參數資料
型號： 20-101-0732
廠商： Rabbit Semiconductor
文件頁數： 45/126頁
文件大?。?/td> 0K
描述： INTERFACE SMART SCREEN OP7100
標準包裝： 1
系列： SBC
模塊/板類型： 單板計算機模塊
適用于相關產品： OP7100
其它名稱： 20-101-732
20-101-732-ND
OP7100
Hardware
25
Power Management
The OP7100 was designed to operate from a 12 V to 30 V DC source, and
consumes about 4.5 W with the backlight on, 1.5 W with the backlight off.
To allow for a surge current when the OP7100 is first turned on, the power
supply used must be able to handle at least four times this power (for
example, 800 mA at 24 V).
The OP7100 power supply is converted internally to supply three voltages.
1. A switching regulator outputs VCC (+ 5 V).
2. A linear regulator outputs VEE (approximately –20 V).
3. A high-voltage section supplies 300 V rms to drive the cold-cathode
fluorescent backlight. The backlight can be turned on or off under
software control whereby a high on the gate of Q3 enables Q1 and Q2 to
oscillate, and a low turns off Q3, stopping the oscillation of Q1 and Q2.
Figure 3-2 shows these internal power supplies in a block diagram
Figure 3-2. Block Diagram of OP7100 Internal Power Regulators
The DC input source can also be brought out on pin 9 of header J10, the
DE-9 connector, by installing a 0
resistor at R32. This option allows
power to be supplied to a serial device connected to the OP7100 as long as
the serial device’s RS-232 port can handle the DC input on pin 9.
Be sure to use a power supply with sufficient capacity (for
example, 1.1 A at 24 V) to handle surges when the OP7100
and any devices connected to it are first turned on.
VCC
J10:9
1230 V DC
J11:5
1230 V DC
U28
2575
Sw Reg
U27
2951
Lin Power
U25
7662
Sw Reg
U23
7662
Sw Reg
VEE
VCC
2575
Sw Reg
Backlight
Power
from EPLD
300 V rms, 32.7 kHz,
to CCFL backlight
Q3
相關PDF資料
PDF描述
395-030-527-804 CARD EDGE 30POS DL .100X.200 BLK
395-030-527-802 CARD EDGE 30POS DL .100X.200 BLK
395-030-527-801 CARD EDGE 30POS DL .100X.200 BLK
395-030-527-204 CARD EDGE 30POS DL .100X.200 BLK
395-030-527-202 CARD EDGE 30POS DL .100X.200 BLK
相關代理商/技術參數
參數描述
20-101-0737 制造商:Digi International 功能描述:SMARTBLOCK OEM W/RTC - MOQ: 50 - Bulk 制造商:Digi International Inc 功能描述:SMARTBLOCK OEM W/RTC MOQ: 50 制造商:Rabbit Semiconductor 功能描述:Smartblock OEM w/RTC
20-101-0738 功能描述:單板計算機 SR9150 Eth 512K SRAM RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0739 制造商:Digi International 功能描述:BL1700 16IN/16OUT 512K SRAM 256K FLASH - MOQ: 25 - Boxed Product (Development Kits) 制造商:Digi International Inc 功能描述:ETH CTLR BL1700 16I/O 256K FLASH 制造商:Rabbit Semiconductor 功能描述:BL1700 512K SRAM 16 In/Out 256K Flash
20-101-0743 制造商:Digi International Inc 功能描述:SMARTBLOCK OEM W/RTC (ROHS) 制造商:Digi International 功能描述:SMARTBLOCK OEM W/RTC - MOQ: 50 - Bulk 制造商:Digi International Inc 功能描述:SMARTBLOCK OEM W/RTC MOQ: 50 制造商:Rabbit Semiconductor 功能描述:Smartblock OEM w/RTC
20-101-0749 功能描述:單板計算機 16 I/O 128K SRAM RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*