- 您現在的位置：買賣IC網 > PDF目錄366891 > CR16MCS9VJE8 Microcontroller PDF資料下載
參數資料
| 型號： | CR16MCS9VJE8 |
| 英文描述： | Microcontroller |
| 中文描述： | 微控制器 |
| 文件頁數： | 13/157頁 |
| 文件大?。?/td> | 1256K |
| 代理商： | CR16MCS9VJE8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁
13
www.national.com
6.0
Input/Output Ports
Each device has up to 56 software-configurable I/O pins, or-
ganized into seven ports of up to eight pins per port. The
ports are named Port B, Port C, Port F, Port G, Port H, Port I,
and Port L.
Each pin can be configured to operate as a general-purpose
input or general-purpose output. In addition, many I/O pins
can be configured to operate as a designated input or output
for an on-chip peripheral module such as the USART or the
Multi-Input Wakeup. This is called the pin's “alternate func-
tion.” The alternate functions of all I/O pins are shown in the
pinout diagrams in Table 1.
The I/O pin characteristics are fully programmable. Each pin
can be configured to operate as a TRI-STATE output, push-
pull output, weak pull-up input, or high-impedance input. Dif-
ferent pins within the same port can be individually config-
ured to operate in different modes.
Figure 1 is a diagram showing the functional features of an I/
O port pin. The register bits, multiplexers, and buffers allow
the port pin to be configured into the various operating
modes.The output buffer is a TRI-STATE buffer with weak
pull-up capability. The weak pull-up, if used, prevents the port
pin from going to an undefined state when it operates as an
input.
The input buffer is disabled when it is not needed to prevent
leakage current caused by an input signal’s level between
V
cc
-0.2 and V
ss
+0.2 [Volts]. When enabled, it buffers the in-
put signal and sends the pin's logic level to the appropriate
on-chip module where it is latched. A Schmitt-Trigger mini-
mizes the effects of electrical noise.
The electrical characteristics and drive capabilities of the in-
put and output buffers are described in Section 25.0.
For some pins, a direct low-impedance path is provided be-
tween the pin and an internal analog function. These are the
input pins to the A/D converter and the analog comparators.
6.1
Each port has an associated set of memory-mapped regis-
ters used for controlling the port and for holding the port data.
In general, there are five such registers:
— PxALT: Port alternate function register
— PxDIR: Port direction register
— PxDIN: Port data input register
— PxDOUT: Port data output register
— PxWKPU: Port weak pull-up register
In the descriptions of the ports and port registers, the lower-
case letter “x” represents the port designation, either B, C, F,
G, H, I, or L. For example, “PxDIR register” means any one
of the port direction registers: PBDIR, PCDIR, PFDIR, and so
on.
All of the port registers are byte-wide read/write registers, ex-
cept for the port data input registers, which are read-only reg-
isters. Each register bit controls the function of the
corresponding port pin. For example, PFDIR.2 (bit 2 of the
PFDIR register) controls the operation of port pin PF2.
PORT REGISTERS
Figure 1.
I/O Pin Functional Diagram
PIN
Direction
Data Out
Register
{
Direction
Register
{
Weak pull-up
Register
{
Alternate Data Input
M
M
Weak pull-up
Data Out
Alt Device Data Output
Alt
Alt
Alt Device Direction
Data In Read Strobe
Alt
Data Input
M
Alt
1
Alternate Function
enable
*
相關PDF資料 |
PDF描述 |
|---|---|
| CR16MCS9VJE8Y | Microcontroller |
| CR16MCT5VJE7Y | Microcontroller |
| CR16HCS5VJE8 | Microcontroller |
| CR16HCS9VJE7Y | Microcontroller |
| CR16HCS9VJE8Y | Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CR16MCS9VJE8/NOPB | 功能描述:16位微控制器 - MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| CR16MCS9VJE80 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16MCS9VJE81 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16MCS9VJE82 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
| CR16MCS9VJE83 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。