參數資料
型號: XRT75L00IV
廠商: Exar Corporation
文件頁數: 22/50頁
文件大?。?/td> 0K
描述: IC LIU E3/DS3/STS-1 SGL 52TQFP
標準包裝: 96
類型: 線路接口裝置(LIU)
驅動器/接收器數: 1/1
規程: DS3,E3,STS-1
電源電壓: 3.135 V ~ 3.465 V
安裝類型: 表面貼裝
封裝/外殼: 52-LQFP
供應商設備封裝: 52-TQFP(10x10)
包裝: 托盤
XRT75L00
REV. 1.0.2
E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
27
In order to configure the device for internal transmit driver monitoring, set the TxMON bit to “1” in the transmit
control register.
When the MTIP and MRing are connected to the TTIP and TRing lines, the drive monitor circuit monitors the
line for transitions. The DMO (Drive Monitor Output) will be asserted “Low” as long as the transitions on the line
are detected via MTIP and MRing.
If no transitions on the line are detected for 128 ± 32 TxClk periods, the DMO output toggles “High” and when
the transitions are detected again, DMO toggles “Low”.
NOTE: The Drive Monitor Circuit is only for diagnostic purposes and does not have to be used to operate the transmitter.
4.5
Transmitter Section On/Off:
The transmitter section can be turned on or off. To turn on the transmitter in the Hardware mode, pull TxON pin
“High”. In the Host mode, write a “1” to the TxON control bit AND pull the TxON pin “High” to turn on the
transmitter.
When the transmitter is turned off, the TTIP and TRing are tri-stated.
NOTES:
1.
This feature provides support for Redundancy.
2.
If the XRT75L00 is configured in Host mode, to permit a system designed for redundancy to quickly shut-off the
defective line card and turn on the back-up line card, writing a “1” to the TxON control bit transfers the control to
TxON pin.
FIGURE 16. TRANSMIT DRIVER MONITOR SET-UP.
3.
3k
+
1
%
TT I P
TR i n g
X R T75L00
1: 1
R3
75
Tx PO S
Tx N E G
T x Line C lk
TPD a t a
TN D a t a
Tx C lk
Re x t
Re f A G N D
37. 4
+ 1%
37. 4
+1%
R1
R2
MR i n g
MT I P
R 5 270
R4 2 7 0
3.
3k
+
1
%
Tx PO S
Tx N E G
Tx L in e C lk
TPD a t a
TN D a t a
Tx C l k
Re x t
Re f A G N D
MR i n g
MT I P
TTI P
TR i n g
R3
75
37. 4
+ 1%
37 . 4
+1%
R1
R2
1: 1
相關PDF資料
PDF描述
VI-21W-MX-F4 CONVERTER MOD DC/DC 5.5V 75W
MS27508E8B6PA CONN RCPT 6POS BOX MNT W/PINS
XRT75L00DIVTR-F IC LIU E3/DS3/STS-1 SGL 52TQFP
VE-21X-MX-F2 CONVERTER MOD DC/DC 5.2V 75W
MS3100A22-27S CONN RCPT 9POS WALL MNT W/SCKT
相關代理商/技術參數
參數描述
XRT75L00IV-F 功能描述:外圍驅動器與原件 - PCI Sngl Chip LIU DS3/E3 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT75L00IVTR 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L00IVTR-F 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75L02 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER
XRT75L02DES 功能描述:時鐘合成器/抖動清除器 2CH T3/E3/STS1 LIU+DESYNCH 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel