參數資料
型號: XRT75R03IV
廠商: EXAR CORP
元件分類: 數字傳輸電路
英文描述: THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
中文描述: DATACOM, PCM TRANSCEIVER, PQFP128
封裝: 14 X 20 MM, LQFP-128
文件頁數: 23/92頁
文件大小: 492K
代理商: XRT75R03IV
xr
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75R03
REV. 1.0.7
20
62
ICT
I
In-Circuit Test Input
:
Setting this pin "Low" causes all digital and analog outputs to go into a high-
impedance state to allow for in-circuit testing. For normal operation, set this pin
"High".
N
OTE
:
This pin is internally pulled “High".
70
HOST/HW
I
HOST/Hardware Mode Select:
Tie this pin “High” to configure the XRT75R03 in HOST mode. Tie this “Low” to
configure in Hardware mode.
When the XRT75R03 is configured in HOST mode, the states of many of the dis-
crete input pins are controlled by internal register bits.
N
OTE
:
This pin is internally pulled up.
CONTROL AND ALARM INTERFACE
P
IN
#
S
IGNAL
N
AME
T
YPE
D
ESCRIPTION
122
RXA
****
External Resistor of 3.01K
± 1%.
Should be connected between RxA and RxB for internal bias.
123
RXB
****
External Resistor of 3.01K
± 1%.
Should be connected between RxA and RxB for internal bias.
JITTER ATTENUATOR INTERFACE
P
IN
#
S
IGNAL
N
AME
T
YPE
D
ESCRIPTION
44
JA0
I
Jitter Attenuator Select 0:
In Hardware Mode, this pin along with pin 42 configures the Jitter Attenuator as
shown in the table below.
N
OTES
:
1.
The setting of these input pins applies globally to all three (3) channels
in the XRT75R03.
This input pin is ignored and should be tied to GND if the XRT75R03 is
configured to operate in the Host Mode.
2.
GENERAL CONTROL PINS
P
IN
#
S
IGNAL
N
AME
T
YPE
D
ESCRIPTION
1
1
Disable Jitter Attenuator
JA0
0
0
Mode
16 bit FIFO Depth
32 bit FIFO Depth
JA1
0
1
1
Disable Jitter Attenuator
0
相關PDF資料
PDF描述
XRT75R06D SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75R06DIB SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
XRT75R06 SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75R06IB SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75R12D TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
相關代理商/技術參數
參數描述
XRT75R03IV-F 功能描述:外圍驅動器與原件 - PCI 3-Ch E3/DS3/STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT75R03IVTR 功能描述:時鐘合成器/抖動清除器 3CHNNEL E3/DS3/STS 1 JITTER ATTENUATOR RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75R03IVTR-F 功能描述:時鐘合成器/抖動清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
XRT75R06 制造商:EXAR 制造商全稱:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75R06D 制造商:EXAR 制造商全稱:EXAR 功能描述:SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER