參數資料
型號: AD5410AREZ
廠商: Analog Devices Inc
文件頁數: 10/32頁
文件大?。?/td> 0K
描述: IC DAC 12BIT 1CH SER 24TSSOP
產品培訓模塊: Data Converter Fundamentals
DAC Architectures
Weigh Scale Introduction
設計資源: Simplified 12-Bit, 4 mA-to-20 mA Output Solution Using AD5410 (CN0081)
標準包裝: 62
設置時間: 40µs
位數: 12
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
電壓電源: 模擬和數字
功率耗散(最大): 950mW
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 24-TSSOP(0.173",4.40mm)裸露焊盤
供應商設備封裝: 24-TSSOP 裸露焊盤
包裝: 管件
輸出數目和類型: 1 電流,單極
采樣率(每秒): *
產品目錄頁面: 782 (CN2011-ZH PDF)
AD5410/AD5420
Data Sheet
Rev. F | Page 18 of 32
where N is the total number of AD5410/AD5420 devices in the
chain. When the serial transfer to all devices is complete,
LATCH is taken high. This latches the input data in each device
in the daisy chain. The serial clock can be a continuous or a
gated clock.
A continuous SCLK source can be used only if LATCH is taken
high after the correct number of clock cycles. In gated clock
mode, a burst clock containing the exact number of clock cycles
must be used, and LATCH must be taken high after the final
clock to latch the data. See Figure 4 for a timing diagram.
CONTROLLER
DATA IN
LATCH
SDIN
SCLK
DATA OUT
SERIAL CLOCK
CONTROL OUT
SDO
LATCH
SCLK
SDO
LATCH
SCLK
SDO
SDIN
*ADDITIONAL PINS OMITTED FOR CLARITY.
AD5410/
AD5420*
AD5410/
AD5420*
AD5410/
AD5420*
07027-
035
Figure 39. Daisy Chaining the AD5410/AD5420
Readback Operation
Readback mode is invoked by setting the address byte and read
address as shown in Table 9 and Table 8 when writing to the
input shift register. The next write to the AD5410/AD5420
should be a NOP command, which clocks out the data from the
previously addressed register, as shown in Figure 3. By default,
the SDO pin is disabled. After having addressed the AD5410/
AD5420 for a read operation, a rising edge on LATCH enables
the SDO pin in anticipation of data being clocked out. After the
data has been clocked out on SDO, a rising edge on LATCH
disables (tristate) the SDO pin once again. To read back the
data register, for example, the following sequence should be
implemented:
1. Write 0x020001 to the AD5410/AD5420 input shift
register. This configures the part for read mode with the
data register selected.
2. Follow this with a second write, a NOP condition, 0x000000.
During this write, the data from the data register is clocked
out on the SDO line.
Table 8. Read Address Decoding
Read Address
Function
00
Read status register
01
Read data register
10
Read control register
Table 9. Input Shift Register Contents for a Read Operation
MSB
LSB
DB23
DB22
DB21
DB20
DB19
DB18
DB17
DB16
DB15 to DB2
DB1
DB0
0
1
0
Read address
1
X = don’t care.
相關PDF資料
PDF描述
VI-BNN-MV-F1 CONVERTER MOD DC/DC 18.5V 150W
VI-BNM-MV-F4 CONVERTER MOD DC/DC 10V 150W
VI-J44-MZ-F4 CONVERTER MOD DC/DC 48V 25W
VI-BNM-MV-F3 CONVERTER MOD DC/DC 10V 150W
VI-J42-MZ-F1 CONVERTER MOD DC/DC 15V 25W
相關代理商/技術參數
參數描述
AD5410AREZ-REEL7 功能描述:IC DAC 12BIT 1CH SER 24TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:8 電壓電源:單電源 功率耗散(最大):2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP(4x3) 包裝:管件 輸出數目和類型:8 電壓,單極 采樣率(每秒):*
AD5412 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power HART Modem
AD5412_09 制造商:AD 制造商全稱:Analog Devices 功能描述:Single Channel, 12-/16-Bit, Serial Input, Current Source and Voltage Output DACs
AD5412ACPZ 制造商:Analog Devices 功能描述:DAC 1-CH Segment 12-bit 40-Pin LFCSP EP
AD5412ACPZ-REEL 功能描述:IC DAC 12BIT SER 40-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:8 電壓電源:單電源 功率耗散(最大):2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP(4x3) 包裝:管件 輸出數目和類型:8 電壓,單極 采樣率(每秒):*