155
ATmega8A [DATASHEET]
8159E–AVR–02/2013
pull-up resistors to pull the line high. Note that all AVR devices connected to the TWI bus must be powered in order
to allow any bus operation.
The number of devices that can be connected to the bus is only limited by the bus capacitance limit of 400 pF and
the 7-bit slave address space. A detailed specification of the electrical characteristics of the TWI is given in
“Two-evant for bus speeds below 100kHz, and one valid for bus speeds up to 400kHz.
21.4
Data Transfer and Frame Format
21.4.1
Transferring Bits
Each data bit transferred on the TWI bus is accompanied by a pulse on the clock line. The level of the data line
must be stable when the clock line is high. The only exception to this rule is for generating start and stop
conditions.
Figure 21-3. Data Validity
21.4.2
START and STOP Conditions
The Master initiates and terminates a data transmission. The transmission is initiated when the Master issues a
START condition on the bus, and it is terminated when the Master issues a STOP condition. Between a START
and a STOP condition, the bus is considered busy, and no other master should try to seize control of the bus. A
special case occurs when a new START condition is issued between a START and STOP condition. This is
referred to as a REPEATED START condition, and is used when the Master wishes to initiate a new transfer with-
out relinquishing control of the bus. After a REPEATED START, the bus is considered busy until the next STOP.
This is identical to the START behavior, and therefore START is used to describe both START and REPEATED
START for the remainder of this datasheet, unless otherwise noted. As depicted below, START and STOP condi-
tions are signalled by changing the level of the SDA line when the SCL line is high.
SDA
SCL
Data Stable
Data Change