- 您現在的位置：買賣IC網 > PDF目錄1986 > AD9510BCPZ-REEL7 (Analog Devices Inc)IC CLOCK DIST 8OUT PLL 64LFCSP PDF資料下載
參數資料
| 型號： | AD9510BCPZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 17/56頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLOCK DIST 8OUT PLL 64LFCSP |
| 標準包裝： | 750 |
| 類型： | 扇出緩沖器（分配），除法器 |
| PLL： | 是 |
| 輸入： | 時鐘 |
| 輸出： | CMOS，LVDS，LVPECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:8 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 1.2GHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 64-LFCSP-VQ（9x9） |
| 包裝： | 帶卷 (TR) |
| 配用： | AD9510-VCO/PCBZ-ND - BOARD EVALUATION FOR AD9510 AD9510/PCBZ-ND - BOARD EVALUATION FOR AD9510 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
AD9510
Data Sheet
Rev. B | Page 24 of 56
TERMINOLOGY
Phase Jitter and Phase Noise
An ideal sine wave has a continuous and even progression of
phase with time from 0 to 360 degrees for each cycle. Actual
signals, however, display a certain amount of variation from
ideal phase progression over time. This phenomenon is called
phase jitter. Although many causes can contribute to phase
jitter, one major cause is random noise, which is characterized
statistically as being Gaussian (normal) in distribution.
This phase jitter leads to a spreading out of the energy of the
sine wave in the frequency domain, producing a continuous
power spectrum. This power spectrum is usually reported as a
series of values whose units are dBc/Hz at a given offset in fre-
quency from the sine wave (carrier). The value is a ratio, expressed
in dB, of the power contained within a 1 Hz bandwidth with
respect to the power at the carrier frequency. For each measure-
ment, the offset from the carrier frequency is also given.
It is meaningful to integrate the total power contained within
some interval of offset frequencies (for example, 10 kHz to
10 MHz). This is called the integrated phase noise over that
frequency offset interval and can be readily related to the time
jitter due to the phase noise within that offset frequency interval.
Phase noise has a detrimental effect on the performance of
analog-to-digital converters (ADCs), digital-to-analog
converters (DACs), and signal input (RF) mixers. It lowers the
achievable dynamic range of the converters and mixers,
although they are affected in different ways.
Time Jitter
Phase noise is a frequency domain phenomenon. In the time
domain, the same effect is exhibited as time jitter. When observing
a sine wave, the time of successive zero crossings is seen to vary.
In a square wave, the time jitter is seen as a displacement of the
edges from their ideal (regular) times of occurrence. In both
cases, the variations in timing from the ideal are the time jitter.
Since these variations are random in nature, the time jitter is
specified in units of seconds root mean square (rms) or 1 sigma
of the Gaussian distribution.
Time jitter that occurs on a sampling clock for a DAC or an
ADC decreases the SNR and dynamic range of the converter.
A sampling clock with the lowest possible jitter provides the
highest performance from a given converter.
Additive Phase Noise
Additive phase noise is the amount of phase noise attributable
to the device or subsystem being measured. The phase noise of
any external oscillators or clock sources is subtracted. This
makes it possible to predict the degree to which the device
impacts the total system phase noise when used in conjunction
with the various oscillators and clock sources, each of which
contribute their own phase noise to the total. In many cases, the
phase noise of one element dominates the system phase noise.
Additive Time Jitter
Additive time jitter is the amount of time jitter attributable to
the device or subsystem being measured. The time jitter of any
external oscillators or clock sources is subtracted. This makes it
possible to predict the degree to which the device impacts the total
system time jitter when used in conjunction with the various
oscillators and clock sources, each of which contribute their
own time jitter to the total. In many cases, the time jitter of the
external oscillators and clock sources dominates the system
time jitter.
相關PDF資料 |
PDF描述 |
|---|---|
| AD9511BCPZ-REEL7 | IC CLOCK DIST 5OUT PLL 48LFCSP |
| AD9512UCPZ-EP-R7 | IC CLOCK DIST 5OUT PLL 48LFCSP |
| AD9512UCPZ-EP | IC CLOCK DIST 5OUT PLL 48LFCSP |
| AD9513BCPZ-REEL7 | IC CLOCK DIST 3OUT PLL 32LFCSP |
| AD9514BCPZ-REEL7 | IC CLOCK DIST 3OUT PLL 32LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9510-VCO/PCB | 制造商:Analog Devices 功能描述:EVAL BD FOR 1.2 GHZ CLOCK DISTRIBUTION IC, PLL CORE, DIVIDER - Bulk 制造商:Analog Devices 功能描述:IC ((NS)) |
| AD9510-VCO/PCBZ | 功能描述:BOARD EVALUATION FOR AD9510 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PSoC® 主要目的:電源管理，熱管理 嵌入式:- 已用 IC / 零件:- 主要屬性:- 次要屬性:- 已供物品:板，CD，電源 |
| AD9511 | 制造商:AD 制造商全稱:Analog Devices 功能描述:1.2 GHz Clock Distribution IC, PLL Core, Dividers, Delay Adjust, Five Outputs |
| AD9511/PCB | 制造商:Analog Devices 功能描述:1.2 GHZ CLOCK DISTRIBUTION IC, PLL CORE,DIVIDERS, DELAY ADJUST, FIVE OUTPUTS 制造商:Analog Devices 功能描述:EVAL BD FOR AD9511 1.2 GHZ CLOCK DISTRIBUTION IC, PLL CORE,D - Bulk |
| AD9511BCPZ | 功能描述:IC CLOCK DIST 5OUT PLL 48LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND |
發布緊急采購，3分鐘左右您將得到回復。