參數資料
型號: LU6612-T64-DB
英文描述: LU6612 FASTCAT TM Single-FET for 10Base-T/100Base-TX
中文描述: LU6612 FASTCAT商標單的10BASE-T/100BASE-TX快速以太網場效應管
文件頁數: 22/36頁
文件大?。?/td> 528K
代理商: LU6612-T64-DB
LU6612
FASTCAT Single-FET for 10Base-T/100Base-TX
Data Sheet
July 2000
22
Lucent Technologies Inc.
MII Station Management
(continued)
Table 19. MR30—Device-Specific Register 3 (10 Mbits/s Control) Bit Descriptions
1. Note that the format for the pin descriptions is as follows: the first number is the register number, the second number is the bit position in the
register, and the name of the instantiated pad is in capital letters.
2. R = read, W = write.
Bit
1
Type
2
R/W
R/W
Description
30.15:6 (R30[15:6])
30.5 (HBT_EN)
Unused.
Read as 0.
Heartbeat Enable.
When this bit is a 1, the heartbeat function will be
enabled. Valid in 10 Mbits/s mode only. The default is 0.
Extended Line Length Enable.
When this bit is a 1, the receive squelch lev-
els are reduced from a nominal 435 mV to 350 mV, allowing reception of sig-
nals with a lower amplitude. Valid in 10 Mbits/s mode only. The default is 0.
Autopolarity Function Enable.
When this bit is a 1 and the LU6612 is in
10 Mbits/s mode, the autopolarity function will determine if the TP link is wired
with a polarity reversal. If there is a polarity reversal, the LU6612 will assert
the APS bit (register 28, bit 6) and correct the polarity reversal. If this bit is a 0
and the device is in 10 Mbits/s mode, the reversal will not be corrected. The
default is 0.
Reference Select.
When this bit is a 1, the external 10 MHz reference of pin
REF10 is used for phase alignment. This bit defaults to a 0.
Serial Select.
When this bit is set to a 1, 10 Mbits/s serial mode will be
selected. When the LU6612 is in 100 Mbits/s mode, this bit will be ignored.
The default is 0.
No Link Partner Mode.
Setting this bit to a 1 will allow 10 Mbits/s operation
with link pulses disabled. If the LU6612 is configured for 100 Mbits/s opera-
tion, setting this bit will not affect operation. The default is 0.
30.4 (ELL_EN)
R/W
30.3 (APF_EN)
R/W
30.2 (REF_SEL)
R/W
30.1 (SERIAL _SEL)
R/W
30.0 (ENA_NO_LP)
R/W
相關PDF資料
PDF描述
LU6612 Single-FET for 10Base-T/100Base-TX(應用于10基數-T和100基數-TX 的單快速以太網收發器)
LU6X14FT Telecommunication IC
LU97 Telecommunication IC
LUC3X01 LAN Transceiver
LUCDA4044 Phase Frequency Detector
相關代理商/技術參數
參數描述
LU67 制造商:Thomas & Betts 功能描述:2 CONDUIT BODY,GRAY IRON,LU,F-7
LU670Z 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED
LU671 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:RED OVAL LAMP LED
LU680Z 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED
LU681 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:BLUE OVAL LAMP LED