- 您現在的位置：買賣IC網 > PDF目錄1887 > 73S1217F-68MR/F/PE (Maxim Integrated Products)IC SOC SMART CARD READER 68QFN PDF資料下載
參數資料
| 型號： | 73S1217F-68MR/F/PE |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 131/140頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SOC SMART CARD READER 68QFN |
| 標準包裝： | 2,500 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁當前第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁
73S1217F Data Sheet
DS_1217F_002
Smart Card Interrupt Register (SCInt): 0xFE01
0x00
When the smart card interrupt is asserted, the firmware can read this register to determine the actual
cause of the interrupt. The bits are cleared when this register is read. Each interrupt can be disabled by
the Smart Card Interrupt Enable register. Error processing must be handled by the firmware. This
register relates to the interface that is active – see the SCSel register (above).
Table 80: The SCInt Register
MSB
LSB
WAITTO CRDEVT VCCTMRI
RXDAV
TXEVT
TXSENT
TXERR
RXERR
Bit
Symbol
Function
SCInt.7
WAITTO
Wait Timeout – An ATR or card wait timeout has occurred. In sync
mode, this interrupt is asserted when the RLen counter (it advances on
falling edges of CLK/ETU) reaches the loaded (max) value. This bit is
cleared when the SCINT register is read. When running in Synchronous
Clock Stop Mode, this bit becomes RLenINT interrupt (set when the Rlen
counter reaches the terminal count).
SCInt.6
CRDEVT
Card Event – A card event is signaled via pin DETCARD either when the
Card was inserted or removed (read the CRDCtl register to determine
card presence) or there was a fault condition in the interface circuitry.
This bit is functional even if the smart card logic clock is disabled and
when the PWRDN bit is set. This bit is cleared when the SCInt register is
read.
SCInt.5
VCCTMRI
VCC Timer – This bit is set when the VCCTMR times out. This bit is
cleared when the SCInt register is read.
SCInt.4
RXDAV
Rx Data Available – Data was received from the smart card because the
Rx FIFO is not empty. In bypass mode, this interrupt is generated on a
falling edge of the smart card I/O line. After receiving this interrupt in
bypass mode, firmware should disable it until the firmware has received
the entire byte and is waiting for the next start delimiter. This bit is
cleared when there is no RX data available in the RX FIFO.
SCInt.3
TXEVNT
TX Event – Set whenever the TXEMTY or TXFULL bits are set in the
SCInt.2
TXSENT
TX Sent – Set whenever the ISO UART has successfully transmitted a
byte to the smart card. Also set when a CRC/LRC byte is sent in T=1
mode. Will not be set in T=0 when a break is detected at the end of a
byte (when break detection is enabled). This bit is cleared when the
SCInt register is read.
SCInt.1
TXERR
TX Error – An error was detected during the transmission of data to the
smart card as indicated by either BREAKD or TXUNDR bit being set in
the STXCtl SFR. Additional information can be found in that register
description. This bit is cleared when the STXCtl register is read.
SCInt.0
RXERR
RX Error – An error was detected during the reception of data from the
smart card. Additional information can be found in the SRXCtl register.
This interrupt will be asserted for RXOVRR, or RX Parity error events.
This bit is cleared when the SRXCtl register is read.
90
Rev. 1.2
相關PDF資料 |
PDF描述 |
|---|---|
| 73S8010C-ILR/F | IC SMART CARD INTERFACE 28-SOIC |
| 73S8010R-ILR/F | IC SMART CARD INTERFACE 28-SOIC |
| 73S8014R-IL/F | IC SMART CARD 7816 EMV 20-SOIC |
| 73S8014RN-ILR/F | IC SMART CARD 7816 EMV 20-SOIC |
| 73S8023C-IMR/F | IC SMART CARD INTERFACE 32-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 73S1217F-EB | 功能描述:開發板和工具包 - 8051 73S1217F Eval Brd (Usb Cable, Doc. Cd) RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓: |
| 73S1217F-EB-Lite | 功能描述:開發板和工具包 - 8051 73S1217F EVB Lite w/Plug & Play/Usb RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓: |
| 73S1217F-IMR/F | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Bus-Powered 80515 System-on-Chip with USB, ISO 7816 / EMV, PINpad and More |
| 73S13B | 制造商:QUARTZCOM 制造商全稱:QUARTZCOM the communications company 功能描述:-20 ~ +70 °C commercia l application -30 ~ +75 °C on request |
| 73S5040G01X0A | 制造商:NEX Computers 功能描述:INTEL 40GB SSD - Bulk |
發布緊急采購，3分鐘左右您將得到回復。