參數資料
型號： MB90F395HAPMT
廠商： FUJITSU LTD
元件分類： 微控制器/微處理器
英文描述： 16-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP120
封裝： 16 X 16 MM, 1.70 MM HEIGHT, 0.50 MM PITCH, PLASTIC, LQFP-120
文件頁數： 37/72頁
文件大小： 1734K
代理商： MB90F395HAPMT
42
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
M37272M6/M8–XXXSP/FP, M37272MA–XXXSP
M37272E8SP/FP, M37272EFSP
MITSUBISHI MICROCOMPUTERS
Rev. 1.3
8.7 PWM OUTPUT FUNCTION
This microcomputer is equipped with six 8-bit PWMs (PWM0–
PWM5). PWM0–PWM5 have the same circuit structure and an 8-bit
resolution with minimum resolution bit width of 4
s (for f(XIN) = 8
MHz) and repeat period of 1024
s (for f(XIN) = 8 MHz).
Figure 8.7.1 shows the PWM block diagram. The PWM timing gen-
erating circuit applies individual control signals to PWM0–PWM5 us-
ing f(XIN) divided by 2 as a reference signal.
8.7.1 Data Setting
When outputting PWM0–PWM5, set 8-bit output data to the PWMi
register (i means 0 to 5; addresses 020016 to 020516).
8.7.2 Transmitting Data from Register to PWM
circuit
Data transfer from the 8-bit PWM register to the 8-bit PWM circuit is
executed at writing data to the register.
The signal output from the 8-bit PWM output pin corresponds to the
contents of this register.
8.7.3 Operating of 8-bit PWM
The following explains PWM operation.
First, set the bit 0 of PWM mode register 1 (address 020816) to “0”
(at reset, bit 0 is already set to “0” automatically), so that the PWM
count source is supplied.
PWM0–PWM5 are also used as pins P00–P05. Set the correspond-
ing bits of the port P0 direction register to “1” (output mode). And
select each output polarity by bit 3 of PWM mode register 1 (address
020816). Then, set bits 5 to 0 of PWM mode register 2 (address
020916) to “1” (PWM output).
The PWM waveform is output from the PWM output pins by setting
these registers.
Figure 17 shows the 8-bit PWM timing. One cycle (T) is composed
of 256 (28) segments. The 8 kinds of pulses relative to the weight of
each bit (bits 0 to 7), are output inside the circuit during 1 cycle.
Refer to Figure 17 (a). The 8-bit PWM outputs waveform which is
the logical sum (OR) of pulses corresponding to the contents of bits
0 to 7 of the 8-bit PWM register. Several examples are shown in
Figure 17 (b). 256 kinds of output (HIGH area: 0/256 to 255/256) are
selected by changing the contents of the PWM register. A length of
entirely HIGH cannot be output, i.e. 256/256.
8.7.4 Output after Reset
At reset, the output of ports P00–P05 is in the high-impedance state,
and the contents of the PWM register and the PWM circuit are unde-
fined. Note that after reset, the PWM output is undefined until setting
the PWM register.
相關PDF資料
PDF描述
MB90F428GBPFV 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP100
MB90F423GBPFV 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP100
MB90423GBPFV 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100
MB90427GBPFV 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100
MB90F423GBPF 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
MB90F428GAPMC-GSE1 制造商:FUJITSU 功能描述:
MB90F428GCPFR-GSE1 制造商:FUJITSU 功能描述:
MB90F438LSPFR-GE1 制造商:FUJITSU 功能描述:
MB90F438LSPMCR-GE1 制造商:FUJITSU 功能描述:
MB90F439PMCR-GE1 制造商:FUJITSU 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*