參數資料
型號: 73S1210F-EB-LITE
廠商: Maxim Integrated Products
文件頁數: 113/126頁
文件大小: 0K
描述: BOARD EVAL 73S1210F LITE DOC/CBL
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 1
系列: *
DS_1210F_001
73S1210F Data Sheet
Rev. 1.4
87
STX Data Register (STXData): 0xFE07
0x00
Table 79: The STXData Register
MSB
LSB
STXDAT.7
STXDAT.6
STXDAT.5 STXDAT.4 STXDAT.3
STXDAT.2
STXDAT.1
STXDAT.0
Bit
Function
STXData.7
Data to be transmitted to smart card. Gets stored in the TX FIFO and then extracted by
the hardware and sent to the selected smart card. When the MPU reads this register,
the byte pointer is changed to effectively “read out” the data. Thus, two reads will
always result in an “empty” FIFO condition. The contents of the FIFO registers are not
cleared, but will be overwritten by writes.
STXData.6
STXData.5
STXData.4
STXData.3
STXData.2
STXData.1
STXData.0
SRX Control/Status Register (SRXCtl): 0xFE08
0x00
This register is used to monitor reception of data from the smart card.
Table 80: The SRXCtl Register
MSB
LSB
BIT9DAT
LASTRX
CRCERR
RXFULL
RXEMTY RXOVRR
PARITYE
Bit
Symbol
Function
SRXCtl.7
BIT9DAT
Bit 9 Data - When in sync mode and with MODE9/8B set, this bit will contain
the data on IO (or SIO) pin that was sampled on the ninth CLK (or SCLK)
rising edge. This is used to read data in synchronous 9-bit formats.
SRXCtl.6
SRXCtl.5
LASTRX
Last RX Byte - User sets this bit during the reception of the last byte. When
byte is received and this bit is set, logic checks CRC to match 0x1D0F (T=1
mode) or LRC to match 00h (T=1 mode), otherwise a CRC or LRC error is
asserted.
SRXCtl.4
CRCERR
(Read only) 1 = CRC (or LRC) error has been detected.
SRXCtl.3
RXFULL
(Read only) RX FIFO is full. Status bit to indicate RX FIFO is full.
SRXCtl.2
RXEMTY
(Read only) RX FIFO is empty. This is only a status bit and does not generate
an RX interrupt.
SRXCtl.1
RXOVRR
RX Overrun - (Read Only) Asserted when a receive-over-run condition has
occurred. An over-run is defined as a byte was received from the smart card
when the RX FIFO was full. Invalid data may be in the receive FIFO.
Firmware should take appropriate action. Cleared when read. Additional
writes to the RX FIFO are discarded when a RXOVRR occurs until the overrun
condition is cleared. Will generate an RXERR interrupt.
SRXCtl.0
PARITYE
Parity Error - (Read only) 1 = The logic detected a parity error on incoming
data from the smart card. Cleared when read. Will generate an RXERR
interrupt.
相關PDF資料
PDF描述
CM453232-4R7JL INDUCTOR 4.7UH 315MA SMD
GBM18DRYF CONN EDGECARD 36POS DIP .156 SLD
A3DDH-3036M IDC CABLE - AKR30H/AE30M/AKR30H
VI-2WT-EY-S CONVERTER MOD DC/DC 6.5V 50W
CM453232-471JL INDUCTOR 470UH 62MA SMD
相關代理商/技術參數
參數描述
73S1210F-EB-LiteMS 功能描述:開發板和工具包 - 8051 73S1210F Eval Brd Lite + Multi Sam RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓:
73S1215F 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:80515 System-on-Chip with USB, ISO 7816 / EMV, PINpad and More
73S1215F-44IM/F 功能描述:8位微控制器 -MCU 80515 SoC w/USB & PINpad RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
73S1215F-44IM/F/P 功能描述:IC SMART CARD READER PROG 44-QFN RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:73S12xx 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C,智能卡,UART/USART,USB 外圍設備:LED,POR,WDT 輸入/輸出數:9 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件
73S1215F-44IMR/F 功能描述:8位微控制器 -MCU 80515 SoC w/USB & PINpad RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT