- 您現在的位置：買賣IC網 > PDF目錄377999 > MR2900 (Shindengen Electric Manufacturing Company, Ltd.) Provision for Standby mode operation Partial Resonance Power Supply IC Module PDF資料下載
參數資料
| 型號： | MR2900 |
| 廠商： | Shindengen Electric Manufacturing Company, Ltd. |
| 英文描述： | Provision for Standby mode operation Partial Resonance Power Supply IC Module |
| 中文描述： | 撥備待機模式操作局部共振電源IC模塊 |
| 文件頁數： | 18/19頁 |
| 文件大?。?/td> | 226K |
| 代理商： | MR2900 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁
Shindengen Electric MFG.CO.,LTD
- 18 -
5.4 Selection of Constants for Peripheral Components
5.4.1 Values of Constants for MR2900 Peripheral Components (see 4. Standard Circuit on P12)
Component
Constant
C107
This is the power supply voltage rectification condenser.
If this value is small operation at start-up readily becomes intermittent, and if it is too large start-up time
becomes excessive.
A value of between 47
μ
F and 100
μ
F is appropriate.
This condenser determines the resonance frequency. Select the value on the basis of noise and efficiency etc.
A value of between 820pF and 2200pF is appropriate for autosensing power supplies of between 75W and
150W capacity.
C108
C109
This condenser is incorporated to deal with noise at pin 2. A value of approximately 4700pF is appropriate.
Also beneficial in gain phase adjustment, however frequency response deteriorates if the value is too large.
C111
This is the partial resonance adjustment condenser. Adjust so that turn-on occurs at the resonance trough.
Turn-on occurs earlier if this value is small, and later if it is large.
A value of between 10pF and 33pF is appropriate.
R102
This is the current limiting damper resistor for C108. A value up to a few ohms is appropriate.
Select the value on the basis of noise and efficiency etc.
R103
This is the over-current detection resistor. It determines the droop point.
Calculate the resistance value as follows.
[0.60 (over-current threshold voltage) / Droop point collector current at minimum input]
R104
Adjust on the basis of droop characteristics. Set to a value slightly higher than the droop point set with R103.
A value of a few tens of kohms is appropriate.
R105
This resistor compensates for droop due to input voltage. Adjust on the basis of droop characteristics.
A value of approximately 50kohms is appropriate.
R106
This resistor limits current at the Z/C pin. A value of approximately 20kohms is appropriate.
D102
This corresponds to the body diode for the main switching device (ultra high-speed IGBT).
Select a high-speed diode in the 900V, 1A class.
D106
This is a Zener diode to compensate for droop due to input voltage.
Select a diode for a Zener voltage at least equal to that found with the following equation.
Zener voltage
P
C
N
N
150
×
1.3
=
×
(assume an initial compensation voltage of 150V)
R105 and D106 are additional components for autosensing input specifications.
相關PDF資料 |
PDF描述 |
|---|---|
| MR2920 | Provision for Standby mode operation Partial Resonance Power Supply IC Module |
| MR2940 | Provision for Standby mode operation Partial Resonance Power Supply IC Module |
| MS52C181A | 131,072-Word × 8-Bit STATIC RAM +1,048,576-Word × 8-Bit One Time PROM(128k字×8位靜態RAM+1M字×8位 OTPROM) |
| MS52C182A | 65,536-Word × 16-Bit or 131,072-Word × 8-Bit STATIC RAM +524,288-Word × 16-Bit or 1,048,576-Word × 8-Bit One Time PROM(64k字×16位或128k字×8位靜態RAM+512k字×16位或1M字×8位 OTPROM) |
| MS81V06160 | (401,408-word ⅴ 16-bit) FIFO memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR29-0R2011 | 制造商:Alpha 3 Manufacturing 功能描述: |
| MR29-0R2022 | 制造商:Alpha 3 Manufacturing 功能描述: |
| MR29-0R2223 | 制造商:Alpha 3 Manufacturing 功能描述: |
| MR29-0R2227 | 制造商:Alpha 3 Manufacturing 功能描述: |
| MR291.04D | 制造商:IVO 制造商全稱:Baumer IVO GmbH & Co. KG 功能描述:Accessories & Service |
發布緊急采購，3分鐘左右您將得到回復。