- 您現在的位置：買賣IC網 > PDF目錄9381 > ISL12082IB8Z (Intersil)IC RTC I2C LO-POWER 8-SOIC PDF資料下載
參數資料
| 型號： | ISL12082IB8Z |
| 廠商： | Intersil |
| 文件頁數： | 15/26頁 |
| 文件大小： | 0K |
| 描述： | IC RTC I2C LO-POWER 8-SOIC |
| 標準包裝： | 980 |
| 類型： | 時鐘/日歷 |
| 特點： | 警報器，閏年，監視計時器 |
| 時間格式： | HH:MM:SS:hh（12/24 小時） |
| 數據格式： | YY-MM-DD-dd |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 電壓 - 電源，電池： | 1.8 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
22
FN6731.3
November 24, 2008
Application Section
Oscillator Crystal Requirements
The ISL12082 uses a standard 32.768kHz crystal. Either
through hole or surface mount crystals can be used. Table
15 lists some recommended surface mount crystals and the
parameters of each. This list is not exhaustive and other
surface mount devices can be used with the ISL12082 if
their specifications are very similar to the devices listed.
The crystal should have a required parallel load capacitance
of 12.5pF and an equivalent series resistance of <50k. The
crystal’s temperature range specification should match the
application. Many crystals are rated for -10°C to +60°C
(especially through-hole and tuning fork types), so an
appropriate crystal should be selected if extended
temperature range is required.
Crystal Oscillator Frequency Adjustment
The ISL12082 device contains circuitry for adjusting the
frequency of the crystal oscillator. This circuitry can be used
to trim oscillator initial accuracy as well as adjust the
frequency to compensate for temperature changes.
The Analog Trimming Register (ATR) is used to adjust the
load capacitance seen by the crystal. There are 6 bits of ATR
control, with linear capacitance increments available for
adjustment. Since the ATR adjustment is essentially “pulling”
the frequency of the oscillator, the resulting frequency
changes will not be linear with incremental capacitance
changes. The equations which govern pulling show that
lower capacitor values of ATR adjustment will provide larger
increments. Also, the higher values of ATR adjustment will
produce smaller incremental frequency changes. These
values typically vary from 6ppm to 10ppm/bit at the low end
to <1ppm/bit at the highest capacitance settings. The range
afforded by the ATR adjustment with a typical surface mount
crystal is typically -34ppm to +80ppm around the ATR = 0
default setting because of this property. The user should
note this when using the ATR for calibration. The
temperature drift of the capacitance used in the ATR control
is extremely low, so this feature can be used for temperature
compensation with good accuracy.
In addition to the analog compensation afforded by the
adjustable load capacitance, a digital compensation feature is
available for the ISL12082. There are 6 bits known as the
Digital Trimming Register (DTR). The range provided is
63.0696ppm to +126.139ppm. DTR operates by adding or
skipping pulses in the clock counter. It is very useful for coarse
adjustments of frequency drift over-temperature or extending
the adjustment range available with the ATR register.
Initial accuracy is best adjusted by enabling the frequency
output (using the INT register, address 08h), and monitoring
the ~IRQ/fOUT pin with a calibrated frequency counter. The
frequency used is unimportant, although 1Hz is the easiest
to monitor. The gating time should be set long enough to
ensure accuracy to at least 1ppm. The ATR should be set to
the center position, or 100000Bh, to begin with. Once the
initial measurement is made, then the ATR register can be
changed to adjust the frequency. Note that increasing the
ATR register for increased capacitance will lower the
frequency, and vice-versa. If the initial measurement shows
the frequency is far off, it will be necessary to use the DTR
register to do a coarse adjustment. Also, note that most all
crystals will have tight enough initial accuracy at room
temperature so that a small ATR register adjustment should
be all that is needed.
Temperature Compensation
The ATR and DTR controls can be combined to provide
crystal drift temperature compensation. The typical
32.768kHz crystal has a drift characteristic that is similar to
that shown in Figure 17. There is a turnover-temperature
(T0) where the drift is very near zero. The shape is parabolic
as it varies with the square of the difference between the
actual temperature and the turnover-temperature.
If full industrial temperature compensation is desired in an
ISL12082 circuit, then both the DTR and ATR registers will
need to be utilized (total correction range = -97ppm to
+206ppm).
A system to implement temperature compensation would
consist of the ISL12082, a temperature sensor, and a micro
controller. These devices may already be in the system so
TABLE 15. SUGGESTED SURFACE MOUNT CRYSTALS
MANUFACTURER
PART NUMBER
Citizen
CM200S
Epson
MC-405, MC-406
Raltron
RSM-200S
SaRonix
32S12
Ecliptek
ECPSM29T-32.768K
ECS
ECX-306
Fox
FSM-327
TEMPERATURE (°C)
-160
-140
-120
-100
-80
-60
-40
-20
0
-40 -30 -20 -10 0 10 2030 40 50 607080
PPM
FIGURE 17. RTC CRYSTAL TEMPERATURE DRIFT
ISL12082
相關PDF資料 |
PDF描述 |
|---|---|
| VI-JVJ-MZ | CONVERTER MOD DC/DC 36V 25W |
| AD5114BCPZ80-500R7 | IC DGTL POT 32POS 80K 8LFCSP |
| VI-JV4-MZ | CONVERTER MOD DC/DC 48V 25W |
| ISL12026AIVZ-T | IC RTC/CALENDAR EEPROM 8-TSSOP |
| VE-J0B-MZ | CONVERTER MOD DC/DC 95V 25W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL12082IB8Z-T | 功能描述:實時時鐘 LW PWR RTC W/ALARM & TIMR FUNCTIONS 8LD RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12082IUZ | 功能描述:實時時鐘 RTC W/RESEAL ALARM & TIMR FUNCTNS IN MSO RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL12082IUZ-T | 功能描述:實時時鐘 RTC W/RESEAL ALARM & TIMR FUNCTNS IN MSO RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| ISL1208EVAL | 功能描述:電源管理IC開發工具 EVALRD FOR ISL1208 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| ISL1208IB8 | 功能描述:IC RTC/CALENDAR I2C 8-SOIC RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 實時時鐘 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:時鐘/日歷 特點:警報器，閏年，SRAM 存儲容量:- 時間格式:HH:MM:SS（12/24 小時） 數據格式:YY-MM-DD-dd 接口:SPI 電源電壓:2 V ~ 5.5 V 電壓 - 電源，電池:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN EP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。