參數資料
型號: ZL30410QCC
廠商: ZARLINK SEMICONDUCTOR INC
元件分類: 數字傳輸電路
英文描述: CONN SOCKET R/A 4R0W 24POS SLD
中文描述: ATM/SONET/SDH SUPPORT CIRCUIT, PQFP80
封裝: 14 X 14 MM, 1.40 MM HEIGHT, MS-026BEC, LQFP-80
文件頁數: 15/38頁
文件大?。?/td> 400K
代理商: ZL30410QCC
ZL30410
Data Sheet
15
Zarlink Semiconductor Inc.
FCS pin
:
Filter Characteristic Select
. The FCS (pin 9) input is used to select the filtering characteristics of the
Core PLL. See Table 2 on page 15 for details.
RefSel
:
Reference Source Select
. The RefSel (pin 47) input selects the PRI (primary) or SEC (secondary) input
as the reference clock for the Core PLL. The logic level at this input is sampled by the rising edge of F8o.
RefAlign:
Reference Alignment
. The RefAlign (pin 48) input controls phase realignment between the input
reference and the generated output clocks. See Section 2.2.4 on page 9 for details.
3.2 Status Pins
The ZL30410 has four dedicated status pins for indicating modes of operation and quality of the Primary and
Secondary reference clocks. These pins are listed below:
LOCK
. This output goes high after the ZL30410 has completed its locking sequence (see section 2.2.3 for details).
HOLDOVER
- This output goes high when the Core PLL enters Holdover mode. The Core PLL will switch to
Holdover mode if the respective Acquisition PLL enters Holdover mode or if the mode select pins are set to
Holdover (MS2, MS1 = 01).
PRIOR
- (Primary Reference Out of Range). The PRIOR status is based on two detectors that monitor reference
quality with different precision and response times. Outputs of both detectors are combined together (OR function)
to drive PRIOR status pin.
This output goes high when one of the detectors is triggered by the failing Primary Reference clock:
- Slow Response Detector (High Precision): This detector detects if the primary reference is off its nominal
frequency by more than ±12 ppm. The frequency offset monitor updates internally every 10 sec and will
change state after two matching measurements (PASS/PASS or FAIL/FAIL). This is in full compliance
with the GR-1244-CORE requirement of 10 to 30 sec Reference Validation Time. This output returns to
zero when the reference frequency is requalified within ±9.2 ppm of the nominal frequency (monitor
circuit has built-in hysteresis). In an extreme case, when over time the Master Clock oscillator drifts ±4.6
ppm the switching thresholds will change as well, as is shown in Figure 7.
- Fast Response Detector (Low Precision): This detector detects a large frequency offset (greater than 3%)
or large change in a single cycle period (grater than 30%). In both cases detector will almost
instantaneously (in less than 250μs) disqualify the reference and reset the 10 sec internal timer.
FCS
Filtering Characteristic
Phase Slope
Limit
0
Filter corner frequency set to 12Hz.
This selection meets loop filter characteristics for line card applications
N/A
1
Filter corner frequency set to 6Hz.
This selection meets requirements of G.813 Option 1
41 ns
in 1.326 ms
Table 2 - Filter Characteristic Selection
RefSel
Input Reference
0
Core PLL connected to the Primary Acquisition PLL
1
Core PLL connected to the Secondary Acquisition PLL
Table 3 - Reference Source Select
相關PDF資料
PDF描述
ZL30414 SONET/SDH Clock Multiplier PLL
ZL30414QGC SONET/SDH Clock Multiplier PLL
ZL30414QGC1 SONET/SDH Clock Multiplier PLL
ZL30415 SONET/SDH Clock Multiplier PLL
ZL30415GGC SONET/SDH Clock Multiplier PLL
相關代理商/技術參數
參數描述
ZL30410QCC1 制造商:Microsemi Corporation 功能描述:
ZL30410QCG1 制造商:Microsemi Corporation 功能描述:IC SONET/SDH NETWORK ELEMENT PLL 制造商:Microsemi Corporation 功能描述:LEAD FREE SONET/SDH NETWORK ELEMENT PLL - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC PLL SONET/SDH/PDH 80LQFP 制造商:Microsemi Corporation 功能描述:IC PLL SONET/SDH/PDH 80LQFP
ZL30414 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:SONET/SDH Clock Multiplier PLL
ZL30414QGC 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:SONET/SDH Clock Multiplier PLL
ZL30414QGC1 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:SONET/SDH Clock Multiplier PLL