DM9331
100 Mbps Twisted Pair/Fiber Ethernet Media Converter Chip
6
Preliminary
Version: DM9331-DS-P02
September 21, 2001
Pin Description
I : Input, O : Output, LI : Latch input when power-up/reset, Z : Tri-State output, U : Pull-up
D : Pull-down
Media converter interface, 18 pins
Pin No.
14
Pin Name
TPFAULT
I/O
O
Description
Twisted Pair Fault
0 = Twisted pair link fault.
1 = Twisted pair normal work.
Link Fault Propagation
0 = Link fault propagation is active.
1 = normal operation.
Link Fault Propagation Enable
0 = Link fault propagation disable.
1 = Link fault propagation enable
17
LNKFAULT#
I
18
LNKFAULTEN
I
20,19
TXD[0:1]
I
Transmit Data
2-bit data inputs (synchronous to the 50MHz OSCIN).
Transmit Enable
Active high indicates the presence of valid data on the TXD[0:1] for
100Mbps mode
Transmit Clock
25MHz transmit clock.
Management Data Clock
Synchronous clock for the MDIO management data. This clock is
provided by management entity, and it is up to 2.5MHz
Management Data I/O
Bi-directional management data that may be provided by the station
management entity or the PHY.
Fiber Fault
0 = Fiber link fault; Fiber receive far end fault package or fiber
disconnect.
1 = Fiber normal work.
TPSET1 (reset latch input)
0 = Fiber mode; default pull low.
1 = Twisted pair mode; need 4.7k
resistor to pull high.
Twisted Pair set (reset latch input)
0 = Fiber mode; default pull low.
1 = Twisted pair mode; need 4.7k
resistor to pull high.
Receive Data Output
2-bit data outputs (synchronous to the 50MHz OSCIN )
21
TXEN
I
22
TXCLK
O
24
MDC
I
25
MDIO
I/O
26
FXFAULT/
TPSET1
O,Z
,LI
(D)
27
TPSET0
Z,LI
(D)
29,28
RXD[0:1]
O,Z
,LI
(D)
O, Z Status Interrupt Output:
Asserted low whenever there is a status change (link, speed, duplex).
The MDINTR# pin has a high impedance output, a 2.2K
Ω
pull-high
resistor is needed.
32
MDINTR#