- 您現在的位置：買賣IC網 > PDF目錄1908 > CC-2401K2A-CS (Copeland Communications Inc)MODEM 2400BAUD SECURE 3.3V PDF資料下載
參數資料
| 型號： | CC-2401K2A-CS |
| 廠商： | Copeland Communications Inc |
| 文件頁數： | 4/66頁 |
| 文件大?。?/td> | 0K |
| 描述： | MODEM 2400BAUD SECURE 3.3V |
| 標準包裝： | 30 |
| 數據格式： | V.21，V.22，V.23，Bell 103 |
| 波特率： | 2.4k |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 模塊 |
| 包裝： | 散裝 |
| 配用： | 539-1002-ND - KIT EVALUATION WORLD MODEM II |
| 其它名稱： | 539-1010 CC-2401K2A-CS-ND |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁
Data Sheet
CC-2401K2
Page 12 of 66
2007, Copeland Communications, Inc.
CC-2401K2 Datasheet Rev 1.5
If the host checks the voltage via LVS before initiating a call (or going off-hook for any reason), the modem can
be used to determine if another device is using the telephone line. One way to do this is to verify the voltage in
LVS is above a fixed threshold, such as 30V.
Off-Hook Intrusion Detection
Once a call has begun and the modem is in data mode, the serial port is used for modem data making it
difficult for the host to monitor registers. Therefore, when the modem is off-hook, an algorithm is implemented
to automatically monitor the TIP-RING loop current via the LCS register (SF3). Because the TIP-RING voltage
drops significantly when off-hook, TIP-RING current is a better indicator of another device using the phone
line. The LCS[7:0] bits have a resolution of 1.1mA per bit. An LCS register value of 0x00 indicates less than
the required loop current is present, and a value of 0xff indicates excessive current draw (> 120mA if ILIM = 0
or > 60mA if ILIM = 1). The user can read these bits directly through the LCS register. Upon detecting an
intrusion, an “I” result code is sent to the host if it is in the call negotiation stage or command mode.
Otherwise, the modem can be programmed to generate an interrupt to notify the host of the intrusion.
The off-hook intrusion algorithm monitors the value of LCS (SF3) at a sample rate determined by the DGSR
(SDF, bits 6:0) register (40 ms units). The algorithm compares each LCS sample to the reference value in the
ACL register (S12). If LCS is lower than ACL by an amount greater than DCL (S11, bits 4:0), the algorithm
waits for another LCS sample, and if the next LCS sample is also lower than ACL by an amount greater than
DCL, an interrupt occurs. This helps the modem avoid a false parallel phone detection (PPD) interrupt due to
glitches on the phone line. The ACL is continually updated with the value of LCS as outlined below. The
algorithm can be outlined as follows:
IF
LCS(t) = LCS(t – 40 ms x DGSR)
and
LCS(t) – ACL > DCL
THEN
ACL = LCS(t)
IF
(ACL – LCS[t – 40 ms x DGSR]) > DCL)
and
(ACL – LCS[t]) > DCL)
THEN
an intrusion interrupt is sent to the host.
The off-hook intrusion algorithm does not begin to operate immediately after going off-hook. This avoids
accidental interrupts occurring as a result of transients resulting from the modem itself going from on-hook to
off-hook. The time delay between the modem going off-hook and the start of the intrusion algorithm is about 1
second. This can be adjusted using the IST register (S82, bits 7:4).
The off-hook intrusion algorithm may also be disabled for a period of time after dialing begins via the IB
register (S82, bits 2:1). This avoids triggering an interrupt due to pulse dialing, open-switch intervals or line
transients from central office switching. Intrusion can be disabled from the start of dialing to the end of dialing
(IB = Dib), from the start of dialing to the timeout of the IS (S29, bits 7:0) by setting IB = 11. The off-hook
intrusion algorithm is only suspended (not disabled) during this IB interval and sustains through the end of the
interval triggers a PPD interrupt.
Interrupt Detection
The interrupt pin (pin 55) can be programmed to alert the host of loss-of-carrier, loss-of-phone-line
voltage/current, parallel phone detection, and other interrupts listed in the interrupt status mask (S08). After
the host receives an interrupt via the INT# pin, the host should issue the AT:I command. This command
causes a read-clear of the WOR, PPD, NLD, RI, OCD, and REV bits of the S09 register and raises
(deactivates) the INT# pin. All the interrupt status bits in the register S09 remain high after being set until
cleared by the AT:I command.
Loop Current Detection
The CC-2401 can monitor the loss of loop current. This feature can be enabled by setting S08[4] (NLDM) = 1.
This feature is disabled by default. If the loop current is too low for normal DAA operation, S09[4] (NLD) is set.
相關PDF資料 |
PDF描述 |
|---|---|
| CC-2434K2-CS5 | MODEM FAX 33K 5V |
| CC-24K2N-CS5 | MODEM WORLD NET 2400BAUD 5V |
| CC-92K2-IS | MODEM 56KBAUD V.90 SERIAL 3.3V |
| CC-MX-LB69-ZM | CONNECTCORE I.MX51 MODULE |
| CD22M3494MQZ96 | IC CROSSPOINT SWITCH 16X8 44PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CC-2401K2A-CS5 | 功能描述:MODEM 2400BAUD SECURE 5V RoHS:否 類別:集成電路 (IC) >> 接口 - 調制解調器 - IC 和模塊 系列:- 標準包裝:25 系列:- 數據格式:V.21，V.22，V.23，V.29，V.32，V.34，V.90，V.92，Bell 103，Bell 212A 波特率:33.6k 電源電壓:3.3V 安裝類型:- 封裝/外殼:- 供應商設備封裝:- 包裝:托盤 配用:591-1013-ND - KIT DEV SOCKETMODEM PARALLEL591-1009-ND - KIT DEV SRL SOCKETMODEM UNIVERSL 其它名稱:MT5656SMI-P-V-34.R2-SPMT5656SMI-P-V-34.R2-SP-NDQ4711574 |
| CC24020N | 制造商:POWEREX 制造商全稱:Powerex Power Semiconductors 功能描述:Super Fast Recovery Dual Diode Modules 20 Amperes/300-600 Volts |
| CC2403020N | 制造商:POWEREX 制造商全稱:Powerex Power Semiconductors 功能描述:Super Fast Recovery Dual Diode Modules 20 Amperes/300-600 Volts |
| CC2403500N | 制造商:POWEREX 制造商全稱:Powerex Power Semiconductors 功能描述:Super Fast Recovery Dual Diode Modules 50 Amperes/300-600 Volts |
| CC-2404K2A-CS | 功能描述:MODEM 2400BAUD SERIAL 3.3V RoHS:否 類別:集成電路 (IC) >> 接口 - 調制解調器 - IC 和模塊 系列:- 標準包裝:25 系列:- 數據格式:V.21，V.22，V.23，V.29，V.32，V.34，V.90，V.92，Bell 103，Bell 212A 波特率:33.6k 電源電壓:3.3V 安裝類型:- 封裝/外殼:- 供應商設備封裝:- 包裝:托盤 配用:591-1013-ND - KIT DEV SOCKETMODEM PARALLEL591-1009-ND - KIT DEV SRL SOCKETMODEM UNIVERSL 其它名稱:MT5656SMI-P-V-34.R2-SPMT5656SMI-P-V-34.R2-SP-NDQ4711574 |
發布緊急采購，3分鐘左右您將得到回復。