參數資料
型號： CR16MCS9VJE8
英文描述： Microcontroller
中文描述： 微控制器
文件頁數： 45/157頁
文件大小： 1256K
代理商： CR16MCS9VJE8
45
www.national.com
14.0
Real-Time Timer and WATCHDOG
The Timing and WATCHDOG Module (TWM) generates the
clocks and interrupts used for timing periodic functions in the
system, and also provides Watchdog protection against soft-
ware errors. The module operates off the slow clock either
generated by the external 32kHz oscillator or from the pres-
caled high speed system clock. The maximum operating
clock frequency is 100kHz.
The WATCHDOG is designed to detect program execution
errors. Once WATCHDOG operation is initiated, the software
must periodically write a specific value to a WATCHDOG reg-
ister. If the software fails to do so, a WATCHDOG error is trig-
gered, which resets the device.
The TWM is flexible in allowing selection of a variety of clock
ratios and clock sources for the WATCHDOG circuit. Once
the software configures the TWM, it can lock the configura-
tion for a higher level of protection against erroneous soft-
ware action. Once locked, the TWM can be released only by
a device reset.
14.1
Figure 10 is a block diagram showing the internal structure of
the Timing and WATCHDOG module. There are two main
sections: the Real-Time Timer (T0) section at the top and the
WATCHDOG section on the bottom.
TWM STRUCTURE
All counting activities of the module are based on the slow
clock (SLCLK). A prescaler counter divides this clock to
make a slower clock. The prescaler factor is defined by a 3-
bit field in the Timer and WATCHDOG Prescaler register,
which selects either 1, 2, 4, 8, 16, or 32 and the divide-by fac-
tor. Thus, the prescaled clock period can be set to 1, 2, 4, 8,
16, or 32 times the slow clock period. The prescaled clock
signal is called T0IN.
14.2
Timer T0 is a programmable 16-bit down counter that can be
used as the time base for real-time operations such as a pe-
riodic audible tick. It can also be used to drive the WATCH-
DOG circuit.
The timer starts counting from the value loaded into the
TWMT0 register and counts down on each rising edge of
T0IN. When the timer reaches zero, it is automatically reload-
ed from the TWMT0 register and continues counting down
from that value. Thus, the frequency of the timer is:
fSLCLK / [(TWMT0+1) * prescaler]
When an external crystal oscillator is used as the SLCLK
source or when the fast clock is divided accordingly, fSLCLK
is 32.768 kHz.
The value stored in TWMT0 can range from 0001 hex to
FFFF hex.
TIMER T0 OPERATION
Figure 10.
Timing and WATCHDOG Module Block Diagram
(TWCP)
16-bit Timer (Timer0)
5-bit pre-scaler counter
WATCHDOG Timer
Peripheral Bus
CLKIN1
T0OUT
(to Multi-Input-
Wake-Up)
WATCHDOG ERROR
TWMT0 register
WDCNT
WDSDM
WATCHDOG
Service
Logic
Restart
Underflow
T0CSR Contrl. Reg.
Restart
Underflow
T0LINT
(to ICU)
WDERR
slow clock from
dual clock and
reset module
REAL TIME TIMER (T0)
WATCHDOG
T0IN
相關PDF資料
PDF描述
CR16MCS9VJE8Y Microcontroller
CR16MCT5VJE7Y Microcontroller
CR16HCS5VJE8 Microcontroller
CR16HCS9VJE7Y Microcontroller
CR16HCS9VJE8Y Microcontroller
相關代理商/技術參數
參數描述
CR16MCS9VJE8/NOPB 功能描述:16位微控制器 - MCU RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
CR16MCS9VJE80 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers
CR16MCS9VJE81 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers
CR16MCS9VJE82 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers
CR16MCS9VJE83 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Family of 16-bit CAN-enabled CompactRISC Microcontrollers
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*