- 您現在的位置：買賣IC網 > PDF目錄1932 > KSZ8893FQL (Micrel Inc)IC SWITCH FAST ETH 3PORT 128PQFP PDF資料下載
參數資料
| 型號： | KSZ8893FQL |
| 廠商： | Micrel Inc |
| 文件頁數： | 37/117頁 |
| 文件大小： | 0K |
| 描述： | IC SWITCH FAST ETH 3PORT 128PQFP |
| 標準包裝： | 66 |
| 控制器類型： | 以太網開關控制器 |
| 接口： | MII，RMII，SNI |
| 電源電壓： | 3.1 V ~ 3.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 128-BFQFP |
| 供應商設備封裝： | 128-PQFP（14x20） |
| 包裝： | 托盤 |
| 配用： | 576-1603-ND - EVAL KIT EXPERIMENTAL KSZ8893MQL |
| 其它名稱： | 576-1565 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁
Micrel, Inc.
KSZ8893FQL
October 2007
26
M9999-101607-1.3
Dedicated TS-1000 Registers & Pins
The KSZ8893FQL provides 32 dedicated registers to support TS-1000 OAM communication in center MC and terminal
MC modes. The TS-1000 MC registers are located at 64 to 95 (0x40 to 0x5F), and provide the following functions:
PHY address configuration
Center MC and Terminal MC configuration
OAM frame selection and execution
MC loop back setup
MC loop back counters for CRC error, timeout, good packet
Remote command access
Counters for valid MC packet transmitted and received
MC (local) - status, vendor code, and model number
Link Partner (remote) - status, vendor code, and model number
The following table lists the dedicated KSZ8893FQL pins used in center MC and terminal MC modes.
Pin
Signal Name
Type
Description
9
MCHS
Ipd
10
MCCS
Ipd
Selects center MC and terminal MC modes. See “Media Converter
Modes” subsection for details.
11
PDD#
Ipu
Power Down Detect – Use by terminal MC to detect a power-down
condition or indicate a failure has occurred.
1 = Normal operation
0 = Power down detected
After detecting a high-to-low transition on this pin, the KSZ8893FQL then
sends out an “Indicate Terminal MC Condition” OAM frame with the S0
status bit set to ‘1’ to inform the center MC that a power down condition
or failure has occurred on the terminal MC side.
If this pin is implemented, PWRDN (pin 36) needs to be de-asserted
(pulled up).
17
P1FST
Opu
Drives low to indicate fault conditions (far-end fault detected, link
partner’s fiber or UTP port down), or MC loop back mode. This pin has
8mA drive and can directly drive a LED.
18
P1CRCD
Ipd
Used by terminal MC for MC loop back – strap-in pin to select:
1 = Drop OAM frames and Ethernet frames with the following errors –
CRC, undersize, oversize. Loop back Ethernet frames with only good
CRC and valid length.
0 = Drop OAM frames only. Loop back all Ethernet frames including
those with errors.
19
P1LPBM
Ipd
Used by terminal MC for MC loop back – strap-in pin to select:
1 = Perform MC loop back at PHY of port 1
0 = Perform MC loop back at MAC of port 2
See also register 11 (0x0B) bits[3:2].
34
ML_EN
Ipd
Used by terminal MC for Missing Link Indication – strap-in pin to select:
1 = Enable Missing Link feature
0 = Disable Missing Link feature
35
DIAGF
Ipd
Used by terminal MC for Diagnostic status
1 = Diagnostic fail
0 = Diagnostic normal
After detecting a change of state on this pin, the KSZ8893FQL sends out
an “Indicate Terminal MC Condition” OAM frame with the S3 status bit
set to the state of this pin to inform the center MC that a diagnostic status
change has occurred on the terminal MC side.
Table 2. Dedicated TS-1000 Pins
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8895MQI | IC ETHERNET SWITCH 5PORT 128PQFP |
| KSZ8895MQ | IC ETHERNET SW 5PORT 128-PQFP |
| KSZ8993FL | IC CONV MED 10/100 SGL 128PQFP |
| KSZ8993MLI | IC SWITCH 10/100 3PORT 128-PQFP |
| KSZ8993ML | IC SWITCH 10/100 W/TXRX 128PQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8893FQL-EVAL | 功能描述:以太網開發工具 2+1 Port 10/100 Switch w/Tranceivers & Frame Buffers - Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ8893FQL-FX | 功能描述:以太網 IC 2+1 Port 10/100 Switch w/Tranceivers & Frame Buffers, (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8893FQLI-FX | 功能描述:以太網 IC 3-Port Ethernet Switch w MII/RMII Interface + 100FX (I-Temp, Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8893MBL | 功能描述:以太網 IC 2+1 Port 10/100 Switch w/Tranceivers & Frame Buffers, 128-Ld PQFP(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8893MBL TR | 功能描述:以太網 IC 2+1 Port 10/100 Switch w/Tranceivers & Frame Buffers, 100-Ball LFBGA (Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。