- 您現在的位置：買賣IC網 > PDF目錄376464 > XRT86VL3X_07 (Exar Corporation) Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 PDF資料下載
參數資料
| 型號： | XRT86VL3X_07 |
| 廠商： | Exar Corporation |
| 元件分類： | 通信及網絡 |
| 英文描述： | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| 中文描述： | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| 文件頁數： | 110/153頁 |
| 文件大?。?/td> | 1316K |
| 代理商： | XRT86VL3X_07 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁當前第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁
XRT86VL3X
103
T1/E1/J1 FRAMER/LIU COMBO - ARCHITECTURE DESCRIPTION
REV. 1.2.2
On the other hand, the payload portion of a framed AIS pattern is all ones. However, a framed AIS pattern still
has correct framing bits. Therefore, the equipment further down the line can still maintain frame
synchronization as well as timing synchronization. In this case, no LOF or Red alarm will be declared.
"AIS16" is an AIS alarm that is supported only in E1 framing format. It is an all ones pattern in time slot 16 of
each E1 frame. As we mentioned before, time slot 16 is usually used for signaling and data link in E1,
therefore, an "AIS16" alarm is transmitted by the intermediate node to indicate that the data link channel is
having a problem. Since all the other thirty one time slots are still transmitting normal data (that is, framing
information and PCM data), the equipment further down the line can still maintain frame synchronization,
timing synchronization as well as receive PCM data. In this case, no LOF or Red alarm will be declared by the
equipment further down the line. However, a CAS Multi-frame Yellow Alarm will be sent by the equipment
further down the line to indicate the loss of CAS Multi-frame alignment.
The Transmit Alarm Indication Signal Select bits of the Alarm Generation Register (AGR) enable the three
types of AIS transmission that are supported by the XRT86VL3x framer. The table below shows configurations
of the Transmit Alarm Indication Signal Select bits of the Alarm Generation Register (AGR).
9.5.2
How to configure the framer to generate Red Alarm
Upon detection of Loss of Signal (LOS) or Loss of Frame (LOF) condition, the Repeater will generate an
internal Red Alarm when enabled. This alarm will normally trigger a microprocessor interrupt informing the user
that an incoming signal failure is happening.
The Loss of Frame Declaration Enable bit of the Alarm Generation Register (AGR) enable the generation of
Red Alarm. The table below shows configurations of the of Frame Declaration Enable bit of the Alarm
Generation Register (AGR).
9.5.3
How to configure the framer to transmit Yellow Alarm
The XRT86VL3x framer supports transmission of both Yellow Alarm and CAS Multi-frame Yellow Alarm in E1
mode.
ALARM GENERATION REGISTER (AGR) (ADDRESS = 0XN108H)
B
IT
N
UMBER
B
IT
N
AME
B
IT
T
YPE
B
IT
D
ESCRIPTION
3-2
Transmit AIS
Select
R/W
These READ/WRITE bit-fields allows the user to choose which one of the
three AIS pattern supported by the XRT86VL3x framer will be transmitted.
00 - No AIS alarm is generated.
01 - Enable unframed AIS alarm of all ones pattern.
11 - AIS16 pattern is generated. Only time slot 16 is carrying the all ones
pattern. The other time slots still carry framing and PCM data.
11 - Enable framed AIS alarm of all ones pattern except for framing bits.
ALARM GENERATION REGISTER (AGR) (ADDRESS = 0XN108H)
B
IT
N
UMBER
B
IT
N
AME
B
IT
T
YPE
B
IT
D
ESCRIPTION
6
Loss of Frame
Declaration Enable
R/W
This READ/WRITE bit-field permits the framer to declare Red Alarm in
case of Loss of Frame Alignment (LOF).
When receiver module of the framer detects Loss of Frame Alignment in
the incoming data stream, it will generate a Red Alarm. The framer will
also generate an RxLOFs interrupt to notify the microprocessor that an
LOF condition is occurred. A Yellow Alarm is then returned to the remote
transmitter to report that the local receiver detects LOF.
0 - Red Alarm declaration is disabled.
1 - Red Alarm declaration is enabled.
相關PDF資料 |
PDF描述 |
|---|---|
| XRT86VL3X | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| XRT91L30_0611 | STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER |
| XRT91L306 | STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER |
| XRT91L30IQ | STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER |
| XRT91L30 | STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT86VX38 | 制造商:EXAR 制造商全稱:EXAR 功能描述:OCTAL T1/E1/J1 FRAMER/LIU COMBO - HARDWARE DESCRIPTION |
| XRT86VX38_09 | 制造商:EXAR 制造商全稱:EXAR 功能描述:8-CHANNEL T1/E1/J1 FRAMER/LIU COMBO - T1 REGISTER DESCRIPTION |
| XRT86VX38_0906 | 制造商:EXAR 制造商全稱:EXAR 功能描述:OCTAL T1/E1/J1 FRAMER/LIU COMBO - HARDWARE DESCRIPTION |
| XRT86VX38IB256 | 制造商:EXAR 制造商全稱:EXAR 功能描述:8-CHANNEL T1/E1/J1 FRAMER/LIU COMBO - E1 REGISTER DESCRIPTION |
| XRT86VX38IB256ES | 功能描述:界面開發工具 Evaluation Board for XRT86VX38 256pin ICs RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
發布緊急采購，3分鐘左右您將得到回復。