- 您現在的位置：買賣IC網 > PDF目錄67388 > AP603-F (TRIQUINT SEMICONDUCTOR INC) 800 MHz - 2200 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | AP603-F |
| 廠商： | TRIQUINT SEMICONDUCTOR INC |
| 元件分類： | 放大器 |
| 英文描述： | 800 MHz - 2200 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
| 封裝： | 6 X 5 MM, ROHS COMPLIANT, MO-229VJGC, SMT, DFN-14 |
| 文件頁數： | 15/20頁 |
| 文件大小： | 1165K |
| 代理商： | AP603-F |
AP603
High Dynamic Range 7W 28V HBT Amplifier
Load-Pull Data
Test condition: Output Power = 29.5 dBm, VCC = +28 V, ICQ = 160 mA, ZS = 50
Test signal = W-CDMA (PAR=8.6dB @ 0.01% Probability), 2140 MHz
The reference plane is at the AP603-PCB2140 eval board’s SMA connectors.
The plots are shown to detail the optimization of the ACLR performance.
Gain Load-Pull
ACLR Load-Pull
PAE Load-Pull
GAIN Max=13.08 dB at 76.9-j37.0
ACPR1LO Min=-50.98 dBc at 57.9-j2.6
P.A.EFF Max=16.98 % at 34.4-j49.7
Evaluation Board Bias Procedure
The following bias procedure is recommended to ensure proper functionality of AP603 in a laboratory environment. The sequencing is not
required in the final system application.
Bias.
Voltage (V)
Vcc
+28
Vbias
+5
Turn-on Sequence:
1.
Attach input and output loads onto the evaluation board.
2.
Turn on power supply Vcc = +28V. Pin_Vbias is connected to 28V supply through dropping resistor. At this point, the only
current drawn by the device is leakage current (< 25 μA).
3.
Turn on power supply Vpd = +5V. Power supply Vcc should now be drawing typical Icq = 165 mA.
4.
Turn on RF power.
Turn-off Sequence:
1.
Turn off RF power.
2.
Turn off power supply Vpd = +5V.
3.
Turn off power supply Vcc = +28V.
Notes:
1.
Icq can be adjusted with the resistor R2 from the Vpd (+5V) supply and the PIN_VPD (pin14) of the amplifier. Increasing R2 results in a lower
Icq. Icq should not be increased above 320 mA.
2.
Vpd is used as a reference for the internal active bias circuitry. It can be used to turn on/off the amplifier. Ipd depends on the Icq quiescent current
setting. Ipd can be up to 8mA at a quiescent current setting of 320mA.
3.
Ibias will change based on RF input power level. It can be up to 8mA on the AP603.
Ipd vs Icq
0
2
4
6
8
0
100
200
300
400
Icq Setting (mA)
Ip
d
(
m
A
)
Ibias vs Output Power
0
2
4
6
8
22
24
26
28
30
32
Output Average Power (dBm)
Ibia
s
(
m
A
)
Data Sheet: Rev A 07/02/11
-
4 of 20 -
Disclaimer: Subject to change without notice
2011 TriQuint Semiconductor, Inc.
Connecting the Digital World to the Global Network
相關PDF資料 |
PDF描述 |
|---|---|
| APDS-9120-020 | PROXIMITY SENSOR-PHOTOELECTRIC, 1.25-2.55V, SQUARE, SURFACE MOUNT |
| APM4220KAC-TRG | 13 A, 25 V, 0.009 ohm, N-CHANNEL, Si, POWER, MOSFET, MS-012BA |
| APS3603RS26Q1 | 50 MHz - 1000 MHz RF/MICROWAVE SPLITTER |
| APT-10566 | 4500 MHz - 10500 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
| APT18-2735 | 6000 MHz - 18000 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AP603-PCB1960 | 功能描述:射頻開發工具 1930-1990MHz Brd 12dB Gain RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| AP603-PCB2140 | 功能描述:射頻開發工具 2110-2170MHz Brd 12dB Gain RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| AP603-PCB900 | 功能描述:射頻開發工具 869-960MHz Eval Brd 17dB Gain RoHS:否 制造商:Taiyo Yuden 產品:Wireless Modules 類型:Wireless Audio 工具用于評估:WYSAAVDX7 頻率: 工作電源電壓:3.4 V to 5.5 V |
| AP604A-F | 功能描述:射頻放大器 AMP. 15W. 28V HBT RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| AP6050R | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PSU BENCH AUTO RANGE 1000W |
發布緊急采購，3分鐘左右您將得到回復。