Similarly, many SONET applications mandate that
SONET equipment use at least a "Stratum 3" level clock as its timing source. This requirement mandates that
an STS-1 signal must have a bit rate that is in the range of 51.84 ± 4.6ppm. To make matters worse, there are
also provisions for SONET equipment to use (what is referred to as) a "SONET Minimum Clock" (SMC) as its
timing source. In this case, an STS-1 signal can have a bit-rate in the range of 51.84Mbps ± 20ppm.
In order to convey the impact that frequency offsets (in either the DS3 or STS-1 signal) will impose on the bit-
stuffing behavior, and the resulting bit-rate, intrinsic jitter and wander within the DS3 signal that is being
transported across the SONET network; let us assume that a DS3 signal, with a bit-rate of 44.736Mbps +
1ppm is being mapped into an STS-1 signal with a bit-rate of 51.84Mbps + 0ppm. In this case, the following
things will occur.
In general, most of the STS-1 SPE's will each transport 5592 DS3 data bits.
However, within a "one-second" period, a DS3 signal that has a bit-rate of 44.736Mbps + 1 ppm will deliver
approximately 44.7 additional bits (over and above that of a DS3 signal with a bit-rate of 44.736Mbps + 0
ppm). This means that this particular signal will need to "negative-stuff" or map in an additional DS3 data bit
every (1/44.736 =) 22.35ms. In other words, this additional DS3 data bit will need to be mapped into about
one in every (22.35ms · 8000 =) 178.8 STS-1 SPEs in order to avoid dropping any DS3 data-bits.
What does this mean at the "Source" PTE
All of this means that as the "Source" PTE maps this DS3 signal, with a data rate of 44.736Mbps + 1ppm into
an STS-1 signal, most of the resulting "outbound" STS-1 SPEs will transport 5592 DS3 data bits (e.g., 3 Stuff
Opportunity bits will be carrying DS3 data bits, the remaining 6 Stuff Opportunity bits are "stuff" bits, as in the
"Ideal" case). However, in approximately one out of 178.8 "outbound" STS-1 SPEs, there will be a need to
insert an additional DS3 data bit within this STS-1 SPE. Whenever this occurs, then (for these particular STS-
1 SPEs) the SPE will be carrying 5593 DS3 data bits (e.g., 4 Stuff Opportunity bits will be carrying DS3 data
bits, the remaining 5 Stuff Opportunity bits are "stuff" bits).
Figure 47 presents an illustration of the STS-1 SPE traffic that will be generated by the "Source" PTE, during
this condition.
F
IGURE
47. A
N
I
LLUSTRATION
OF
THE
STS-1 SPE
TRAFFIC
THAT
WILL
BE
GENERATED
BY
THE
"S
OURCE
" PTE,
WHEN
MAPPING
IN
A
DS3
SIGNAL
THAT
HAS
A
BIT
RATE
OF
44.736M
BPS
+ 1
PPM
,
INTO
AN
STS-1
SIGNAL
PTE
Source
44.736Mbps + 1ppm
5592
DS3 Data
Bits
5592
DS3 Data
Bits
SPE # N
SPE # N+1
5592
DS3 Data
Bits
SPE # N+177
5593
DS3 Data
Bits
5592
DS3 Data
Bits
SPE # N+178
SPE # N+179
Extra DS3 Data
Bit Stuffed Here
STS-1 SPE Data Stream
相關PDF資料 |
PDF描述 |
|---|---|
| XRT75L06 | SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
| XRT75L06IB | SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
| XRT75R03D | THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCRONIZER |
| XRT75R03DIV | THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCRONIZER |
| XRT75R03 | THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT75L06DIB-F | 功能描述:外圍驅動器與原件 - PCI 6-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75L06ES | 功能描述:時鐘合成器/抖動清除器 6 CHT3/E3/STS1 LIU+JA 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L06IB | 功能描述:接口 - 專用 6CH E3/DS3/STS1 LIU+Jitter Attenuato RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| XRT75L06IB-F | 功能描述:外圍驅動器與原件 - PCI 6-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75R03 | 制造商:EXAR 制造商全稱:EXAR 功能描述:THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
發布緊急采購，3分鐘左右您將得到回復。