- 您現在的位置：買賣IC網 > PDF目錄366551 > AM79C973KCW (ADVANCED MICRO DEVICES INC) PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY PDF資料下載
參數資料
| 型號： | AM79C973KCW |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| 中文描述： | 5 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP16 |
| 封裝： | PLASTIC, QFP-160 |
| 文件頁數： | 64/304頁 |
| 文件大?。?/td> | 2092K |
| 代理商： | AM79C973KCW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁當前第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁第259頁第260頁第261頁第262頁第263頁第264頁第265頁第266頁第267頁第268頁第269頁第270頁第271頁第272頁第273頁第274頁第275頁第276頁第277頁第278頁第279頁第280頁第281頁第282頁第283頁第284頁第285頁第286頁第287頁第288頁第289頁第290頁第291頁第292頁第293頁第294頁第295頁第296頁第297頁第298頁第299頁第300頁第301頁第302頁第303頁第304頁
64
Am79C973/Am79C975
P R E L I M I N A R Y
Re-initialization may be done via the initialization block
or by setting the STOP bit in CSR0, followed by writing
to CSR15, and then setting the START bit in CSR0.
Note that this form of restart will not perform the same
in the Am79C973/Am79C975 controller as in the C-
LANCE device. In particular, upon restart, the
Am79C973/Am79C975 controller reloads the transmit
and receive descriptor pointers with their respective
base addresses. This means that the software must
clear the descriptor OWN bits and reset its descriptor
ring pointers before restarting the Am79C973/
Am79C975 controller. The reload of descriptor base
addresses is performed in the C-LANCE device only
after initialization, so that a restart of the C-LANCE
without initialization leaves the C-LANCE pointing at
the same descriptor locations as before the restart.
Suspend
The Am79C973/Am79C975 controller offers two sus-
pend modes that allow easy updating of the CSR reg-
isters without going through a full re-initialization of the
device. The suspend modes also allow stopping the
device with orderly termination of all network activity.
The host requests the Am79C973/Am79C975 control-
ler to enter the suspend mode by setting SPND (CSR5,
bit 0) to 1. The host must poll SPND until it reads back
1 to determine that the Am79C973/Am79C975 control-
ler has entered the suspend mode. When the host sets
SPND to 1, the procedure taken by the Am79C973/
Am79C975 controller to enter the suspend mode de-
pends on the setting of the fast suspend enable bit
(FASTSPND, CSR7, bit 15).
When a fast suspend is requested (FASTSPND is set
to 1), the Am79C973/Am79C975 controller performs a
quick entry into the suspend mode. At the time the
SPND bit is set, the Am79C973/Am79C975 controller
will continue the DMA process of any transmit and/or
receive packets that have already begun DMA activity
until the network activity has been completed. In addi-
tion, any transmit packet that had started transmission
will be fully transmitted and any receive packet that had
begun reception will be fully received. However, no ad-
ditional packets will be transmitted or received and no
additional transmit or receive DMA activity will begin
after network activity has ceased. Hence, the
Am79C973/Am79C975 controller may enter the sus-
pend mode with transmit and/or receive packets still in
the FIFOs or the SRAM. This offers a worst case sus-
pend time of a maximum length packet over the possi-
bility of completely emptying the SRAM. Care must be
exercised in this mode, because the entire memory
subsystem of the Am79C973/Am79C975 controller is
suspended. Any changes to either the descriptor rings
or the SRAM can cause the Am79C973/Am79C975
controller to start up in an unknown condition and could
cause data corruption.
When FASTSPNDE is 0 and the SPND bit is set, the
Am79C973/Am79C975 controller may take longer be-
fore entering the suspend mode. At the time the SPND
bit is set, the Am79C973/Am79C975 controller will
complete the DMA process of a transmit packet if it had
already begun and the Am79C973/Am79C975 control-
ler will completely receive a receive packet if it had al-
ready begun. The Am79C973/Am79C975 controller
will not receive any new packets after the completion of
the current reception. Additionally, all transmit packets
stored in the transmit FIFOs and the transmit buffer
area in the SRAM (if one is present) will be transmitted,
and all receive packets stored in the receive FIFOs and
the receive buffer area in the SRAM (if selected) will be
transferred into system memory. Since the FIFO and
the SRAM contents are flushed, it may take much
longer before the Am79C973/Am79C975 controller en-
ters the suspend mode. The amount of time that it
takes depends on many factors including the size of the
SRAM, bus latency, and network traffic level.
Upon completion of the described operations, the
Am79C973/Am79C975 controller sets the read-version
of SPND to 1 and enters the suspend mode. In sus-
pend mode, all of the CSR and BCR registers are ac-
cessible. As long as the Am79C973/Am79C975
controller is not reset while in suspend mode (by
H_RESET, S_RESET, or by setting the STOP bit), no
re-initialization of the device is required after the device
comes out of suspend mode. When SPND is set to 0,
the Am79C973/Am79C975 controller will leave the
suspend mode and will continue at the transmit and re-
ceive descriptor ring locations where it was when it en-
tered the suspend mode.
See the section on
Magic Packet
technology for de-
tails on how that affects suspension of the Am79C973/
Am79C975 controller.
Buffer Management
Buffer management is accomplished through message
descriptor entries organized as ring structures in mem-
ory. There are two descriptor rings, one for transmit and
one for receive. Each descriptor describes a single
buffer. A frame may occupy one or more buffers. If mul-
tiple buffers are used, this is referred to as buffer chain-
ing.
Descriptor Rings
Each descriptor ring must occupy a contiguous area of
memory. During initialization, the user-defined base
address for the transmit and receive descriptor rings,
as well as the number of entries contained in the de-
scriptor rings are set up. The programming of the soft-
ware style (SWSTYLE, BCR20, bits 7-0) affects the
way the descriptor rings and their entries are arranged.
When SWSTYLE is at its default value of 0, the de-
scriptor rings are backwards compatible with the
Am79C90 C-LANCE and the Am79C96x PCnet-ISA
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C975KCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C973VCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C975VCW | PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C976 | PCnet-PRO⑩ 10/100 Mbps PCI Ethernet Controller |
| AM79C976KIW | PCnet-PRO⑩ 10/100 Mbps PCI Ethernet Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C973VCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST III Single-Chip 10/100 Mbps PCI Ethernet Controller with Integrated PHY |
| AM79C974 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-SCSI Combination Ethernet and SCSI Controller for PCI Systems |
| AM79C974KC | 制造商:Advanced Micro Devices 功能描述: |
| AM79C974KC/W | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller |
發布緊急采購，3分鐘左右您將得到回復。