參數資料
型號： RTL8139L
廠商： Electronic Theatre Controls, Inc.
英文描述： REALTEK 3.3V SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
中文描述： 瑞昱3.3V的單芯片快速以太網控制器電源管理
文件頁數： 30/62頁
文件大小： 648K
代理商： RTL8139L
RTL8139C(L)
2002/01/10
Rev.1.4
30
6.29 Config5: Configuration Register 5
(Offset 00D8h, R/W)
This register, unlike other Config registers, is not protected by the 93C46 Command register. Therefore, there is no need to
enable Config register write prior to writing to Config5.
Bit
7
6
R/W
-
R/W
Symbol
-
BWF
Description
Reserved
Broadcast Wakeup Frame:
0: Default value. Disable Broadcast Wakeup Frame with mask bytes
of only DID field = FF FF FF FF FF FF.
1: Enable Broadcast Wakeup Frame with mask bytes of only DID
field = FF FF FF FF FF FF.
The power-on default value of this bit is 0.
Mroadcast Wakeup Frame:
0: Default value. Disable Multicast Wakeup Frame with mask bytes
of only DID field, which is a multicast address.
1: Enable Multicast Wakeup Frame with mask bytes of only DID
field, which is a multicast address.
The power-on default value of this bit is 0.
Unicast Wakeup Frame:
0: Default value. Disable Unicast Wakeup Frame with mask bytes of
only DID field, which is its own physical address.
1: Enable Unicast Wakeup Frame with mask bytes of only DID field,
which is its own physical address.
The power-on default value of this bit is 0.
FIFO Address Pointer:
(Realtek internal use only to test FIFO SRAM)
0: (Power-on) default value. Both Rx and Tx FIFO address pointers
are updated in ascending way from 0 and upwards. The initial FIFO
address pointer is 0.
1: Both Rx and Tx FIFO address pointers are updated in descending
way from 1FFh and downwards. The initial FIFO address pointer is
1FFh.
Note: This bit does not participate in EEPROM auto-load. The FIFO
address pointers can not be reset, except initial power-on.
The power-on default value of this bit is 0.
Link Down Power Saving mode:
When cable is disconnected (Link
Down), the analog part will power down itself (PHY Tx part & part of
twister) automatically. However, the PHY Rx part and part of twister
to monitor SD signal will not, in case the cable is re-connected and
Link should be established again.
1: Disable.
0: Enable.
LANWake signal enable/disable:
1: Enable LANWake signal.
0: Disable LANWake signal.
PME_Status bit:
Always sticky/can be reset by PCI RST# and
software.
1: The PME_Status bit can be reset by PCI reset or by software.
0: The PME_Status bit can only be reset by software.
5
R/W
MWF
4
R/W
UWF
3
R/W
FIFOAddrPtr
2
R/W
LDPS
1
R/W
LANWake
0
R/W
PME_STS
Config5 register, offset D8h: (SYM_ERR register is changed to Config5, the function of SYM_ERR register is no longer
supported by RTL8139C.)
The 3 bits (bit2-0) are auto-loaded from EEPROM Config5 byte to RTL8139C Config5 register.
相關PDF資料
PDF描述
RTL8139 REALTEK 3.3V SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8139A REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8139B REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8139D REALTEK SINGLE CHIP FAST ETHERNET CONTROLLER WITH POWER MANAGEMENT
RTL8201 REALTEK SINGLE CHIP SINGLE PORT 10/100M FAST ETHERNET PHYCEIVER RTL8201BL
相關代理商/技術參數
參數描述
RTL8150 制造商:未知廠家 制造商全稱:未知廠家 功能描述:RTL8150L(M) Specifications
RTL8168 制造商:未知廠家 制造商全稱:未知廠家 功能描述:INTEGRATED GIGABIT ETHERNET CONTROLLER FOR PCI EXPRESS TM
RTL8169 制造商:未知廠家 制造商全稱:未知廠家 功能描述:RTL8169 Specification
RTL8181 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Wireless LAN Access Point/Gateway Controller
RTL8187L 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Wireless LAN network interface controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*