- 您現在的位置：買賣IC網 > PDF目錄1994 > DS3106LN+ (Maxim Integrated Products)IC TIMING LINE CARD 64-LQFP PDF資料下載
參數資料
| 型號： | DS3106LN+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 31/92頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TIMING LINE CARD 64-LQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 160 |
| 類型： | 定時卡 IC，多路復用器 |
| PLL： | 是 |
| 主要目的： | 以太網，SONET/SDH，Stratum，電信 |
| 輸入： | CMOS，TTL |
| 輸出： | CMOS，LVDS，LVPECL，TTL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:2 |
| 差分 - 輸入:輸出： | 無/是 |
| 頻率 - 最大： | 312.5MHz |
| 電源電壓： | 1.62 V ~ 1.98 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-LQFP |
| 供應商設備封裝： | 64-LQFP（10x10） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1429 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
DS3106
37
7.10 Reset Logic
The device has three reset controls: the
RST pin, the RST bit in MCR1, and the JTAG reset pin JTRST. The RST
pin asynchronously resets the entire device, except for the JTAG logic. When the
RST pin is low all internal
registers are reset to their default values, including those fields that latch their default values from, or based on, the
states of configuration input pins when the
RST goes high. The RST pin must be asserted once after power-up
while the external oscillator is stabilizing.
The MCR1:RST bit resets the entire device (except for the microprocessor interface, the JTAG logic, and the RST
bit itself), but when RST is active, the register fields with pin-programmed defaults do not latch their values from, or
based on, the corresponding input pins. Instead, these fields are reset to the default values that were latched when
the
RST pin was last active.
Microsemi recommends holding
RST low while the external oscillator starts up and stabilizes. An incorrect reset
condition could result if
RST is released before the oscillator has started up completely.
Important: System software must wait at least 100s after reset (
RST pin or RST bit) is deasserted before
initializing the device as described in Section 7.12.
7.11 Power-Supply Considerations
Due to the DS3106’s dual-power-supply nature, some I/Os have parasitic diodes between a 1.8V supply and a
3.3V supply. When ramping power supplies up or down, care must be taken to avoid forward-biasing these diodes
because it could cause latchup. Two methods are available to prevent this. The first method is to place a Schottky
diode external to the device between the 1.8V supply and the 3.3V supply to force the 3.3V supply to be within one
parasitic diode drop below the 1.8V supply (i.e., VDDIO > VDD - ~0.4V). The second method is to ramp up the 3.3V
supply first and then ramp up the 1.8V supply.
7.12 Initialization
After power-up or reset, a series of writes must be done to the DS3106 to tune it for optimal performance. This
series of writes is called the initialization script. Each DS3106 die revision has a different initialization script. For the
latest initialization scripts contact Microsemi timing products technical support.
Important: System software must wait at least 100s after reset (
RST pin or RST bit) is deasserted before
initializing the device.
相關PDF資料 |
PDF描述 |
|---|---|
| DS3231MZ+ | IC RTC I2C 8SOIC |
| DS3231SN#T&R | IC RTC W/TCXO 16-SOIC |
| DS3232MZ+ | IC RTC W/SRAM I2C 8SOIC |
| DS3232SN#T&R | IC RTC W/TCXO 20-SOIC |
| DS3234S# | IC RTC W/TCXO 20-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS3106LN+ | 功能描述:計時器和支持產品 Line Card Timing IC RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| DS3107FP000 | 制造商:Thomas & Betts 功能描述:30A,CON,2P3W,MG,107,125V |
| DS3107FRAB0 | 制造商:Thomas & Betts 功能描述:30A,REC,2P3W,MG,107,AB0,125,SC |
| DS3107MP000 | 制造商:Thomas & Betts 功能描述:30A,PLG,2P3W,MG,107,125V |
| DS3107MP00K | 制造商:Thomas & Betts 功能描述:30A,PLG,2P3W,MG,107,125V,CC |
發布緊急采購，3分鐘左右您將得到回復。