- 您現在的位置：買賣IC網 > PDF目錄378517 > CYWUSB6935 (Cypress Semiconductor Corp.) WirelessUSB LR 2.4-GHz DSSS Radio SoC(WirelessUSB LR 2.4-GHz DSSS無線SoC) PDF資料下載
參數資料
| 型號： | CYWUSB6935 |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | WirelessUSB LR 2.4-GHz DSSS Radio SoC(WirelessUSB LR 2.4-GHz DSSS無線SoC) |
| 中文描述： | 的WirelessUSB LR 2.4 GHz的無線擴頻系統芯片（的WirelessUSB LR 2.4 GHz的無線擴頻芯片） |
| 文件頁數： | 8/32頁 |
| 文件大?。?/td> | 395K |
| 代理商： | CYWUSB6935 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
CYWUSB6935
Document #: 38-16008 Rev. *D
Page 8 of 32
Addr: 0x00
REG_ID
Default: 0x07
7
6
5
4
3
2
1
0
Silicon ID
Product ID
Figure 7-1. Revision ID Register
Bit
Name
Description
7:4
Silicon ID
These are the Silicon ID revision bits. 0000 = Rev A, 0001 = Rev B, etc. These bits are read-only.
3:0
Product ID
These are the Product ID revision bits. Fixed at value 0111. These bits are read-only.
Addr: 0x03
REG_CONTROL
Default: 0x00
7
6
5
4
3
2
1
0
RX
Enable
TX
Enable
PN Code
Select
Bypass Internal
Syn Lock
Signal
Auto Internal
PA
Disable
Internal PA
Enable
Reserved
Reserved
Figure 7-2. Control
Bit
Name
Description
7
RX Enable
The Receive Enable bit is used to place the IC in receive mode.
1 = Receive Enabled
0 = Receive Disabled
6
TX Enable
The Transmit Enable bit is used to place the IC in transmit mode.
1 = Transmit Enabled
0 = Transmit Disabled
5
PN Code
Select
The Pseudo-Noise Code Select bit selects between the upper or lower half of the 64 chips/bit PN code.
1 = 32 Most Significant Bits of PN code are used
0 = 32 Least Significant Bits of PN code are used
This bit applies only when the Code Width bit is set to 32 chips/bit PN codes (Reg 0x04, bit 2=1).
4
Bypass
Internal Syn
Lock Signal
This bit controls whether the state machine waits for the internal Syn Lock Signal before waiting for the amount of time
specified in the Syn Lock Count register (Reg 0x38), in units of 2
μ
s. If the internal Syn Lock Signal is used then set
Syn Lock Count to 25 to provide additional assurance that the synthesizer has settled.
1 = Bypass the Internal Syn Lock Signal and wait the amount of time in Syn Lock Count register (Reg 0x38)
0 = Wait for the Syn Lock Signal and then wait the amount of time specified in Syn Lock Count register (Reg 0x38)
It is recommended that the application MCU sets this bit to 1 in order to guarantee a consistent settle time for the
synthesizer.
3
Auto Internal
PA Disable
The Auto Internal PA Disable bit is used to determine the method of controlling the Internal Power Amplifier. The two
options are automatic control by the baseband or by firmware through register writes. For external PA usage, please
see the description of the REG_ANALOG_CTL register (Reg 0x20).
1 = Register controlled Internal PA Enable
0 = Auto controlled Internal PA Enable
When this bit is set to 1, the enabled state of the Internal PA is directly controlled by bit Internal PA Enable (Reg 0x03,
bit 2). It is recommended that this bit is set to 0, leaving
the PA control to the baseband.
The Internal PA Enable bit is used to enable or disable the Internal Power Amplifier.
1 = Internal Power Amplifier Enabled
0 = Internal Power Amplifier Disabled
This bit only applies when the Auto Internal PA Disable bit is selected (Reg 0x03, bit 3=1), otherwise this bit is don’t care.
2
Internal PA
Enable
1
Reserved
This bit is reserved and should be written with a zero.
0
Reserved
This bit is reserved and should be written with a zero.
相關PDF資料 |
PDF描述 |
|---|---|
| CZA1414P | Video Switch Compatible With IIC Bus(IIC總線控制的視頻轉換芯片) |
| D-BY228G | Automotive Low-Cost Non-Volatile FPGA Family; Voltage: 1.2V; Grade: -5; Package: Lead-Free TQFP; Pins: 144; Temperature: AUTO; LUTs (k): 8 |
| D-BYW36 | Fast Silicon Rectifiers Schnelle Si-Gleichrichter |
| D-BYW38 | Fast Silicon Rectifiers Schnelle Si-Gleichrichter |
| D0201YR | DIAC (BIDIRECTIONAL DIODE THYRISTOR)|32V V(BO) MAX|50UA I(S)|DO-204AH |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CYWUSB6935_10 | 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:WirelessUSBa?￠ LR 2.4 GHz DSSS Radio SoC |
| CYWUSB6935-28SEI | 功能描述:IC WIRELESS USB 2.4GHZ 28-SOIC RoHS:否 類別:RF/IF 和 RFID >> RF 收發器 系列:WirelessUSB™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:30 系列:- 頻率:4.9GHz ~ 5.9GHz 數據傳輸率 - 最大:54Mbps 調制或協議:* 應用:* 功率 - 輸出:-3dBm 靈敏度:- 電源電壓:2.7 V ~ 3.6 V 電流 - 接收:* 電流 - 傳輸:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 工作溫度:-25°C ~ 85°C 封裝/外殼:68-TQFN 裸露焊盤 包裝:管件 |
| CYWUSB6935-48LFI | 功能描述:IC USB WIRELESS 2.4GHZ 48VQFN RoHS:否 類別:RF/IF 和 RFID >> RF 收發器 系列:WirelessUSB™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:30 系列:- 頻率:4.9GHz ~ 5.9GHz 數據傳輸率 - 最大:54Mbps 調制或協議:* 應用:* 功率 - 輸出:-3dBm 靈敏度:- 電源電壓:2.7 V ~ 3.6 V 電流 - 接收:* 電流 - 傳輸:* 數據接口:PCB，表面貼裝 存儲容量:- 天線連接器:PCB，表面貼裝 工作溫度:-25°C ~ 85°C 封裝/外殼:68-TQFN 裸露焊盤 包裝:管件 |
| CYWUSB6935-48LFXC | 功能描述:射頻接收器 Tranciever COM RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| CYWUSB6935-48LFXI | 功能描述:射頻接收器 Tranciever IND RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。