參數資料
型號: 73S1215F-68IM/F/P
廠商: Maxim Integrated Products
文件頁數: 116/136頁
文件大?。?/td> 0K
描述: IC SMART CARD READER PROG 68-QFN
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 260
系列: 73S12xx
核心處理器: 80515
芯體尺寸: 8-位
速度: 24MHz
連通性: I²C,智能卡,UART/USART,USB
外圍設備: LED,POR,WDT
輸入/輸出數: 9
程序存儲器容量: 64KB(64K x 8)
程序存儲器類型: 閃存
RAM 容量: 2K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 68-VFQFN 裸露焊盤
包裝: 管件
73S1215F Data Sheet
DS_1215F_003
VCC
IO
RST
CLK
t1
t2
t3
t4
t5
Firmware sets
VCCSEL to 00
CMDVCCnB
t5 delay or
Card Event
t1: Time after either a “card event” occurs or firmware sets the VCCSela and VCCSelb bits to 0 (see
t5, VCCOff_tmr) occurs until RST is asserted low.
t2: Time after RST goes low until CLK stops.
t3: Time after CLK stops until IO goes low.
t4: Time after IO goes low until VCC is powered down.
t5: Delayed VCC off time (in ETUs per VCCOff_tmr bits). Only in effect due to firmware deactivation.
Figure 18: Deactivation Sequence
1.7.15.3 Data Reception/Transmission
When a 12Mhz crystal is used, the smart card UART will generate a 3.69Mhz (default) clock to both
smart card interfaces. This will allow approximately 9600bps (1/ETU) communication during ATR (ISO
7816 default). As part of the PPS negotiation between the smart card and the reader, the firmware may
determine that the smart card parameters F & D may be changed. After this negotiation, the firmware
may change the ETU by writing to the SFR FDReg to adjust the ETU and CLK. The firmware may also
change the smart card clock frequency by writing to the SFR SCCLK (SCECLK for external interface).
Independent clock frequency control is provided to each smart card interface. Clock stop high or Clock
stop low is supported in asynchronous mode. Figure 19 shows the ETU and CLK control circuits. The
firmware determines when clock stop is supported by the smart card and when it is appropriate to go into
that mode (and when to come out of it). The smart card UART is clocked by the same clock that is
provided to the selected smart card. The transition between smart card clocks is handled in hardware to
eliminate any glitches for the UART during switchover. The external smart card clock is not affected
when switching the UART to communicate with the internal smart card.
80
Rev. 1.4
相關PDF資料
PDF描述
73S1215F-44IMR/F/P IC SMART CARD READER PROG 44-QFN
73S1215F-44IM/F/P IC SMART CARD READER PROG 44-QFN
73S1210F-68IM/F/P IC SMART CARD READER PROG 68-QFN
73S1210F-44IMR/F/P IC SMART CARD READER PROG 44-QFN
MAXQ613E-0000+ IC MCU 16BIT IR MOD 32LQPF
相關代理商/技術參數
參數描述
73S1215F68IMLV1.15 制造商:Maxim Integrated Products 功能描述:8-bit Microcontrollers - MCU 80515 SoC w/USB & PINpad
73S1215F-68IMR/F 功能描述:8位微控制器 -MCU 80515 SoC w/USB & PINpad RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
73S1215F-68IMR/F/P 功能描述:IC SMART CARD READER PROG 68-QFN RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:73S12xx 產品培訓模塊:MCU Product Line Introduction AVR® UC3 Introduction 標準包裝:2,500 系列:AVR®32 UC3 B 核心處理器:AVR 芯體尺寸:32-位 速度:60MHz 連通性:I²C,IrDA,SPI,SSC,UART/USART,USB 外圍設備:欠壓檢測/復位,DMA,POR,PWM,WDT 輸入/輸出數:28 程序存儲器容量:128KB(128K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:32K x 8 電壓 - 電源 (Vcc/Vdd):1.65 V ~ 1.95 V 數據轉換器:A/D 6x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-TQFP 包裝:帶卷 (TR) 配用:ATSTK600-TQFP48-ND - STK600 SOCKET/ADAPTER 48-TQFPATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMRATEVK1101-ND - KIT DEV/EVAL FOR AVR32 AT32UC3B 其它名稱:AT32UC3B1128-AUR-NDAT32UC3B1128-AURTR
73S1215F-EB 功能描述:開發板和工具包 - 8051 73S1215F Eval Brd (USD Cbl, Doc. Cd) RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓:
73S1215F-EB-Lite 功能描述:開發板和工具包 - 8051 73S1215F Eval Brd Lite (USD Cbl, D.Cd) RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓: