參數資料
型號： MT9074
廠商： Mitel Networks Corporation
英文描述： T1/E1/J1 Single Chip Transceiver(T1/E1/J1單片收發器)
中文描述： T1/E1/J1收發單芯片收發器（T1/E1/J1收發單片收發器）
文件頁數： 5/120頁
文件大?。?/td> 362K
代理商： MT9074
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁
Advance Information
MT9074
5
42
23
RxMF
Receive Multiframe Boundary (Output).
An output pulse delimiting the received
multiframe boundary. The next frame output on the data stream (DSTo) is basic
frame zero on the T1 or PCM 30 link. In E1 mode this receive multiframe signal
can be related to either the receive CRC multiframe (page 01H, address 17H, bit 6,
MFSEL=1) or the receive signalling multiframe (MFSEL=0).
43
24
BS/LS
Bus/Line Synchronization Mode Selection (Input)
. If high, C4b and F0b will be
inputs; if low, C4b and F0b will be outputs.
44
32
E1.5o/C1.5o 2.048 MHz in E1 mode or 1.544MHz in T1 mode, Extracted Clock (Output).
If the internal L/U is enabled, this output is the clock extracted from the received
signal and used internally to clock in data received on RTIP and RRING. If the
internal LIU is disabled (digital framer mode), this output is a 1.544MHz clock
(T1) C1.5o or a 2.048 MHz clock C2o which clocks out the transmit digital data
TXA, TXB.
45
33
C4b
4.096 MHz System Clock (Input/Output).
C4b is the clock for the ST-BUS
sections and transmit serial PCM data of the MT9074. In the free-run (S/FR=0) or
line synchronous mode (S/FR=1 and BS/LS=0) this signal is an output, while in
bus synchronous mode (S/FR=1) this signal is an input clock which is phase-
locked to the extracted clock (E1.5o).
46
34
F0b
Frame Pulse (Input/Output).
This is the ST-BUS frame synchronization signal,
which delimits the 32 channel frame of CSTi, CSTo, DSTi, DSTo and the PCM30
link. In the free-run (S/FR=0) or line synchronous mode (S/FR=1 and BS/LS=0)
this signal is an output, while in the line synchrounous mode (S/FR=1 and BS/
LS=0) this signal is an input.
47
35
RxFP
Receive Frame Pulse (Output).
An 8kHz pulse signal, which is low for one
extracted clock period. This signal is synchronized to the receive DS1 or PCM 30
basic frame boundary.
48
36
IC
Internal Connection.
Must be left open for normal operation.
49
37
V
SS
V
DD
VDD
ATx
Negative Power Supply (Input).
Digital ground.
50
38
Positive Power Supply (Input).
Digital supply (+5V
±
5%).
51
39
Transmit Analog Power Supply (Input).
Analog supply for the LIU transmitter
(+5V
±
5% 10%)).
52
53
40
41
TTIP
TRING
Transmit TIP and RING (Outputs).
Differential outputs for the transmit DS1 line
signal - must be transformer coupled (See Figure 5).
54
42
GND
ATx
Tdi
Transmit Analog Ground (Input).
Analog ground for the LIU transmitter.
55
43
IEEE 1149.1 Test Data Input.
If not used, this pin should be pulled high.
56
44
Tdo
IEEE 1149.1 Test Data Output.
If not used, this pin should be left unconnected.
57
45
Tms
IEEE 1149.1 Test Mode Selection (Input).
If not used, this pin should be pulled
high.
58
46
Tclk
IEEE 1149.1 Test Clock Signal (Input).
If not used, this pin should be pulled high.
59
47
Trst
IEEE 1149.1 Reset Signal (Input).
If not used, this pin should be held low.
60
48
TxAO
Transmit All Ones (Input).
High - TTIP, TRING will transmit data normally. Low -
TTIP, TRING will transmit an all ones signal.
Pin Description
Pin #
Name
Description
68 Pin
PLCC
100 Pin
MQFP
相關PDF資料
PDF描述
MT9075B E1 Single Chip Transceiver
MT9075B E1 Single Chip Transceiver(E1單片收發器)
MT9075 E1 Single Chip Transceiver
MT9075A E1 Single Chip Transceiver
MT9075AL E1 Single Chip Transceiver
相關代理商/技術參數
參數描述
MT9074_05 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 Single Chip Transceiver
MT9074AL 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 100MQFP - Trays 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 5V 100MQFP - Trays
MT9074AL1 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 100MQFP - Trays
MT9074AP 制造商:Microsemi Corporation 功能描述:
MT9074AP1 制造商:Microsemi Corporation 功能描述:T1/E1/J1 SGLE CHIP XSCR 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL T1/E1 68PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX SGL T1/E1 68PLCC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*