- 您現在的位置：買賣IC網 > PDF目錄368307 > PSOC (Cypress Semiconductor Corp.) 8-Bit Programmable System-on-Chip (PSoC⑩) Microcontrollers PDF資料下載
參數資料
| 型號： | PSOC |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | 8-Bit Programmable System-on-Chip (PSoC⑩) Microcontrollers |
| 中文描述： | 8位可編程系統（的PSoC⑩）微控制器片上 |
| 文件頁數： | 113/148頁 |
| 文件大?。?/td> | 1412K |
| 代理商： | PSOC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁當前第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
Special Features of the CPU
September 5, 2002
Document #: 38-12010 CY Rev. ** CMS Rev. 3.20
113
11.3.2
Power On Reset (POR)
Power On Reset (POR) occurs every time the power to
the device is switched on. POR is released when the
supply is typically 2.2V +/-12% for the upward supply
transition, with typically 120mV of hysterisis during the
power on transient. Bit 4 of the Status and Control Regis-
ter (CPU_SCR) is set to record this event (the register
contents are set to 00010000 by the POR). After a POR,
the microprocessor is suspended for 64 ms. This pro-
vides time for the Vcc supply to stabilize after the POR
trip, before CPU operation begins. If the Vcc voltage
drops below the POR downward supply trip point (2.1V
+/-12%, once the internal reference is established), POR
is reasserted.
Important
: The PORS status bit is set at POR and can
only be cleared by the user, and cannot be set by firm-
ware.
11.3.3
Execution Reset
The following diagram illustrates the sequence of events
(in time) for execution reset, from voltage stabilization on
through execution of user’s code. Once voltage trips
POR and after 64 ms, the CPU starts boot calibration.
Boot calibration takes 2,502 cycles, with the CPU run-
ning at 3 MHz. This results in approximately 800
μ
s for
the time between beginning boot calibration and reset
vector. At reset vector, the boot.asm must execute
before user code begins running. (boot.asm contains
device configurations from PSoC Designer. The time it
takes boot.asm to execute varies depending on device
configuration settings such as CPU speed.)
11.3.4 External Reset (X
res
)
Pulling the X
res
pin high for a minimum of 10 μS forces
the microcontroller to perform a Power On Reset (POR).
The X
res
pin does not require a pull-down resistor for
operation and can be tied directly to ground, or left open.
11.3.5 Watchdog Timer Reset (WDR)
The user has the option to enable the WDT. The WDT is
enabled by clearing the PORS bit. Once the PORS bit is
cleared, the Watchdog Timer (WDT) cannot be disabled.
The only exception to this is if a POR event takes place,
which will disable the WDT.
The sleep timer is used to generate the sleep time period
and the watchdog time period. The sleep timer divides
down the
32K
system clock, and thereby produces the
sleep time period. The user can program the sleep time
period to be one of 4 multiples of the period of the
32K
clock. When the sleep time elapses (sleep timer over-
flows), an interrupt to the Sleep Timer Interrupt Vector
will be generated.
Figure 30: Execution Reset
3.0V (Good)
V
cc
Power
3.0 - 5.5
64 ms
2502
~
Boot
Calibration
Start CPU
3 MHz
Reset
Vector
boot.asm
User Code
POR 2.2V ± 12%
T
rVdd
相關PDF資料 |
PDF描述 |
|---|---|
| PSOT03LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PS0T03LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT05LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT08LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT12LC | D-SUB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSOK10001 | 制造商:Value Added 功能描述: |
| PSOODO3A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO3B | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO6A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO6B | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
發布緊急采購，3分鐘左右您將得到回復。