參數資料
型號: ADS1194CZXGT
廠商: TEXAS INSTRUMENTS INC
元件分類: 模擬信號調理
英文描述: SPECIALTY ANALOG CIRCUIT, PBGA64
封裝: 8 X 8 MM, GREEN, PLASTIC, NFBGA-64
文件頁數: 50/76頁
文件大?。?/td> 1193K
代理商: ADS1194CZXGT
Wcta
8:1MUX
WCT1[2:0]
IN4N
IN4P
IN3N
IN3P
IN2N
IN2P
WCT
IN1N
IN1P
Wctb
8:1MUX
WCT2[5:3]
Wctc
8:1MUX
WCT2[2:0]
ToChannel
PGAs
ADS1194/6/8
30kW
80pF
AVSS
SBAS471B
– APRIL 2010 – REVISED APRIL 2011
WILSON CENTER TERMINAL (WCT) AND CHEST LEADS
In the standard 12-lead ECG, WCT voltage is defined as the average of Right Arm (RA), Left Arm (LA), and Left
Leg (LL) electrodes. This voltage is used as the reference voltage for the measurement of the chest leads. The
ADS1194/6/8 has three integrated low-noise amplifiers that generate the WCT voltage. Figure 44 shows the
block diagram of the implementation.
Figure 44. WCT Voltage
The devices provide flexibility to choose any one of the eight signals (IN1P to IN4N) to be routed to each of the
amplifiers to generate the average. Having this flexibility allows the RA, LA, and LL electrodes to be connected to
any input of the first four channels depending on the lead configuration.
Each of the three amplifiers in the WCT circuitry can be powered down individually with register settings. By
powering up two amplifiers, the average of any two electrodes can be generated at the WCT pin. Powering up
one amplifier provides the buffered electrode voltage at the WCT pin. Note that the WCT amplifiers have limited
drive strength and thus should be buffered if used to drive a low-impedance load.
See Table 3 for performance when using any 1, 2, or 3 of the WCT buffers.
As can be seen in Table 3, the overall noise reduces when more than one WCT amplifier is powered up. This
noise reduction is due to the fact that noise is averaged by the passive summing network at the output of the
amplifiers. Powering down individual buffers gives negligible power savings because a significant portion of the
circuitry is shared between the three amplifiers. The bandwidth of the WCT node is limited by the RC network.
The internal summing network consists of three 30k
Ω resistors and a 80pF capacitor. It is recommended that an
external 100pF capacitor be added for optimal performance. The effective bandwidth depends on the number of
amplifiers that are powered up, as shown in Table 3.
The WCT node should be only be used to drive very high input impedances (typically greater than 500M
Ω).
Typical application would be to connect this WCT signal to the negative inputs of a ADS1194/6/8 to be used as a
reference signal for the chest leads.
54
Copyright
2010–2011, Texas Instruments Incorporated
Product Folder Link(s): ADS1194 ADS1196 ADS1198
相關PDF資料
PDF描述
ADS1251 "ResolutionPlus 24-Bit
ADS5102IPFBR 1.8-V ANALOG SUPPLY, 10-BIT, 65/40 MSPS ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE
ADS5103 "10 Bit
ADS5103CPFB 1.8-V ANALOG SUPPLY, 10-BIT, 65/40 MSPS ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE
ADS5103CPFBR 1.8-V ANALOG SUPPLY, 10-BIT, 65/40 MSPS ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE
相關代理商/技術參數
參數描述
ADS1194IPAG 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power 8-Channel 16-Bit Analog Front-End for Biopotential Measurements
ADS1194IPAGR 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power 8-Channel 16-Bit Analog Front-End for Biopotential Measurements
ADS1196 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power, 8-Channel, 24-Bit Analog Front-End for Biopotential Measurements
ADS1196CPAG 功能描述:模數轉換器 - ADC Low-Pwr6Ch16B Ana Front-End for ECG RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
ADS1196CPAG 制造商:Texas Instruments 功能描述:; Resolution (Bits):16bit; Sampling Rate 制造商:Texas Instruments 功能描述:IC, ADC, 6CH, 16BIT, 8KSPS, TQFP-64