- 您現在的位置：買賣IC網 > PDF目錄9996 > XRT75L00IV (Exar Corporation)IC LIU E3/DS3/STS-1 SGL 52TQFP PDF資料下載
參數資料
| 型號： | XRT75L00IV |
| 廠商： | Exar Corporation |
| 文件頁數： | 41/50頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU E3/DS3/STS-1 SGL 52TQFP |
| 標準包裝： | 96 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 1/1 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 52-LQFP |
| 供應商設備封裝： | 52-TQFP（10x10） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
XRT75L00
E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
REV. 1.0.2
44
8.0
DIAGNOSTIC FEATURES:
8.1
PRBS Generator and Detector:
The XRT75L00 contains an on-chip Pseudo Random Binary Sequence (PRBS) generator and detector for
diagnostic purpose. This feature is only available in Host mode. With the PRBSEN bit = “1”, the transmitter will
send out PRBS of 223-1 in E3 rate or 215-1 in STS-1/DS3 rate. At the same time, the receiver PRBS detector is
also enabled. When the correct PRBS pattern is detected by the receiver, the RNEG/LCV pin will go “Low” to
indicate PRBS synchronization has been achieved. When the PRBS detector is not in sync the PRBSLS bit will
be set to “1” and RNEG/LCV pin will go “High”.
With the PRBS mode enabled, the user can also insert a single bit error by toggling “INSPRBS” bit. This is
done by writing a “1” to INSPRBS bit. The receiver at RNEG/LCV pin will pulse “High” for half RxClk cycle for
every bit error detected. Any subsequent single bit error insertion must be done by first writing a “0” to
INSPRBS bit and followed by a “1”.
When PRBS mode is enabled, the PRBS counter starts counting each single bit error. The PRBS counter is 16
bits wide. The current value in the counter can be read via two readback operations of the Serial I/O registers.
1) Either the Least Significant Byte (LSB, address 0x30) or the Most Significant Byte (MSB, address 0x31) can
be read first. The value of the un-read register will be copied into the Holding register (address 0x38) and both
the LSB and MSB registers will be reset to zero.
2) Read the Holding register and concatenate the result with the value from the first read operation to get the
full 16 bit counter value.
When the PRBS mode is first enabled, errors will be counted while the receiver logic is synchronizing to the
PRBS pattern. When RNEG/LCV goes “Low” indicating PRBS synchronization, reset the counter by reading
either the LSB or the MSB register.
Figure 25 shows the status of RNEG/LCV pin when the XRT75L00 is configured in PRBS mode.
8.2
LOOPBACKS:
The XRT75L00 offers three loopback modes for diagnostic purposes. In Hardware mode, the loopback modes
are selected via the RLB and LLB pins. In Host mode, the RLB and LLB bits in the control registers select the
loopback modes.
8.2.1
ANALOG LOOPBACK:
In this mode, the transmitter outputs (TTIP and TRING) are connected internally to the receiver inputs (RTIP
and RRING) as shown in Figure 26. Data and clock are output at RCLK, RPOS and RNEG pins for the
corresponding transceiver. Analog loopback exercises most of the functional blocks of the device including the
jitter attenuator which can be selected in either the transmit or receive path.
XRT75L00 can be configured in Analog Loopback either in Hardware mode via the LLB and RLB pins or in
Host mode via LLB and RLB bits in the channel control registers.
FIGURE 25. PRBS MODE
RClk
RNEG/LCV
SYNC LOSS
PRBS SYNC
Single Bit Error
相關PDF資料 |
PDF描述 |
|---|---|
| VI-21W-MX-F4 | CONVERTER MOD DC/DC 5.5V 75W |
| MS27508E8B6PA | CONN RCPT 6POS BOX MNT W/PINS |
| XRT75L00DIVTR-F | IC LIU E3/DS3/STS-1 SGL 52TQFP |
| VE-21X-MX-F2 | CONVERTER MOD DC/DC 5.2V 75W |
| MS3100A22-27S | CONN RCPT 9POS WALL MNT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT75L00IV-F | 功能描述:外圍驅動器與原件 - PCI Sngl Chip LIU DS3/E3 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75L00IVTR | 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L00IVTR-F | 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L02 | 制造商:EXAR 制造商全稱:EXAR 功能描述:TWO CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER |
| XRT75L02DES | 功能描述:時鐘合成器/抖動清除器 2CH T3/E3/STS1 LIU+DESYNCH 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。