參數資料
型號: 73M1822-KEYCHN
廠商: Maxim Integrated Products
文件頁數: 62/82頁
文件大小: 0K
描述: BOARD KEYCHAIN 73M1822 42-QFN
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 1
主要目的: *
嵌入式: *
已用 IC / 零件: *
主要屬性: *
次要屬性: *
已供物品: 板,CD
DS_1x22_017
73M1822/73M1922 Data Sheet
Rev. 1.6
65
11.5 Trans-Hybrid Cancellation
A Transmit Bit Stream (TBS) emulating a sinusoid of 1 kHz, full scale (code word of +/- 32,767) is applied to
SDIN and the residual signal is measured at SDOUT. Unless stated otherwise, test conditions are: ACZ=00
(600 Ω termination), THEN=1, ATEN=0, DAA=01, TXBST=0. TXM is externally fed back into the Line-Side
Device (73M1912) to effect cancellation of transmit signal.
Table 43: Trans-Hybrid Cancellation
Parameter
Test Condition
Min
Nom
Max
Units
Transmit hybrid
cancellation
Measure RxD in HIC
26
dB
Offset voltage
50% 1’s Density
25
50
mV
AC swing
1kHz sinusoid at Tip and Ring
0.85
0.95
1.05
Vpk
Idle noise
300 Hz – 4 kHz at Tip and Ring
-81
dBm
11.6 Direct Access Arrangement Control Functions
These Transmit Control Registers contain control information to set up the line side of the 73M1x22.
Included are DC-IV characteristics, off-hook control, etc.
Table 44: DAA Control Functions
Function
Mnemonic
Register
Location
Type
Description
OFH
0x12[7]
WO
Off-Hook Enable
This bit controls the state of the Hook signal.
0 = On-Hook. (Default)
1 = Off-Hook.
PLDM
0x13[3]
WO
Pulse Dialing Mode Enable
Alleviates the strict timing requirements for the Host having to control
ENDC and OFH during pulse dialing. With PLDM = 1, the Host only has
to toggle OFH to perform pulse dialing.
0 = Pulse Dialing Mode is disabled. (Default)
1 = Pulse Dialing Mode is enabled.
IDISPD
0x13[1:0]
WO
Discharge and Pulse Dialing
Controls the DC discharge current and how fast the loop turns off. Affects
pulse dialing waveform. Controls the amount of discharge current during
hook switch transitions.
0 = Minimum current. (Default)
1 = Maximum current.
It is recommended to set IDISPD to 1 prior to hook switching operations.
ENNOM
0x12[0]
WO
Enable Nominal Operation
0 = Speeds up the on and off hook transitions time by increasing the DC
loop bandwidth of the DC transconductance circuit in the 73M1x22. This
can be used for pulse dialing. In addition, ENNOM=0 prevents the reset
of all bits in Register 0x12. (Default)
1 = Enter Nominal Operation. Reduces the loop bandwidth of the DC
transconductance circuit. Allows reset of Register 0x12 caused by bits
UVDT, OVDT or OIDT.
相關PDF資料
PDF描述
78Q2133-DB EVAL BOARD 78Q2133
MAX14821EVKIT# EVAL KIT MAX14821
UVZ1C472MHD CAP ALUM 4700UF 16V 20% RADIAL
78Q2123-DB BOARD DEMO 78Q2123 78Q2133
78Q2120C09-DB BOARD DEMO 78Q2120C
相關代理商/技術參數
參數描述
73M1866B-IFX 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M1866B-IM/F 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M1866B-IMR/F 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M1866B-KEYCHN 功能描述:網絡開發工具 73M1866B Keychain Brd RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
73M1902-IM/F 功能描述:電信線路管理 IC MicroDAA Chip Set Host Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray