參數資料
型號: AD5755BCPZ-REEL7
廠商: Analog Devices Inc
文件頁數: 43/52頁
文件大小: 0K
描述: IC DAC 16BIT QUAD 64-LFCSP
視頻文件: AD5755: 16-Bit Multi-Channel, Voltage and Current Output DAC
標準包裝: 750
設置時間: 11µs
位數: 16
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 4
電壓電源: 模擬和數字,雙 ±
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 64-VFQFN 裸露焊盤,CSP
供應商設備封裝: 64-LFCSP-VQ(9x9)
包裝: 帶卷 (TR)
輸出數目和類型: 4 電流,4 電壓
采樣率(每秒): *
AD5755
Data Sheet
Rev. C | Page 48 of 52
separate ground plane, but separating the lines helps). It is
essential to minimize noise on the REFIN line because it
couples through to the DAC output.
Avoid crossover of digital and analog signals. Traces on
opposite sides of the board should run at right angles to each
other. This reduces the effects of feedthrough on the board. A
microstrip technique is by far the best but not always possible
with a double-sided board. In this technique, the component
side of the board is dedicated to ground plane, whereas signal
traces are placed on the solder side.
Layout—DC-to-DC Converters
To achieve high efficiency, good regulation, and stability, a well-
designed printed circuit board layout is required.
Follow these guidelines when designing printed circuit boards
Keep the low ESR input capacitor, CIN, close to AVCC and
PGND.
Keep the high current path from CIN through the inductor,
LDCDC, to SWX and PGND as short as possible.
Keep the high current path from CIN through LDCDC, the
rectifier, DDCDC, and the output capacitor, CDCDC, as short as
possible.
Keep high current traces as short and as wide as possible.
The path from CIN through the inductor, LDCDC, to SWX and
PGND should be able to handle a minimum of 1 A.
Place the compensation components as close as possible to
COMPDCDC_x.
Avoid routing high impedance traces near any node
connected to SWx or near the inductor to prevent radiated
noise injection.
GALVANICALLY ISOLATED INTERFACE
In many process control applications, it is necessary to provide
an isolation barrier between the controller and the unit being
controlled to protect and isolate the controlling circuitry from
any hazardous common-mode voltages that may occur. The
Analog Devices iCoupler products can provide voltage isolation
in excess of 2.5 kV. The serial loading structure of the AD5755
makes it ideal for isolated interfaces because the number of
interface lines is kept to a minimum. Figure 86 shows a 4-
channel isolated interface to the AD5755 using an ADuM1400.
For more information, visit www.analog.com.
VIA
SERIAL CLOCK
OUT
TO SCLK
VOA
ENCODE
DECODE
VIB
SERIAL DATA
OUT
TO SDIN
VOB
ENCODE
DECODE
VIC
SYNC OUT
VOC
ENCODE
DECODE
VID
CONTROL OUT
VOD
ENCODE
DECODE
MICROCONTROLLER
ADuM1400*
*ADDITIONAL PINS OMITTED FOR CLARITY.
TO SYNC
TO LDAC
07304-
081
Figure 86. Isolated Interface
相關PDF資料
PDF描述
AD5760BCPZ IC DAC VOLT OUT 16BIT 24LFCSP
AD5762RCSUZ-REEL7 IC DAC 16BIT QUAD VOUT 32-TQFP
AD5763CSUZ-REEL7 DAC 16BIT DUAL 5V 2LSB 32-TQFP
AD5764CSUZ IC DAC 16BIT QUAD VOUT 32TQFP
AD5764RBSUZ IC DAC 16BIT QUAD VOUT 32-TQFP
相關代理商/技術參數
參數描述
AD5755BCPZX 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad Channel, 16-Bit, Serial Input, 4-20mA & Voltage Output DAC, Dynamic Power Control
AD5757 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad Channel, 16-Bit,Serial Input, 4 mA to 20 mA Output DAC, Dynamic Power Control
AD5757_11 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad Channel, 16-Bit,Serial Input, 4 mA to 20 mA Output DAC, Dynamic Power Control
AD5757ACPZ 功能描述:IC DAC 16BIT QUAD 64-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行,SPI? 轉換器數目:1 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓,單極;1 電壓,雙極 采樣率(每秒):* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND
AD5757ACPZ-REEL7 功能描述:IC DAC 16BIT QUAD IOUT 64LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散(最大):100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC(J 形引線) 供應商設備封裝:28-PLCC(11.51x11.51) 包裝:帶卷 (TR) 輸出數目和類型:1 電壓,單極;1 電壓,雙極 采樣率(每秒):143k