參數資料
型號： AT42QT1110-AZ
廠商： ATMEL CORP
元件分類： 速度傳感器和接近開關
英文描述： PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT
封裝： 7 X 7 MM, 1 MM HEIGHT, 0.80 MM PITCH, ROHS COMPLIANT, PLASTIC, TQFP-32
文件頁數： 11/46頁
文件大小： 657K
代理商： AT42QT1110-AZ
19
9570I–AT42–03/10
AT42QT1110-MZ/AT42QT1110-AZ
4.8.2
Synchronized Trigger
In 11-key mode, if a time trigger is not enabled, the QT1110 operates in “synchronized” mode. In
this mode, SNS10K is used as a SYNC pin to trigger key acquisition, rather than using the
device’s internal clock. In this case the maximum number of keys is reduced to 10.
The SYNC pin can use one of two methods to trigger key measurements, selectable via bit 4 of
the Device Mode setup byte (see Section 7.4 on page 29): Low Level and Rising Edge.
With the Low Level method the QT1110 operates in “free run” mode for as long as the SYNC pin
is read as a logical “0”. When the SYNC pin goes high, the current measurement cycle will be
finished and no more key measurements will be taken until the SYNC pin goes low again.
The low level trigger should be a minimum of 1 ms so that there is sufficient time for the device
to detect the low level.
With the Rising Edge method all enabled keys are measured once when a rising edge is
detected on the SYNC pin. This allows key measurements to be synchronized to an external
event or condition.
For example, the SYNC pin can be used by the host to synchronize several devices to each
other. This would ensure that only one of the devices outputs pulses at any given time and
signals from one QT1110 do not interfere with the measurements from another.
Another use for synchronizing to the rising edge is to steady the signals when the device is
running off a mains transformer with insufficient mains frequency filtering that is causing a 50Hz
or 60Hz ripple on Vdd. If the mains voltage is scaled down with a simple voltage divider and
connected to the SYNC pin, then the key measurement can be triggered by the rising edge
detected at a positive going zero-crossing. Note that in this case, each key signal will be taken at
the same point in the cycle, so Vdd will be the same at each measurement for a given key and
the signals will be steadier.
4.9
Guard Channel Option
The device has a guard channel option (available in all key modes), which allows one key to be
configured as a guard channel to help prevent false detection (see Figure 4-9 on page 20).
Guard channel keys should be more sensitive than the other keys (physically bigger or larger
Cs), subject to burst length limitations (see Section 4.11.2 on page 21).
With guard channel enabled, the designated key is connected to a sensor pad which detects the
presence of touch and overrides any output from the other keys using the chip’s AKS feature.
The guard channel option is enabled by the Guard Key setup byte (see Section 7.5 on page 30).
With the guard channel not enabled, all the keys work normally.
Note:
If a key is already “in detect” when the guard channel becomes active, that key will
remain in detect and the guard key will not activate until the active key goes out of
detect.
相關PDF資料
PDF描述
AT42QT1110-MZ PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT
AT42QT1111-AU PROXIMITY SENSOR-CAPACITIVE, 0-5V, SQUARE, SURFACE MOUNT
AT76C453AC-MY19T IMAGE SENSOR-CMOS, 708(H) X 494(V) PIXEL, 30fps, SURFACE MOUNT
ATF-33143-TR2 X BAND, Si, N-CHANNEL, RF SMALL SIGNAL, HEMFET
ATF-33143-BLK X BAND, Si, N-CHANNEL, RF SMALL SIGNAL, HEMFET
相關代理商/技術參數
參數描述
AT42QT1110-MU 功能描述:電容觸摸傳感器 QTouch 11 Key Touch Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍:
AT42QT1110-MU QS470 功能描述:IC TOUCH SENSOR 11KEY 32QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:QTouch™ 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
AT42QT1110-MUR 功能描述:QTOUCH 11 KEY TOUCH SENSOR IC 制造商:microchip technology 系列:* 包裝:剪切帶（CT） 零件狀態:在售 封裝/外殼:32-VFQFN 裸露焊盤 供應商器件封裝:32-QFN（5x5） 標準包裝:1
AT42QT1110-MZ 功能描述:電容觸摸傳感器 QTouch 11 Key Touch Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍:
AT42QT1111-AU 功能描述:電容觸摸傳感器 QTouch 11 Key Touch Sensor IC RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*