- 您現在的位置：買賣IC網 > PDF目錄10955 > CS4207-CNZ (Cirrus Logic Inc)IC CODEC AUD HDPN AMP COMM 48QFN PDF資料下載
參數資料
| 型號： | CS4207-CNZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 26/77頁 |
| 文件大小： | 0K |
| 描述： | IC CODEC AUD HDPN AMP COMM 48QFN |
| 標準包裝： | 429 |
| 類型： | 音頻編解碼器 |
| 數據接口： | 串行 |
| 分辨率（位）： | 24 b |
| ADC / DAC 數量： | 2 / 3 |
| 三角積分調變： | 是 |
| 動態范圍，標準 ADC / DAC (db)： | 105 / 110 |
| 電壓 - 電源，模擬： | 2.97 V ~ 5.25 V |
| 電壓 - 電源，數字： | 2.97 V ~ 5.25 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-QFN |
| 供應商設備封裝： | 48-QFN-EP（6x6） |
| 包裝： | 托盤 |
| 其它名稱： | 598-1796 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁
32
DS880F4
CS4207
If the codec has detected that the link is entering a Link Reset state (see description below), all Unsolicited
Response requests will be buffered. Once the link is in the Link Reset state, with RESET# asserted low,
the codec will request a power state change and initialization request. Following the codec initialization
cycle where a unique address is provided to the CS4207, the codec will then wait for the first verb to be
received before issuing the Unsolicited Response to prevent the response from being lost due to software
transition to active power state.
The Link Reset entry sequence is defined as follows:
1.
The HD Audio Bus controller synchronously completes the current frame but does not signal Frame
Sync (SYNC) during the last eight SDO bit times.
2.
The HD Audio Bus controller synchronously asserts RESET# four (or more) BITCLK cycles after the
completion of the current frame.
3.
BITCLK is stopped a minimum of four clocks, four rising edges, after the assertion of RESET#.
In the event of a system bus (PCI Bus) reset, the above sequence does not complete, and RESET# is
asynchronously asserted immediately and unconditionally.
When the codec returns to D0 from the D3 lower power state, the state of the presence detection bits will
be correct. If the codec power has been removed, the state of the presence detection bits will be reset to
the default value and the codec
WILL NOT report this by setting the PS-SettingsReset bit for the affected
Pin Widget(s). (HDA015-B, March 1, 2007 says that the PS-SettingsReset bit will be set for the affected
Pin widget).
5.1.2
S/PDIF Receiver Presence Detect
The presence detect scheme for the S/PDIF Receiver will use the logic state transition of the “LOCK” or
“UNLOCK” indicator for the incoming digital stream. The “LOCK” and “UNLOCK” indicators are sticky bits
(edge-triggered) which indicate the current state of the receiver. These bits are located in the Vendor Pro-
cessing Widget, see “S/PDIF RX/TX Interface Status (CIR = 0000h)” on p 129. When the S/PDIF Receiver
Input Converter Widget is “enabled” and the “LOCK” indicator is a “1”, then the Presence Detect bit in the
Pin Sense register will be set to ‘1’. The S/PDIF IN Converter Widget (NID=07h) and the S/PDIF Receiver
pin widget (NID=0Fh) must be in the D0 state to support presence detect using this method described.
With an incoming valid S/PDIF signal applied to the SPDIF_IN pin, the “LOCK” status will be valid approx-
imately 200 S/PDIF frames following the receiver being enabled.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B40-IW-B1 | CONVERTER MOD DC/DC 5V 100W |
| VE-B1X-IW-B1 | CONVERTER MOD DC/DC 5.2V 100W |
| VE-B10-IX-B1 | CONVERTER MOD DC/DC 5V 75W |
| VE-B10-IW-B1 | CONVERTER MOD DC/DC 5V 100W |
| VE-B0J-IX-B1 | CONVERTER MOD DC/DC 36V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS4207-CNZ/C1 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power, 4-in / 6-out HD Audio CODEC with Headphone Amp |
| CS4207-CNZR | 功能描述:接口—CODEC IC Lo Pwr,4/6 HD Aud Codec w/HP Amp RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| CS4207-CNZR/C1 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power, 4-in / 6-out HD Audio CODEC with Headphone Amp |
| CS4207-DNZ | 功能描述:接口—CODEC IC Lo Pwr,4/6 HD Aud Codec w/HP Amp RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| CS4207-DNZR | 功能描述:接口—CODEC IC Lo Pwr,4/6 HD Aud Codec w/HP Amp RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。
