參數資料
型號: PIC18F45J50-I/PT
廠商: Microchip Technology
文件頁數: 99/164頁
文件大?。?/td> 0K
描述: IC PIC MCU FLASH 32K 2V 44-TQFP
產品培訓模塊: XLP Deep Sleep Mode
PIC18 J Series MCU Overview
8-bit PIC® Microcontroller Portfolio
標準包裝: 160
系列: PIC® XLP™ 18F
核心處理器: PIC
芯體尺寸: 8-位
速度: 48MHz
連通性: I²C,SPI,UART/USART,USB
外圍設備: 欠壓檢測/復位,DMA,POR,PWM,WDT
輸入/輸出數: 34
程序存儲器容量: 32KB(16K x 16)
程序存儲器類型: 閃存
RAM 容量: 3.8K x 8
電壓 - 電源 (Vcc/Vdd): 2.15 V ~ 3.6 V
數據轉換器: A/D 13x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 44-TQFP
包裝: 托盤
產品目錄頁面: 657 (CN2011-ZH PDF)
配用: AC164322-ND - MODULE SOCKET MPLAB PM3 28/44QFN
2011 Microchip Technology Inc.
DS39931D-page 45
PIC18F46J50 FAMILY
3.7
Effects of Power-Managed Modes
on Various Clock Sources
When the PRI_IDLE mode is selected, the designated
primary oscillator continues to run without interruption.
For all other power-managed modes, the oscillator
using the OSC1 pin is disabled. Unless the USB
module is enabled, the OSC1 pin (and OSC2 pin if
used by the oscillator) will stop oscillating.
In
secondary
clock
modes
(SEC_RUN
and
SEC_IDLE), the Timer1 oscillator is operating and
providing the device clock. The Timer1 oscillator may
also run in all power-managed modes if required to
clock Timer1 or Timer3.
In internal oscillator modes (RC_RUN and RC_IDLE),
the internal oscillator block provides the device clock
source. The 31 kHz INTRC output can be used directly
to provide the clock and may be enabled to support
various
special
features
regardless
of
the
power-managed mode (see Section 27.2 “Watchdog
information on WDT, FSCM and Two-Speed Start-up).
The INTOSC output at 8 MHz may be used directly to
clock the device or may be divided down by the post-
scaler. The INTOSC output is disabled if the clock is
provided directly from the INTRC output.
If Sleep mode is selected, all clock sources which are
no longer required are stopped. Since all the transistor
switching currents have been stopped, Sleep mode
achieves the lowest current consumption of the device
(only leakage currents) outside of Deep Sleep.
Sleep mode should not be invoked while the USB
module is enabled and operating in Full-Power mode.
Before Sleep mode is selected, the USB module should
be put in the suspend state. This is accomplished by
setting the SUSPND bit in the UCON register.
Enabling any on-chip feature that will operate during
Sleep mode increases the current consumed during
Sleep mode. The INTRC is required to support WDT
operation. The Timer1 oscillator may be operating to
support a RTC. Other features may be operating that
do not require a device clock source (i.e., MSSP slave,
PMP, INTx pins, etc.). Peripherals that may add
significant
current
consumption
are
listed
in
.
3.8
Power-up Delays
Power-up delays are controlled by two timers so that no
external Reset circuitry is required for most applica-
tions. The delays ensure that the device is kept in
Reset until the device power supply is stable under
normal circumstances and the primary clock is operat-
ing and stable. For additional information on power-up
The first timer is the Power-up Timer (PWRT), which
provides a fixed delay on power-up (Parameter 33,
The second timer is the Oscillator Start-up Timer
(OST), intended to keep the chip in Reset until the
crystal oscillator is stable (HS mode). The OST does
this by counting 1024 oscillator cycles before allowing
the oscillator to clock the device.
There is a delay of interval, TCSD (Parameter 38,
Table 30-14), following POR, while the controller
becomes ready to execute instructions. This delay runs
concurrently with any other delays. This may be the only
delay that occurs when any of the internal oscillator or
EC modes are used as the primary clock source.
相關PDF資料
PDF描述
PIC24FJ64GA004-I/PT IC PIC MCU FLASH 64KB 44TQFP
PIC16C711-20/SO IC MCU OTP 1KX14 A/D 18SOIC
PIC18F44J50-I/ML IC PIC MCU FLASH 16K 2V 44-QFN
PIC18LF26J50-I/SS IC PIC MCU FLASH 64K 2V 28-SSOP
SFW19R-2STE1 SFW19R-2STE1-FFC/FPC CONN
相關代理商/技術參數
參數描述
PIC18F45J50T-I/ML 功能描述:8位微控制器 -MCU Full Spd USB 32KB 4KBRAM nanoWatt RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC18F45J50T-I/PT 功能描述:8位微控制器 -MCU Full Spd USB 32KB 4KBRAM nanoWatt RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC18F45K20-E/ML 功能描述:8位微控制器 -MCU 32KB Flash 1536B RAM 25 I/O 8B RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC18F45K20-E/MV 功能描述:8位微控制器 -MCU 32KB FL 1536b RAM 8b Familynanowatt XLP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
PIC18F45K20-E/P 功能描述:8位微控制器 -MCU 32KB Flash 1536B RAM 25 I/O 8B RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT