參數資料
型號: TPS2345PWNRND
廠商: TEXAS INSTRUMENTS INC
元件分類: 電源管理
英文描述: 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24
封裝: GREEN, TSSOP-24
文件頁數: 3/32頁
文件大?。?/td> 621K
代理商: TPS2345PWNRND
TPS2345
SLUS503B – MARCH 2002 – REVISED AUGUST 2002
11
www.ti.com
detailed description (continued)
The basic functional blocks of the LCA/voltage sense circuits is shown in greater detail in Figure 2. The LCA
has as its inputs the reference voltage generated by the current sources, and the current sense input. During
a supply turn-on, it slews the pass MOSFET gate to force the load current to track the selected source. After
load charging completes, and the current decays to the nominal operating level, the LCA drives the GATEx
output to its input supply level, the charge pump output voltage.
UDG–02004
+
R
LCA
OCA
OV
UV
OV
R
DAC
5
REF_Vx
VSEL
VINx
CSx
VSx
GATEx
OCx
UVOVx
MUX
2:1
VCPUMP
VIMAX
IRAMP
10
VINX
Figure 2. Linear Control Amplifier Block
The supply voltage is monitored by the undervoltage (UV) and overvoltage (OV) comparators. A voltage
multiplexer (MUX) selects from either the input supply voltage (VINx) or the load voltage (VSx), and provides
that signal to the comparator inputs. Once the Channel 1 supply is above the UVLO threshold, and the BD_SEL#
input has been pulled low, but prior to the ramp-up of the first channel, the comparators monitor the input
supplies. Any supply outside its UV/OV window causes all pass MOSFETs to be held off. If all inputs are within
tolerance, a ramp-up sequence can start, at which time the comparator inputs are switched over to the load,
or VSx, voltages. Within the state machine, monitoring of the ORed status of the UV and OV comparators of
any channel is enabled at the turn-on of the next channel, or approximately at the leading edge of the next
IRAMP pulse.
Finally, a fast overcurrent comparator (OCA in the diagram) also monitors the CSx input. This comparator
threshold is set to approximately 2 times the current limit threshold, (2
× IMAX) for the three positive supplies.
In the event of a short-circuit or other fast overcurrent event, the OCA trips, disabling the LCA, and causing
additional gate discharge paths to be turned on for a rapid shutdown of the loads.
A 1-
S to 2-S filter is applied to all overcurrent and voltage faults to guard against nuisance trips. If the duration
of a fault condition on any one channel exceeds the filter length, the fault is latched, the open-drain device at
the HEALTHY# output is turned off, and all four channels are shut down.
相關PDF資料
PDF描述
TPS2346PWG4 4-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO24
TPS2350DRG4 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO14
TPS2350PWG4 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO14
TPS2359RHHT 2-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC36
TPS2363PFBRG4 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48
相關代理商/技術參數
參數描述
TPS2345PWR 制造商:Rochester Electronics LLC 功能描述:COMPACTPCI HOT SWAP POWER MANAGER - Bulk
TPS2346PW 功能描述:IC HOT SWAP POWER MGR 24-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:100 系列:- 類型:熱插拔開關 應用:通用 內部開關:是 電流限制:可調 電源電壓:9 V ~ 13.2 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-TDFN-EP(3x3) 包裝:管件
TPS2346PWR 功能描述:熱插拔功率分布 Optical Network Hot Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
TPS2346PWRG4 功能描述:熱插拔功率分布 Optical Network Hot Swap Controller RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
TPS2350D 功能描述:熱插拔功率分布 Pwr Mngr for Redund -48V Supplies RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube