<small id="oekpx"><tfoot id="oekpx"></tfoot></small>
  • <source id="oekpx"></source>
    <thead id="oekpx"></thead>
    參數資料
    型號: DS2196LN+
    廠商: Maxim Integrated Products
    文件頁數: 114/157頁
    文件大?。?/td> 0K
    描述: IC FRAMER DUAL T1 LIU 100-LQFP
    產品培訓模塊: Lead (SnPb) Finish for COTS
    Obsolescence Mitigation Program
    標準包裝: 90
    控制器類型: T1 調幀器
    接口: 并行/串行
    電源電壓: 3.135 V ~ 3.465 V
    電流 - 電源: 85mA
    工作溫度: -40°C ~ 85°C
    安裝類型: 表面貼裝
    封裝/外殼: 100-LQFP
    供應商設備封裝: 100-LQFP(14x14)
    包裝: 托盤
    DS2196
    6 of 157
    1. INTRODUCTION
    The DS2196 is a derivative of the DS21352 T1 SCT. The feature set has been optimized for transport
    applications commonly found in T1 transmission equipment. The DS2196 register map and register bit
    definitions are compatible with the DS21352/DS21552, allowing for easy migration to the DS2196.
    Interface designs requiring per-channel code insertion, elastic stores, and ANSI 1’s density monitoring
    should use the DS21352 or DS21552.
    1.1 Feature Highlights
    § Main features
    – Two full-featured independent framers
    – Short/long haul LIU
    – 100-pin LQFP small package
    – 3.3V operation with 5V tolerant I/O
    § 8-bit parallel control port
    – Multiplexed or nonmultiplexed buses
    – Intel or Motorola formats
    – Polled or interrupt environments
    § HDLC Support
    – Two independent HDLC controllers
    – 64-byte Rx and Tx buffers
    – Access FDL or single/multiple DS0
    channels
    § ANSI T1.403-1998 support
    – NPRMs
    – SPRMs
    – RAI-CI detection and generation
    – AIS-CI detection and generation
    § Format Conversion
    – D4 to ESF framing
    – ESF to D4 framing
    § LIU
    – Long and short-haul support
    – Receive sensitivity: 0dB to -36dB
    – 32-bit or 128-bit crystal-less jitter
    attenuator
    – DSX-1 and CSU line buildout options
    – Provisions for custom waveform
    generation
    § DS1 Idle Code Generation
    – User-defined
    – Fixed 7F Hex
    – Digital milliwatt
    § In-band repeating pattern generator and
    detector
    – Programmable pattern generator
    – Three programmable pattern detectors
    – Patterns from 1 to 8 bits or 16 bits in
    length
    § Programmable on-chip bit error-rate testing
    – Pseudorandom patterns including QRSS
    – User-defined repetitive patterns
    – Daly pattern
    – Error insertion
    – Bit and error counts
    § Payload Error Insertion
    – Error insertion in the payload portion of
    the T1 frame in the transmit path
    – Errors can be inserted over the entire
    frame or selected channels
    – Insertion options include continuous and
    absolute number with selectable insertion
    rates
    § Function Isolation
    – All key signals are routed to pins
    – LIU, Framer A, and Framer B can be
    disconnected from each other
    § Supports both NRZ and bipolar interfaces
    § F-bit corruption for line testing
    § Programmable output clocks for Fractional
    T1
    § Fully independent transmit and receive
    functionality in each framer
    § Large path and line error counters including
    BPV, CV, CRC6, and framing bit errors
    § Ability to calculate and check CRC6
    according to the Japanese standard
    § Ability to generate Yellow Alarm according
    to the Japanese standard
    § Per channel loopback
    § RCL, RLOS, RRA, and RAIS alarms
    interrupt on change of state
    § Hardware pins to indicate receive loss-of-
    sync and receive bipolar violations
    § IEEE 1149.1 JTAG Boundary Scan
    相關PDF資料
    PDF描述
    DS21FF42 IC FRAMER T1 4X4 16CH 300-BGA
    DS21FF44 IC FRAMER E1 4X4 16CH 300-BGA
    DS21FT44N+ IC FRAMER 4X4 16CH 300-BGA
    DS21Q352B IC TXRX QUAD T1/E1 3.3V 256-BGA
    DS21Q41BT IC FRAMER T1 QUAD 128-TQFP
    相關代理商/技術參數
    參數描述
    DS2196LN+ 功能描述:網絡控制器與處理器 IC T1 Dual Framer LIU RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
    DS219T 功能描述:烙鐵 DESOLDERING HEAD RoHS:否 制造商:Weller 產品:Soldering Stations 類型:Digital, Iron, Stand, Cleaner 瓦特:50 W 最大溫度:+ 850 F 電纜類型:US Cord Included
    DS21E352 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
    DS21E352N 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
    DS21E354 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray