參數資料
型號: ADUC7023BCP6Z62IRL
廠商: Analog Devices Inc
文件頁數: 15/96頁
文件大?。?/td> 0K
描述: IC MCU 12BIT 62KB FLASH 40LFCSP
標準包裝: 2,500
系列: MicroConverter® ADuC7xxx
核心處理器: ARM7
芯體尺寸: 16/32-位
速度: 44MHz
連通性: I²C,SPI
外圍設備: POR,PWM,WDT
輸入/輸出數: 20
程序存儲器容量: 64KB(32K x 16)
程序存儲器類型: 閃存
RAM 容量: 2K x 32
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 3.6 V
數據轉換器: A/D 12 x12b; D/A 4x12b
振蕩器型: 內部
工作溫度: -40°C ~ 125°C
封裝/外殼: 40-VFQFN 裸露焊盤,CSP
包裝: 帶卷 (TR)
ADuC7023
Data Sheet
| Page 22 of 96
MEMORY ORGANIZATION
The ADuC7023 incorporates two separate blocks of memory:
8 kB of SRAM and 64 kB of on-chip Flash/EE memory; 62 kB of
on-chip Flash/EE memory is available to the user, and the
remaining 2 kB are reserved for the factory configured boot
page. These two blocks are mapped as shown in Figure 16.
RESERVED
MMRs
0xFFFFFFFF
0x0008FFFF
0x00011FFF
0x0000FFFF
0x00000000
0x00010000
0x00080000
0xFFFF0000
RESERVED
FLASH/EE
(FLASH/EE OR SRAM)
REMAPPABLE MEMORY SPACE
SRAM
08
67
5-
00
9
Figure 16. Physical Memory Map
By default, after a reset, the Flash/EE memory is mirrored at
Address 0x00000000. It is possible to remap the SRAM at
Address 0x00000000 by clearing Bit 0 of the Remap MMR.
This remap function is described in more detail in the Flash/EE
Memory section.
MEMORY ACCESS
The ARM7 core sees memory as a linear array of the 232 byte
location where the different blocks of memory are mapped as
outlined in Figure 16.
The ADuC7023 memory organizations are configured in little
endian format, which means that the least significant byte is
located in the lowest byte address, and the most significant byte
is in the highest byte address.
0
86
75
-0
10
BIT 31
BYTE 2
A
6
2
.
BYTE 3
B
7
3
.
BYTE 1
9
5
1
.
BYTE 0
8
4
0
.
BIT 0
32 BITS
0xFFFFFFFF
0x00000004
0x00000000
Figure 17. Little Endian Format
FLASH/EE MEMORY
The total 64 kB of Flash/EE memory is organized as 32k × 16 bits;
31k × 16 bits is user space and 1 k × 16 bits is reserved for the
on-chip kernel. The page size of this Flash/EE memory is 512 bytes.
62 kilobytes of Flash/EE memory are available to the user as
code and nonvolatile data memory. There is no distinction
between data and program because ARM code shares the same
space. The real width of the Flash/EE memory is 16 bits, which
means that in ARM mode (32-bit instruction), two accesses to
the Flash/EE are necessary for each instruction fetch. It is,
therefore, recommended to use Thumb mode when executing
from Flash/EE memory for optimum access speed. The
maximum access speed for the Flash/EE memory is 41.78 MHz
in Thumb mode and 20.89 MHz in full ARM mode. More
details about Flash/EE access time are outlined later in the
SRAM
Eight kilobytes of SRAM are available to the user, organized as
2k × 32 bits, that is, two words. ARM code can run directly from
SRAM at 41.78 MHz, given that the SRAM array is configured
as a 32-bit wide memory array. More details about SRAM access
time are outlined later in the Execution Time from SRAM and
MEMORY MAPPED REGISTERS
The memory mapped register (MMR) space is mapped into the
upper two pages of the memory array and accessed by indirect
addressing through the ARM7 banked registers.
The MMR space provides an interface between the CPU and
all on-chip peripherals. All registers, except the core registers,
reside in the MMR area. All shaded locations shown in Figure 18
are unoccupied or reserved locations and should not be
accessed by user software. Table 10 to Table 23 show the full
MMR memory map.
The access time for reading from or writing to an MMR depends
on the advanced microcontroller bus architecture (AMBA) bus
used to access the peripheral. The processor has two AMBA
buses: advanced high performance bus (AHB) used for system
modules and advanced peripheral bus (APB) used for lower
performance peripheral. Access to the AHB is one cycle, and
access to the APB is two cycles. All peripherals on the ADuC7023
are on the APB except the Flash/EE memory and the GPIOs.
Rev. E
相關PDF資料
PDF描述
ADUC7023BCPZ62I-RL IC MCU 12BIT 62KB FLASH 32LFCSP
ATMEGA32L-8MUR MCU AVR 32K FLASH 8MHZ 44QFN
ATMEGA32-16MUR MCU AVR 32KB FLASH 16MHZ 44QFN
ADG528ATQ IC MULTIPLEXER 8X1 18CDIP
AD7511DIKNZ IC SWITCH QUAD SPST 16DIP
相關代理商/技術參數
參數描述
ADUC7023BCPZ62I 功能描述:IC MCU 12BIT 62KB FLASH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC7xxx 標準包裝:250 系列:LPC11Uxx 核心處理器:ARM? Cortex?-M0 芯體尺寸:32-位 速度:50MHz 連通性:I²C,Microwire,SPI,SSI,SSP,UART/USART,USB 外圍設備:欠壓檢測/復位,POR,WDT 輸入/輸出數:40 程序存儲器容量:96KB(96K x 8) 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-LQFP 包裝:托盤 其它名稱:568-9587
ADUC7023BCPZ62I-R7 功能描述:IC MCU 12BIT 62KB FLASH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC7xxx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
ADUC7023BCPZ62I-RL 功能描述:IC MCU 12BIT 62KB FLASH 32LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC7xxx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
ADUC7024 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision Analog Microcontroller 12-bit Analog I/O, ARM7TDMI MCU
ADUC7024BCP62 制造商:Analog Devices 功能描述:FLASH ARM7+10-CH,12-B ADC &2X12-B DAC IC - Trays