參數資料
型號： 20-101-0494
廠商： Rabbit Semiconductor
文件頁數： 22/90頁
文件大?。?/td> 0K
描述： MODULE RABBITCORE RCM2250
標準包裝： 1
系列： RabbitCore®
模塊/板類型： MPU 核心模塊
適用于相關產品： RCM2250
產品目錄頁面： 620 (CN2011-ZH PDF)
其它名稱： 316-1092
User’s Manual
23
4.2 Serial Communication
The RCM2200 board does not have an RS-232 or an RS-485 transceiver directly on the
board. However, an RS-232 or RS-485 interface may be incorporated on the board the
RCM2200 is mounted on. For example, the Prototyping Board supports a standard
RS-232 transceiver chip.
4.2.1 Serial Ports
There are four serial ports designated as Serial Ports A, B, C, and D. All four serial ports
can operate in an asynchronous mode up to the baud rate of the system clock divided by
64. An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where an
additional bit is sent to mark the first byte of a message, is also supported. Serial Ports A
and B can also be operated in the clocked serial mode. In this mode, a clock line synchro-
nously clocks the data in or out. Either of the two communicating devices can supply the
clock. When the Rabbit 2000 provides the clock, the baud rate can be up to 80% of the
system clock frequency divided by 128, or 138,240 bps for a 22.1 MHz clock speed.
Serial Port A is available only on the programming port, and so is likely to be inconve-
nient to interface with.
4.2.2 Ethernet Port
Figure 6 shows the pinout for the RJ-45 Ethernet port (J2). Note that some Ethernet con-
nectors are numbered in reverse to the order used here.
Figure 6. RJ-45 Ethernet Port Pinout
Two LEDs are placed next to the RJ-45 Ethernet
jack, one to indicate an Ethernet link (LNK) and one
to indicate Ethernet activity (ACT).
The Ethernet signals are also available on header J4.
The ACK and LNK signals can be used to drive LEDs
on the user board the RCM2200 is connected to.
The transformer/connector assembly ground is con-
nected to the RCM2200 printed circuit board digital
ground via a 0
resistor, R29, as shown in Figure 7.
Figure 7. Isolation Resistor R29
ETHERNET
RJ-45 Plug
1. E_Tx+
2. E_Tx
3. E_Rx+
6. E_Rx
1
8
RJ-45 Jack
RJ-45 Ethernet Plug
R29
Chassis
Ground
Board
Ground
相關PDF資料
PDF描述
AT25020N-10SI-2.7 IC EEPROM 2KBIT 2.1MHZ 8SOIC
345-030-521-801 CARDEDGE 30POS DUAL .100 GREEN
12FMN-BMTTN-A-TF CONN FMN HSNG 12POS STAG NOR SMD
AT25020-10PI-2.7 IC EEPROM 2KBIT 2.1MHZ 8DIP
345-030-521-204 CARDEDGE 30POS DUAL .100 GREEN
相關代理商/技術參數
參數描述
20-101-0495 功能描述:處理器配件 BASEPLATE RoHS:否 制造商:Olimex Ltd. 產品:Cable 用于:
20-101-0497 功能描述:單板計算機 OP6810 RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
201-01050 功能描述:鋁質電解電容器 - 帶引線 1 uF Electrolytic Capacitor RoHS:否 制造商:Kemet 引線類型: 電容:220 uF 容差:20 % 電壓額定值:25 V 工作溫度范圍: 端接類型:Radial 外殼直徑:8 mm 外殼長度:11 mm 引線間隔:5 mm 產品:General Purpose Electrolytic Capacitors 封裝:Bulk
201-0105-01 功能描述:印刷電路板和試驗板 JTAG 20 Pin Connector RoHS:否 制造商:3M Electronic Solutions Division 產品:Jumper & Insulated Wires 描述/功能:Jumper wire, 22 AWG 0.1 inch 長度:0.1 in 寬度:
20-101-0502 功能描述:處理器配件 Keypad/Display Unit 5V Panle Mount RoHS:否 制造商:Olimex Ltd. 產品:Cable 用于:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*